P6M053R3S HY-LINE | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 3

Technical content

6W DC-DC Converter P6M-Series

  • Wide 2:1 input range
  • Flat case profile 7 mm
  • Continuous short circuit protection
  • Over Voltage protection
  • Soft start function
  • No internal tantalum capacitors
  • Efficiency up to 88 % Model selection guide Input current Output current Type Input voltage range [VDC] no load [mA] full load [mA] Output voltage [VDC] min. [mA] max. [mA] Efficiency typ. [%] Capacitance load max. (see note 3) [µF] Single output P6M053R3S 4.5…9 45 905 3.3 0 1000 73 1000 P6M0505S 4.5…9 45 1315 5.0 0 1000 76 1000 P6M0512S 4.5…9 45 1520 12.0 0 500 79 680 P6M0515S 4.5…9 45 1520 15.0 0 400 79 680 P6M123R3S 9...18 25 360 3.3 0 1000 76 1000 P6M1205S 9...18 25 620 5.0 0 1200 81 1200 P6M1212S 9...18 25 590 12.0 0 500 85 680 P6M1215S 9...18 25 590 15.0 0 400 85 470 P6M243R3S 18...36 25 225 3.3 0 1200 73 1200 P6M2405S 18...36 25 310 5.0 0 1200 80 1200 P6M2412S 18...36 25 300 12.0 0 500 84 680 P6M2415S 18...36 25 290 15.0 0 400 86 470 P6M483R3S 36...75 25 110 3.3 0 1200 74 1200 P6M4805S 36...75 25 155 5.0 0 1200 80 1200 P6M4812S 36...75 25 150 12.0 0 500 84 680 P6M4815S 36...75 25 145 15.0 0 400 85 470 Dual output P6M0512D 4.5…9 50 1500 ±12.0 0 ±250 82 2 x 220 P6M0515D 4.5…9 50 1500 ±15.0 0 ±200 82 2 x 220 P6M1212D 9...18 15 580 ±12.0 0 ±250 88 2 x 220 P6M1215D 9...18 15 580 ±15.0 0 ±200 88 2 x 220 P6M2412D 18...36 10 290 ±12.0 0 ±250 88 2 x 220 P6M2415D 18...36 10 290 ±15.0 0 ±200 88 2 x 220 P6M4812D 36...75 6 145 ±12.0 0 ±250 87 2 x 220 P6M4815D 36...75 6 145 ±15.0 0 ±200 88 2 x 220 Page 1 of 2 Deutschland: Schweiz: Inselkammerstraße 10 Gründenstrasse 82 D-82008 Unterhaching CH-8247 Flurlingen Tel.: 089 614 503-10 Tel.: 052 647 42 00 E-Mail: power@hy-line.de E-Mail: power@hy-line.ch

6W DC-DC Converter P6M-Series Page 2 of 3 Deutschland: Schweiz: Inselkammerstraße 10 Gründenstrasse 82 D-82008 Unterhaching CH-8247 Flurlingen Tel.: 089 614 503-10 Tel.: 052 647 42 00 E-Mail: power@hy-line.de E-Mail: power@hy-line.ch

6W DC-DC Converter P6M-Series Specifications Input Filter Pi network Start up time @ min. Vin and constant resistive load 20 ms, max. Reflected ripple current 20 mAp-p (see note 5) Output Voltage accuracy ± 1 % Voltage balance (dual outputs) ± 1 % Ripple and noise (at 20 MHz BW) 75 mVp-p, max. (see note 2) Short circuit protection Continuous Short circuit restart Automatic Overcurrent protection 185 % typ, of full load Line regulation ± 0.5 %, max. Load regulation (@ 0...100 % load) ± 1 %, max. @ balanced load Cross regulation (dual output) ± 5 %, max. (see note 1) Temperature coefficient ± 0.02 % / °C Transient response deviation ± 3 %, max. (see note 4) Over voltage protection 3.3 V output type 3.9 V, z-diode clamp voltage 5 V output type 6.2 V, z-diode clamp voltage

12 V output type 15 V, z-diode clamp voltage

15 V output type 18 V, z-diode clamp voltage

± 12 V output type ± 15 V, z-diode clamp voltage ± 15 V output type ± 18 V, z-diode clamp voltage Physical Dimensions 44.5 x 28 x 7 mm Weight 25 g, max. Note: 1. One load is 25 % to 100 % load, the other load is 100 % load, the output voltage variable rate is within ±5 %. 2. Typical value at nominal input voltage and full load,measured by 20 MHz oscilloscope. 3. Test by nominal input voltage and constant resistive load. 4. Tested by normal Vin and 50 % load step change ( 100 % … 50 % of full output current, 50 % … 0 % of full output current ). 5. Measured Input reflected ripple current with a simulated source inductance of 12 µH. 6. Exceeding the absolute ratings of the unit could cause damage. It is not allowed for continuous operating. Dimensions Pin connections Page 3 of 3 Isolation Rated voltage input to output, input or output to case

500 VAC

Ω min. @ 500 V Capacitance input / output 1 nF, max. General Safety standard (designet to meet) IEC / EN60950-1 Reliability calculated MTBF (Mil –HDBK-217 F) > 1.28 Mio. hours Switching frequency 330 kHz Environmental Operating temperatur (ambient) -40 °C to +85 °C Case temperature 100 °C max. Storage temperature -40 °C to +125 °C Derating None required Humidity Up to 95%, non condensing Cooling Free-air convection Absolute maximum ratings Input voltage, 100 ms, max. 5 V input types -0.7…15 V DC 12 V input types -0.7…36 V DC 24 V input types -0.7…50 V DC 48 V input types -0.7…100 V DC Soldering temperature 1.5 mm distance from case 260 °C, 10 s max. Pin Single Dual 1 -V Input -V Input 2 +V Input +V Input 3 +V Output +V Output

4 Omitted Common

PHI-CON is a trademark of HY-LINE power components. Only for professional use by professionals! Not for resale or distribution to the general public in any way! Read the instructi ons carefully before using! Life Support Policy : HY-LINE does not authorize the use of any of its produc ts for use in life support devices or systems without the express written approval of an officer of the Company. Li fe support systems are devices which support or sustain life, and whose failure to perform, when properly used in accordance with instructions for use provided in the labeling, can be reasonabl y expected to result in significant injury to the user. Rev: 01.14 f Notes : All dimensions are typical in millimeters. 1. Pin diameter: 1.0 ±0.05 2. Pin pitch tolerance: ±0.35 3. Case Tolerance: ±0.5 4. The converter metal case is in contact with the cleaning stand of on the PCB. To keep isolation, an adequate PCB layout on the mounted side is required. Deutschland: Schweiz: Inselkammerstraße 10 Gründenstrasse 82 D-82008 Unterhaching CH-8247 Flurlingen Tel.: 089 614 503-10 Tel.: 052 647 42 00 E-Mail: power@hy-line.de E-Mail: power@hy-line.ch