PE4235 PEREGRINE | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 8

Technical content

Features

  • Single 3.0-volt power supply
  • Low insertion loss: 0.40 dB at 1000 MHz, 0.45 dB at 2000 MHz
  • High isolation of 40 dB at 1000 MHz, 30 dB at 2000 MHz
  • Typical 1 dB compression point of +15 dBm
  • Single-pin CMOS or TTL logic control
  • Available in a 6-lead DFN package Notes: 1. Device linearity will begin to degrade below 10 MHz. 2. The DC transient at the output of any port of the switch when the control voltage is switched from Low to High or High to Low in a 50 Ω test set-up, measured with 1ns risetime pulses and 500 MHz bandwidth.

Table 1. Electrical Specifications @ +25 °C, VDD = 3 V (ZS = ZL = 50 Ω) Figure 2. Package Type

1000 MHz

2000 MHz

2000 MHz, 5 dBm

©2005 Peregrine Semiconductor Corp. All rights reserved. Document No. 70-0069-03 │ UltraCMOS™ RFIC Solutions Table 2. Pin Descriptions Table 4. Absolute Maximum Ratings exceeding the rating specified in Table 4. devices are immune to latch-up. Table 3. DC Electrical Specifications Figure 3. Pin Configuration Table 5. Control Logic Truth Table may cause permanent device damage. limits in the DC Electrical Specifications table. extended periods may affect device reliability.

Description

RF2 port.1 GND Ground Connection. Traces should be physically short and connected to the ground plane. This pin is connected to the exposed solder pad that also must be soldered to the ground plane for best performance. RF1 RF1 port.1 VDD Nominal 3 V supply connection. CTRL CMOS or TTL logic level: High = RFC to RF1 signal path Low = RFC to RF2 signal path RFC Common RF port for switch.1 Parameter Min Typ Max Units VDD Power Supply Voltage 2.7 3.0 3.3 V IDD Power Supply Current (VDD = 3V, VCNTL = 3V) 250 500 nA Control Voltage High 0.7xVDD V Control Voltage Low 0.3xVDD V Symbol Parameter/Conditions Min Max Units VDD Power Supply Voltage -0.3 4.0 V VI Voltage on any input except for CTRL pin -0.3 VDD + 0.3 V VCTRL Voltage on CTRL pin V TST Storage temperature range -65 150 TOP Operating temperature range -40 PIN Input power (50 Ω) dBm VESD ESD Voltage (Human Body Model) 200 V Control Voltage Signal Path CTRL = CMOS or TTL High RFC to RF1 CTRL = CMOS or TTL Low RFC to RF2

©2005 Peregrine Semiconductor Corp. All rights reserved. Figure 14. Package Drawing 3 COPLANARITY APPLIES TO EXPOSED HEAT SLUG AS WELL AS THE TERMINALS. 4 PROFILE TOLERANCE APPLIES TO PLASTIC BODY ONLY.

  1. DIMENSIONS AND TOLERANCES ARE PER ANSi Y14.5
  2. DIMENSIONS ARE IN MILLIMETERS, ANGLES ARE IN DEGREES.

©2005 Peregrine Semiconductor Corp. All rights reserved. Document No. 70-0069-03 │www.psemi.com Table 6. Dimensions Table 7. Ordering Information 3000 units / T&R 4235-00 PE4235-EK PE4235-06DFN 3x3mm-EK Evaluation Kit 1 / Box 4235-51 4235 PE4235G-06DFN 3x3mm-12800F Green 6-lead 3x3 mm DFN 12800 units / Canister 4235-52 4235 PE4235G-06DFN 3x3mm-3000C Green 6-lead 3x3 mm DFN 3000 units / T&R Figure 14. Tape and Reel Specifications

©2005 Peregrine Semiconductor Corp. All rights reserved. Document No. 70-0069-03 │ UltraCMOS™ RFIC Solutions Sales Offices The Americas Peregrine Semiconductor Corp.

9450 Carroll Park Drive

San Diego, CA 92121 Tel 858-731-9400 Fax 858-731-9499 North Asia Pacific Peregrine Semiconductor K.K. 5A-5, 5F Imperial Tower 1-1-1 Uchisaiwaicho, Chiyoda-ku Tokyo 100-0011 Japan Tel: +81-3-3502-5211 Fax: +81-3-3502-5213 Europe Peregrine Semiconductor Europe Commercial Products: Bâtiment Maine 13-15 rue des Quatre Vents F- 92380 Garches, France Space and Defense Products:

180 Rue Jean de Guiramand

13852 Aix-En-Provence cedex 3, France

Tel: +33(0) 4 4239 3361 Fax: +33(0) 4 4239 7227 For a list of representatives in your area, please refer to our Web site at: www.psemi.com Data Sheet Identification Advance Information The product is in a formative or design stage. The data sheet contains design target specifications for product development. Specifications and features may change in any manner without notice. Preliminary Specification The data sheet contains preliminary data. Additional data may be added at a later date. Peregrine reserves the right to change specifications at any time without notice in order to supply the best possible product. Product Specification The data sheet contains final data. In the event Peregrine decides to change the specifications, Peregrine will notify customers of the intended changes by issuing a DCN (Document Change Notice). The information in this data sheet is believed to be reliable. However, Peregrine assumes no liability for the use of this information. Use shall be entirely at the user’s own risk. No patent rights or licenses to any circuits described in this data sheet are implied or granted to any third party. Peregrine’s products are not designed or intended for use in devices or systems intended for surgical implant, or in other applications intended to support or sustain life, or in any application in which the failure of the Peregrine product could create a situation in which personal injury or death might occur. Peregrine assumes no liability for damages, including consequential or incidental damages, arising out of the use of its products in such applications. The Peregrine name, logo, and UTSi are registered trademarks and UltraCMOS is a trademark of Peregrine Semiconductor Corp. South Asia Pacific Peregrine Semiconductor 28G, Times Square, No. 500 Zhangyang Road, Shanghai, 200122, P.R. China Tel: +86-21-5836-8276 Fax: +86-21-5836-7652