M9330A KEYSIGHT | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 12
Technical content
Arbitrary Waveform Generator 15-bit, 1.25 GS/s TM
signers the most realistic, wideband waveforms availab le from a commercial AWG. Figure 1. Generate wideband waveforms with unprecede nted
- Keysight E8267D PSG signal generator with Option 016 ,
upconverter with Option 016; either option could be u sed. IF or as a baseband signal for I/Q upconversion.
03 Keysight M9330A Arbitrary Waveform Generator
Figure 2. Create sophisticated signal scenarios by looping and nesting waveforms. waveform segments are played through looping and nesting of stored waveforms. Figure 3. Closing targets can be simulated by ranging parameters on each pulse.
04 Keysight M9330A Arbitrary Waveform Generator
LabView, IVI-C, IVI-COM, and VEE frameworks. Figure 4. Four M9330A modules fit conveniently inside an 18 Figure 5. Directly import and play waveforms from the Quick Play Figure 6. Play waveforms files directly from the MATLAB command line.
05 Keysight M9330A Arbitrary Waveform Generator
input and multiple output formats (MIMO). Figure 7. Create signals where next waveform to be played is not Figure 8. Define signals by carrier frequency and modulation - instant by instant.
06 Keysight M9330A Arbitrary Waveform Generator
Figure 9. Excellent harmonic and spurious performance are available across the full bandwidth of each channel. Figure 10. Spurious performance outstanding at low signal frequencies.
07 Keysight M9330A Arbitrary Waveform Generator
KEY CHARACTERISTICS CONTINUED Sample clock Internal Fixed 1.25 GS/s Internal clock output +3 dBm nominal External clock input Tunable 100 MS/s to 1.25 GS/s External clock input drive level +5 to –15 dBm typical Phase noise characteristics 1 kHz: –95 dBc/Hz 10 kHz: –115 dBc/Hz 100 kHz: –138 dBc/Hz
1 MHz: –150 dBc/Hz
Noise floor –150 dBc/Hz Accuracy Same as 10 MHz timebase input Frequency reference Input drive level +2 to +12 dBm into 50 Ω (+2 dBm nominal) Waveform length 8 MS per channel (16 MS with option 016) Minimum waveform length 128 samples Waveform granularity 8 samples Segment 1 to 32 k unique segments can be defined consisting of waveform start and stop address, repetitions, and marker enable flags. Segment loops A total of 1 million (220) loops can be defined for each segment. Loops can be configured to advance in one of three modes: Single – The segment loop plays once and waits at the end of the loop for a trigger. Continuous – Segment loop is repeated continuously until a trigger is received. Auto – Automatically advances to the next segment after completing the specified number of loop repetitions. Repeat – The waveform loop repeats until the number of wave form loop repetitions is met. Sequences Up to 32 k total unique waveform sequences can be defined. A sequence is a contiguous series of waveform segments. Advanced sequencing Enables users to build and playback scenarios, which are comprised of one or more sequences. Scenarios 1 to 16 k pointers can be assigned to play pre-defined sequences. Sequence play begins with the first sequence entry and continues uninterrupted until the last entry is played. The table repeats until stopped.
08 Keysight M9330A Arbitrary Waveform Generator
KEY CHARACTERISTICS CONTINUED 1. A sync clock cycle is clock/8. Scenario jump modes Scenario jumps determine how a sequence responds to a jump trigger. There are no discontinuities in a scenario jump other than those imposed by the waveform data. Three modes are available to control scenario jumps: Jump immediate – Jumps immediately to the next specifie scenario address with a fixed latency. End of waveform – The current waveform (including repeats) is completed before jumping to a new scenario. End of scenario – The current scenario is completed before jumping to a new scenario. Jump latency is the longer of either the jump immediate latency or the length of the remaining scenario. Dynamic Sequencing (Option 300) Input 20-pin mini-D connector Input levels All pins configured as 2.5 volt LVCMOS inputs. A logic low must fall within the –0.2 to +0.5 volt window. A logic high must be within the window of +2.0 to +2.8 volts. Number of address bits 13 bits per channel Total number of addressable Scenarios 16 k Data rate for dynamic data 100 ns Data latency Same as front panel trigger inputs. Software pointers may also be used to point to pre-defined scenarios over the PCI backplane though latencies are not deterministic. Direct Digital Synthesis (Option 330) Output frequency resolution 1 Hz Frequency modulation Deviation from 0 to 125 MHz (250 MHz peak-peak) Phase modulation Deviation from –180 to +180 degrees in 0.022 degree steps Amplitude modulation Modulation depth from 0 to 100% with 15-bit resolution Single channel bandwidth 400 MHz (800 MHz I/Q) External triggers Number of inputs 8 each (4 SMB female frontpanel connectors plus four software triggers over the PCI backplane from host processor) Trigger polarity Negative/positive Trigger impedance 2k Ω Maximum input level ±4.5 volts Input sensitivity 250 mV Trigger threshold –4.3 volts to +4.3 volts Trigger timing resolution Clock/8 (6.4 ns at full rate) Trigger latency 34* clock/8 (217.6 ns at full rate) Trigger uncertainty < 50 ps Minimum trigger width 12.8 ns at full clock rate Trigger delay Programmable from 1 to 256 sync clock cycles with 1 sync clock cycle resolution 1
