MPE-825A BOSER | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 1
Technical content
www.boser.com.tw Industrial Power SupplyAC-DCAC-DC MPE-825A 280W AC-DC ATX Power Supply *Input Voltage: 90~130VAC or 180~260VAC, auto switchable *Input Frequency: 47~63Hz *Inrush Current: Does not exceed 40A at 115VAC input or 80A at 230VAC input, at cold start 25oC *Ripple And Noise: Peak to peak ripple and noise for each output is < 1% of each output voltage at rated load 115~230VAC *Line Regulation: < +/-1% at rated load with +/-10% change in input voltage *Load Regulation: The output voltage load regulation is less than the values on the table when each output loading changes +/-40% from 60% rated load while all other outputs at 60% rated load *Hold Up Time: > 20ms at 115VAC input and rated load measured from the end of the last charging pulse to when the main output drops down to 95% output voltage *Power Good Signal: Goes high 100~500ms after all DC output are ready *Power Failure: Goes low 0.5ms before any DC output falls *Power On: TTL compatible signal (active low) used to switch ON the main output. When power on is disconnected from secondary common, all outputs except +5Vsb are turned off *Efficiency: > 65% at nominal line and rated load *Altitude: 10,000 feet *Protection: Short Circuit: Hiccup mode function against short circuit or over load conditions auto restarts when fault conditions are removed Output: Built-in crowbar circuit automatically shuts down outputs to avoid damaging external circuits. Trip point of *Temperature: 0~70 oC (operating); -40~+75oC (storage) *Humidity: 5~95%; non-condensing at 40oC (operating) *Connectors: AC Input/Output: Meets IEC 320/CEE 22 standard ATX Connector: Alex 9358-20 or equivalent device 3.5" Disk Drive: AMP 1-480424-0/171822-4 or equivalent device *Dimensions: 14.0 x 15.0 x 8.62 cm with +/-0.8mm and +/- 0.4mm tolerance between mounting holes *MTBF: 119,695 hrs. FeaturesFeatures Safety StandardsSafety Standards *Safety: UL 1950 / CSA 22.2 No.234 / VDE EN60950 *EMI: FCC class B / EN55022B *EMS: Level 3 of IEC-801, 802, 803, 804 Output +5V GND +12V -12V PIN Red Yellow Brown Grey +5V GND +12V -12V Black White Orange Purple PWR OnGreen Output Voltage +5V +12V -12V -5V +3.3V Min. Load 0.1A Rated Load 25A 10A 0.5A 0.5A Max. Load 30A 15A 15A Tolerance +/-0.2V +/-0.24V +/-0.6V +/-0.25V +/-0.17V +5Vsb 0A 0.72A 1.5A +/-0.25V 4-TAPPING#6-32 DC OUTPUT WIRES 14.0 11.02.0 14.4 0.42 0.42 15.0 3.722.4 8.62 11.50.5 4.8 1.6 6.4 2.7 13.800.5