EDS1202-002 EUROPA | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 1
Technical content
This document must be retained for future reference. It is the responsibility of the person installing the electrical equipment to ensure that the installation meets the requirements of the IET wiring regulations and is therefore ‘fit for purpose’. Factors such as correct selection of components, cable sizing, protective devices and Earth bonding are all critical and should be checked prior to full testing and power-up. Any other regulations applicable to the equipment being installed such as the Machinery Directive and current health and safety legislation must also be adhered to. All connections (including factory made) must be checked for the correct tightness prior to commissioning of the electrical installation. All connections should also be inspected periodically to ensure correct tightness. DO NOT USE POWER TOOLS ON THESE PRODUCTS Europa House, Airport Way, Luton, Bedfordshire, LU2 9NH Technical: 01582 692 444 technical@europa-plc.com www.europa-plc.com Data Sheet EDS1202-002 Page 1 of 1 EUR PA ISO125-3 (3 Pole) and ISO125-4 (4 pole) 125A Switch- Disconnector Product Ranges ISO125-3 & ISO125-4 Standard(s) IEC 60947-3, EN 60947-3 Rated Current (In) 125A Rated Uninterupted Current (lu) 125A Rated Operational Voltage (Ue) 415V AC Rated Frequency 50/60Hz Rated impulse withstand Voltage (Uimp) 4kV Number of Poles 3 & 4 Rated Insulation Voltage (Ui) 415V Utilisation Category AC-22A Operating Temperature -5°C to 40°C* Altitude Not exceeding 2000 metres Humidity Not exceeding 50% at 40°C and 90% at 20°C Pollution Degree 3 Terminal protection IP20 Mounting 35mm DIN Rail Terminal Type Tunnel Terminal Capacity 6-50mm² Recommended Terminal Torque (IN) 2.0Nm *average not exceeding 350C over a 24 hour period IMPORTANT: Only to be used as a main incoming device on the Europa TPN boards or as a stand alone unit. Not suitable for the Europa consumer units due to different terminal heights.