09 Keysight M9330A Arbitrary Waveform Generator
KEY CHARACTERISTICS CONTINUED External markers Markers can be defined for each waveform segment. Number of outputs 4 each SMB female Marker polarity Negative, positive Output impedance 50 Ω Marker low level 100 mV nominal into high impedance load Marker high level 3.2 volts nominal into high impedance load Marker timing resolution Clock/8 (6.4 ns at full rate) Marker latency Marker precedes analog output and is adjustable in 2 sample clock period steps. Marker latency repeatability < 100 ps Marker width Programmable with from 1 to 256 sync clock cycles 1 Marker delay Programmable from –8 to 502 sample clock cycles, with 2 sample clock cycle resolution Module synchronization Supports system scaling for any number of M9330A modules. A single module can support fan-out of 8 M9330A modules for precise triggering and repeatability. Driver boards may be used to scale any number of modules. Sync clock output level 800 mV p-p (50 Ω, AC coupled) Sync clock input sensitivity 100 mV p-p minimum into 50 Ω AC coupled Analog output Output connector SMA female Output impedance 50 Ω Analog output levels The following output levels are specified into 50 Ω S Differential Passive mode 0.5 Vp-p N/A Active mode 1 Vp-p with N/A ±0.2 V offset N/A Direct DAC mode N/A 1 Vp-p (0 volt offset) Corrected passband flatness ±1 dB DC - 200 MHz ±2.5 dB DC - 500 MHz (with 1.25 GHz clock) Corrected passband group delay ±500 ps DC - 200 MHz ±1 ns DC - 500 MHz (with 1.25 GHz clock) Reconstruction filters 500 MHz and 250 MHz realized as 7-pole Cauer Chebychev filters plus thru-line output Pulse response Rise time Rise time (10 to 90%): < 1 ns Fall time Fall time (10 to 90%): < 1 ns Amplitude Amplitude: 0.5 Vp-p
010 Keysight M9330A Arbitrary Waveform Generator
Supply +3.3 VDC, 11.2 W +5 VDC, 22 W +12 VDC, 5 W –12 VDC, 5 W Total power 43.2 W Environmental Samples of this product have been type tested in accordance with the Keysight Environmental Test Manual and verified to be robust against the environmental stresses of Storage, Transportation, and End-use; those stresses include but are not limited to temperature, humidity, shock vibration, altitude, and power line conditions. Test methods are aligned with IEC 60068-2 and levels are similar to MIL-PRF-28800F Class 3. Operating temperature 0 °C to +55 °C Storage temperature –20 °C to +70 °C Relative humidity Type tested: 10 to 90% at 40 °C (non-condensing) Altitude 0 to 2000m (6500 ft) above sea level Safety Designed for compliance to IEC 61010-1:2001 EMC Meets the conducted and radiated emissions and immunity requirements of IEC 61326:2002 when tested with EMC shielded filler panels separating the controller and the M9330A module, and in all open slots. The RFI gaskets must be oriented to the right. Weight 1.14 kg (2.5 lb) Security All user data stored in volatile memory Dimensions 3U, 4-slot PXI module ISO compliance This modular instrument is manufactured in an ISO-900 registered facility in concurrence with Keysight Technologies commitment to quality.
011 Keysight M9330A Arbitrary Waveform Generator
ORDERING INFORMATION
Figure 11. Keysight M9330A AWG with controller in PXI chassis. and one PXI controller type must be available.
For more information on Keysight Technologies’ products, applications or services, please contact your local Keysight office. The complete list is available at: www.keysight.com/find/contactus Americas Canada (877) 894 4414 Brazil 55 11 33 51 7010 Mexico 001 800 254 2440 United States (800) 829 4444 Asia Paciic Australia 1 800 629 485 China 800 810 0189 Hong Kong 800 938 693 India 1 800 112 929 Japan 0120 (421) 345 Korea 080 769 0800 Malaysia 1 800 888 848 Singapore 1 800 375 8100 Taiwan 0800 047 866 Other AP Countries (65) 375 8100 Europe & Middle East Belgium 32 (0) 2 404 93 40 Denmark 45 45 80 12 15 Finland 358 (0) 10 855 2100 France 0825 010 700* *0.125 €/minute Germany 49 (0) 7031 464 6333 Ireland 1890 924 204 Israel 972-3-9288-504/544 Italy 39 02 92 60 8484 Netherlands 31 (0) 20 547 2111 Spain 34 (91) 631 3300 Sweden 0200-88 22 55 United Kingdom 44 (0) 118 927 6201 For other unlisted countries: www.keysight.com/find/contactus (BP-04-23-14) Keysight | M9330A Arbitrary Waveform Generator This information is subject to change without notice. © Keysight Technologies 2010 - 2014 Published in USA, July 31, 2014 5990-6426EN www.keysight.com myKeysight www.keysight.com/find/mykeysight A personalized view into the information most relevant to you. www.pxisa.org PCI eXtensions for Instrumentation (PXI) modular instrumentation delivers a rugged, PC-based high-performance measurement and automation system. www.keysight.com/quality Keysight Electronic Measurement Group DEKRA Certified ISO 9001:2008 Quality Management System Keysight Channel Partners www.keysight.com/find/channelpartners Get the best of both worlds: Keysight’s measurement expertise and product breadth, combined with channel partner convenience. www.keysight.com/find/modular