GAU205P-15252 ISAHAYA | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 6

Technical content

http://www.idc-com.co.jp RECOMMENDED IGBT MODULES MITSUBISHI NF series IGBT modules (f : ~ 20kHz) VCES = 600V series ~ 600A class VCES = 1200V series ~ 400A class GAU205P-15252 Universal Gate Drive Prototype Board Size : 65 x 95 x 34t Gate Driver : VLA542-01R DC-DC Converter : VLA106-15242 FEATURE >Built in the isolated DC-DC converter for gate drive >Output peak current is +/-5A(max) >Built in short circuit protection >Electrical isolation voltage is 2500Vrms (for 1 minute) >Two way power supply system for drivers and input signal (VD=15V , VIN=5V) >CMOS compatible input interface

http://www.idc-com.co.jp CONTROL CIRCUIT CONSTANT VOLTAGE CIRCUIT Amp VIN IN2 VD GND IN1 DETECT LATCH SHUT DOWN F.O. TIMER CONTROL CIRCUIT CONSTANT VOLTAGE CIRCUIT SHUT DOWN F.O. FO 180 ohm 180 ohm DETECT LATCH TIMER Vz = 8.2V Vz = 8.2V BLOCK DIAGRAM Amp

http://www.idc-com.co.jp mA85Gate average current (Per one circuit)Gate drive currentIdrive deg-25 ~ 85No condensation allowableStorage temperatureTstg deg-10 ~ 70No condensation allowableOperating temperatureTopr Vrms2500Sine wave voltage 60Hz, for 1minIsolation voltageViso A5IOLP A-5 Pulse width 2usOutput peak current IOHP V-1 ~ +7Applied between VIN – IN1,2 50% Duty cycle , pulse width 1msInput signal voltageVI V18DCSupply voltageVD UnitRatingsConditionsParameterSymbol V--15-SC detect voltageVSC us1.31-IIH = 16mA“H-L” propagation timetPHL -6.5 16.5 5.25 0.5 -8.0 MaxTyp us-IIH = 16mA“L-H” propagation timetPLH V-9.6-Minus bias voltageVOL V13.5-Plus bias voltageVOH ohm2Recommended rangeGate resistanceRG kHz-Recommended rangeSwitching frequencyf mA15.2Recommended range“H” input signal currentIIH V4.75Recommended rangePull-up voltage on input sideVIN V12Recommended rangeSupply voltageVD Min Unit Limits ConditionsParameterSymbol MAXIMUM RATINGS

ELECTRICAL CHARACTERISTICS

(unless otherwise noted, Ta=25C) ( unless otherwise noted, Ta=25C, VD=15V)

http://www.idc-com.co.jp HIC1,3 VLA542-01R ISAHAYA HIC2,4 VLA106-15242 ISAHAYA PC1,2 TLP781 compatible TOSHIBA DZ1,2,3,4 Vz=18V,500mW DZ5,6 Vz=30V,500mW D1,2 RP1H SanKen RG Gate Resistor R1,2 4.7k ohm,250mW CN1,2,3 B2B-XH-A JST CN4 B7B-XH-A JST C1~6 100uF,50V Low impedance *1) Gate Resistor is not installed at the time of shipment. Please solder the chosen resistor. *2) C7,8 is not installed at the time of shipment. Please solder the chosen condenser if needed. (50V,ceramic) 9 3 CN1 E1C1 CN4 DZ5 CN3 HIC4 4 5

6 DZ3

RG * RG * INNER CIRCUIT

http://www.idc-com.co.jp HC04 etc. 15V G18 9 3 RG CN1 CN4 DZ5 D1 C1CN3 HIC4 4 5 RG DZ3 CN2 114 DZ D28 PC2 PC1PC2 DZ4 DZ1 DZ2 PC1 VIN IN2 HIC2 HIC1 HIC3 NC IN1 FO GND VD 4.7k Ω RC filter ~10us APPLICATION EXAMPLE Input Signal

http://www.idc-com.co.jp 65mm 95mm 3.75mm 3.75mm Part arrangement & Size DC-DC Converter VLA106-15242 Gate Driver VLA542-01R CONNECTOR Gate Resistor (This part is not installed at the time of shipment) Screw hole 3.5 φ CONNECTOR