CL40 ARTESYN | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 2

Technical content

Line regulation Single outputs ±0.2% LL to HL, FL Multi's: +5.1V output ±0.2% Multi's: aux. outputs ±1.0% Total regulation Single outputs ±5.0% NL to FL (Note 5) Multi's: +5.1V output, ±5.0% Multi's: aux. outputs See table Overshoot/undershoot At turn-on 10% max. Transient response +5.1V output ±250mV max. dev., (Single output model) (50% FL to 1ms recovery to 1% 100% FL step) Temperature coefficient All outputs ±0.02%/°C Overvoltage protection +5.1V output only 6.25V ±0.75V Output power limit Primary power limited 90W Pin max. 50W Pout min. Short Circuit Protection Continuous with auto-restart INPUT SPECIFICATIONS Input voltage range Note 1 85 to 264VAC Input frequency range 47 to 440Hz Input surge current 110VAC 12A max. 230VAC 30A max. Safety ground 110VAC, 60Hz 0.2mA leakage current 230VAC, 50Hz 0.4mA ELECTROMAGNETIC COMPATIBILITY SPECIFICATIONS Radiated emissions EN55022, EN55011, FCC Level B Conducted emissions EN55022, EN55011, FCC Level A Electrostatic discharge EN61000-4-2 Level 4 Electrostat. air discharge IEC801-2 Level 3 RF field susceptibility IEC801-3 Level 3 transients/bursts Surge susceptibility EN61000-4-5 Level 3 GENERAL SPECIFICATIONS Hold-up time 110VAC 12ms 230VAC 110ms Efficiency 110VAC and 230VAC 70% typical Isolation voltage Input/output 3000VAC Input/chassis 1500VAC Switching frequency Variable 20kHz to 70kHz Approvals and VDE0805, EN60950 standards IEC950, IEC1010, UL1950 BABT, CSA C22.2 No. 950 Case material ABS plastic Material flammability UL94V-0 Weight 800g (28oz) MTBF MIL-HDBK-217E 100,000 hours min. ENVIRONMENTAL SPECIFICATIONS Thermal performance Operating 0°C to +40°C Non-operating –40°C to +85°C 0°C to 40°C ambient 40W Peak (0°C to 40°C, max. 60s) 50W Relative humidity Non-condensing 5% to 95% RH Altitude Operating 10,000 feet max. Non-operating 40,000 feet max. Vibration, 5Hz to 500Hz See Note 8 2.4G rms (approx) Recommended for new design-ins CL40 SERIES Single and triple output [ 2 YEAR WARRANTY ]

  • 85VAC to 264VAC universal input range
  • Pre-approved SELV power solution
  • Up to 40W continuous output power
  • Up to 50W peak output power
  • UL, CSA, VDE and BABT approved
  • VDE0871-A conducted noise performance
  • Stand alone "listed" equipment The CL40 series is a family of 40W (50W peak) external switching power supplies. The CL40 enables the system specifier to optimise the design for several reasons. Firstly, because the power supply offers pre-approved SELV (Safety Extra Low Voltage) outputs, the submission of the apparatus for safety approval is simplified. This represents a significant saving of time and money. Secondly, the task of integrating the power supply into the mechanical design is eliminated, presenting further savings in time and money by ensuring a shorter and simpler design cycle. This means that your product gets to market faster. These advantages are complemented by universal input, CE mark, IEC950, UL, CSA, VDE and BABT approvals, to complete a worldwide packaged power solution suitable for a wide variety of low power, desktop applications. SPECIFICATION All specifications are typical at nominal input, full load at 25 ° C unless otherwise stated PAGE 1

OUTPUT OUTPUT CURRENT (1) RIPPLE (4) TOTAL MODEL NUMBERVOLTAGE MAX (2) PEAK (3) REGULATION (5) +5.1V (A) 3.0A 5.0A 50mV ±5.0% CL40-7608 –12.0V 0.35A 1.0A 120mV ±5.0% +5.1V (A) 3.0A 5.0A 50mV ±5.0% CL40-7610 –15.0V 0.35A 1.0A 150mV ±5.0% +5.1V 5.0A 5.0A 50mV ±6.0% CL40-7605 CL40-7605J (7) +12.0V 3.3A 4.0A 120mV ±5.0% CL40-7612 CL40-7612J (7) +13.5V 3.0A 3.7A 130mV ±5.0% CL40-7613 +15.0V 2.7A 3.3A 150mV ±5.0% CL40-7615 CL40-7615J (7) +16.5V 2.4A 3.0A 160mV ±5.0% CL40-7616 +24.0V 1.6A 2.0A 240mV ±5.0% CL40-7624 CL40-7624J (7) 2.5mm BATTERY ELIMINATOR JACK (SUFFIX 'J') + POSITIVE - NEGATIVE Notes 1 For 230VAC operation a minimum output load of 4 Watts is required. 2 Natural convection cooling, 40W maximum.

3 Peak output current lasting less than 60 seconds with duty cycle less than

10%. During peak loading outputs may go outside of regulation limits. Peak total power must not exceed 50W. 4 Figures are peak-to-peak. Output noise is measured across a 20MHz bandwidth using a 12” twisted pair terminated with a 47µF capacitor.

5 Total regulation is defined as the static output regulation at 25°C, including

initial tolerance, load currents within stated limits, and output voltages adjusted to their factory settings. Also, for ‘B’ output stated regulation: I(A)/I(B)<5.

6 The standard CL40 is IEC950/VDE0805 approved as a stand-alone power

supply. The plastic case incorporates an IEC 320 inlet receptacle. No input cable is supplied in Europe as standard. An input cable is supplied to customers in the US only. To order add the suffix ‘I’ to the end of the model number, e.g. CL40-7605I. In order to have a stand-alone power supply fully UL and CSA listed (as opposed to certified or recognised) it is required that the manufacturer pro- vide an approved input cable with the power supply. 7 The standard output connector is a DIN41524 five-pin plug. As an alterna- tive single output models can be supplied with a 2.5mm battery eliminator jack. To order this option add the suffix “J” to the model number. Example: CL40-7612J. See the table above for availability. 8 Three orthogonal axes random vibration, 10 minute test for each axis. 2.60 (66) (1829) 6.5 (165) 3.85 (98)1 STANDARD OUTPUT CONNECTION (DIN 41524 FIVE PIN PLUG) ALL DIMENSIONS ARE INCHES (mm) International Safety Standard Approvals VDE0805/EN60950, IEC950, IEC1010 File No. 10401-3336-1062 Licence No. 1062 UL1950 File No. E136005 CSA C22.2 No. 950 File No. LR41062/LR50913/LR101320 Certificate No. PS/603191

40 Watt

AC/DC external power supplies AC/DC POWER SUPPLIES | 40W AC/DC PAGE 2http://www.artesyn.com PIN CONNECTIONS PIN NUMBER SINGLES -7608 -7610 1+ V OUT +5.1V +5.1V 2+ V OUT +12V +15V

3 Return Return Return

4 Return –12V –15V

5 Return Return Return

geprüfte Sicherhelt DS_CL40_19980401.PDF