HDM11-S HITRON | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
-21- H HiTRON PCB-MOUNT DC-DC CONVERTER ENCAPSULATED MODULES INDUSTRIAL GRADE 10 WATTS SINGLE & DUAL OUTPUT HDM11-S & HDM11-D SERIES FEATURES: VERY LOW PROFILE 7 MM HIGH SINGLE & DUAL OUTPUT WIDE 4:1 INPUT RANGE 10W ISOLATED OUTPUT SIX-SIDED METAL SHIELD OUTPUT SPECIFICATION Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Voltage Accuracy: Main O/P ±2.0% typical. Line Regulation: Various with output voltages ±0.5% typ. Load Regulation: Various with output voltages. Single O/P ±1.0 typical. Dual O/P ±2.0 typical. Noise & Ripple: Typical 100mV for 3.3V/5.0V & 1.0% for others peak to peak. OVP: Built-in on main output. Adjustability: Not available. Overload Protection (OLP): Fully protected against output overload and short circuit. OLP set t about 120-150% of rating output load. Consult the factory for special OLP setting. SPECIFICATION INPUT SPECIFICATION Input Range: Wide 4:1 DC input range. See Ratings Chart. Input Voltage: Nominal 12/24/48Vdc. Input Current: Various with input range and load. See Ratings Chart. Input Fuse: Use external fuse. Input Filter: Pi-Network. Undervoltage Shutdown: 8Vdc. Isolation Resistor: 1,000 Mega Ohms. Isolation Voltage: 1,500Vdc. EMI: Six-sided metal shielding. Remote On/Off: TTL/CMOS-Compatible Input Control. Positive Logic version for Standard set up: ON(Enable)=Open(or 2.5-5.0Vdc above-Vin) OFF(Disable)=Short(or 0-0.8Vdc above-Vin) Negative Logic version option available by adding a “N” suffix to the end of Model #. Remark: Logic voltage refer to –Input(Vin). GENERAL SPECIFICATION Efficiency: 78% typical various with input. Switching Frequency: Fixed frequency 450K Hz. Circuit Topology: 450K Hz. Forward Circuit. Transient Response: Peak deviation 200mV. Recovery time < 3mS for a 25% load change. Case: Black coated aluminum with non-conductive metal base. Power Density: 17.2Watts. / Cubic inch. MTBF: 1,000,000 hours. Mil. Std. 217, 25°C. Operating Temperature: -25°C to +85°C range. –10°C to+70°C @ full load without derating. From+70°C, derating linearly to half load @+85°C. (Refer to Derating Chart). Storage Temperature: -40°C to +105°C. Humidity: Up to 95% RH, Non-condensing. Temperature Coefficient: 0.02% /°C. Cooling: Convection cooling up to 70°C @ full load. At least 100LFM moving air is recommended for full load >+70°C in a confined area. Industrial Grade only. NOTE:(1) All measurements are at nominal input, full load and +25°C unless otherwise specified. (2) Line Regulation measured from High to Low Lines at full load. (3) Load Regulation measured from Full Load (F-L) to Half-Load (H-L) at nominal input. (4) Correct fuse size by calculating the max. DC current drains at low Line input & Load and then adding 20-25% for the desired fuse size. Due to requests in market and advances in technology, specifications subject to change without notice.
-22- INPUT/ OUTPUT & VOLTAGE/ CURRENT RATINGS CHART SINGLE OUTPUT HDM11-12D-S03 9.0- 36.0 50 900 3.3V 2.50A DM1A HDM11-12D-S05 9.0- 36.0 50 1070 5.0V 2.00A DM1A HDM11-12D-S09 9.0- 36.0 50 1050 9.0V 1.10A DM1A HDM11-12D-S12 9.0- 36.0 50 1050 12.0V 0.83A DM1A HDM11-12D-S15 9.0- 36.0 50 1050 15.0V 0.67A DM1A HDM11-24D-S03 9.0- 36.0 50 450 3.3V 2.50A DM1A HDM11-24D-S05 9.0- 36.0 50 535 5.0V 2.00A DM1A HDM11-24D-S09 9.0- 36.0 50 525 9.0V 1.10A DM1A HDM11-24D-S12 9.0- 36.0 50 525 12.0V 0.83A DM1A HDM11-24D-S15 9.0- 36.0 50 525 15.0V 0.67A DM1A HDM11-48D-S03 18.0- 72.0 46 220 3.3V 2.50A DM1A HDM11-48D-S05 18.0- 72.0 46 260 5. 0V 2.00A DM1A HDM11-48D-S09 18.0- 72.0 46 255 9.0V 1.10A DM1A HDM11-48D-S12 18.0- 72.0 46 255 12.0V 0.83A DM1A HDM11-48D-S15 18.0- 72.0 46 255 15.0V 0.67A DM1A DUAL OUTPUT Symbols: "★" OVP built-in. " ║" Double Feedback. MECHANICAL DIMENSIONS: MM [INCHES] WEIGHT: 20.0g (0.71 Oz.) DERATING CHART PIN ASSIGNMENT PIN NO. SINGLE DUAL PIN# 1. Remote ON/OFF Remote ON/OFF PIN# 2. - INPUT/-Vin - INPUT/-Vin PIN# 3. + INPUT + INPUT PIN# 4. DC-COM - VO2 PIN# 5. NO PIN DC-COM PIN# 6. VO1 +VO1 CASE SIZE: DM1A