9110-G43 NYLENE | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 1
Technical content
NYLENE USA NYLENE CANADA ULC. ISO/IEC 17025 & ISO 9001:2015 Accredited Facilities en 1421 Hwy 136 West 200 McNab Street Product is manufactured in Wayne, NJ ne) Nylene Henderson, Kentucky 42420 Arnprior, Ontario K7S 3P2 Web: www.nylene.com | Email: info@nylene.com Phone: 270-826-7641 Phone: 613-623-3191 TDS Ref ID: 1405 Toll-free: 800-626-7050 Toll-free: 800-267-7394 Date Updated May 27, 2024 Nylene® 9110 G43 Technical Data Sheet Resin Type: * Nylon 6/6 tesin Type: ylon 6 Processing Method{(s): Description: * 43% glass fiber reinforced nylon 6/10 injection molding grade. * Injection Molding * Has the high strength and stiffness of reinforced nylon, while also having the reduced moisture pick- up associated with nylon 6/10. | Fillers/Reinforcements: * Suitable for applications where moisture pickup may be a concern. * 43% Glass Filled Properties ASTM/ISO Unit English si Procedure Form(s)/Color(s): * Pellets Physical Specific Gravity 0792 n/a 1.42 1 Features: Mechanical * High stiffness Tensile Strength D638 psi (MPa) 24000 165 * High strength * Reduced moisture pick-up Flexural Modulus D790 psi (MPa) 1500000 10,345 Elongation D638 % 20 End Uses: Notched Izod @ 23°C D256 ft-lbjin (u/m) 3 160 * General End Uses Thermal = Fasteners a * Inlet Housings DTUL @ 264 psi/1.82 MPa D648 F (°C) 398 203 * Pump Housings Melt Point D3418 °F (°C) 430 221 Disclaimer Nylene does not guarantee the accuracy of Notes: Testing conducted on dry-as-molded specimens at 73°F (22.8°C} this information or the suitability of this product for any given application or usage situation. These values are based on test Recommended Processing Considerations: PA6/6 Injection Molding - Glass Reinforced >15% specimens and should not be used to | _ establish specification limits or fabricate Pressure psi eee toting Injection 5-15,000 Hold 4-12,000 Back 0-50 Melt Temperature: Nylene PA6/6 melts at 490 °F (254°C), actual melt temperatures of 540-600 (282-316°C) are permissible, depending on residence time and shot size. Mold Temperature: 120-200 °F (49-93°C), highly filled grades require 180-200 °F (82-93°C) to obtain the best overall surface appearance, higher temperatures will increase crystallinity. Residence Time: should not exceed 6 minutes if possible, less with higher melt temperatures. Shot Size: should be between 25-75% of barrel capacity. Fill Rate: fast fill rates are suggested for best surface appearance. Regrind Level: typically no more than 25% is recommended, with higher levels possible for unfilled grades depending on the end use requirements. Make certain regrind is properly dried to virgin moisture levels. Drying Temperature: 150-180 °F (65-182°C) (for 2-4 hours, Nylene PAG/6 should be dried to less than 0.20% moisture for optimum performance. Drying longer than 4 hours or at higher temperatures may cause oxidation of the polymer or remove essential volatiles.