3400185 CLARKE | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 4
Technical content
(WITH REMOVABLE LINER) MODEL NO: GT3 PART NO: 3400185
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com INTRODUCTION Thank you for purchasing this CLARKE Garden Trolley. Before attempting to use this product, please follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you and you can look forward to your purchase giving you long and satisfactory service. SAFETY PRECAUTIONS 1. ALWAYS be sure you are strong enough to move heavy loads. 2. DO NOT exceed the 150kg maximum working load for this trolley. 3. DO NOT park the trolley on a gradient without securely chocking the wheels. 4. DO NOT allow children to play with or ride in the trolley. 5. NEVER use the trolley if any of the tyres are deflated. 6. NEVER use the trolley to transport personnel or animals. 7. ALWAYS inspect the trolley for signs of wear or damage before use. 8. ALWAYS ensure the load is evenly distributed and is stable. ASSEMBLY 1. Assemble the steering linkage components to the front axle bracket as shown in Fig 1.
- Bolts ‘A’ are used at all linkage points.
- Secure the linkage at point ‘B’ using the flat washer and split pin. 2. Turn the trolley bed on its back and attach the sub-assembly to the bed using the bolts, flat washers and lock- nuts supplied as shown in Fig 2. NOTE: Flat washers should be used against the nuts. DO NOT over- tighten.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com 3. Slide the axle braces, over the ends of the rear axle and attach the assembly to the trolley bed using the bolts, flat washers and lock-nuts supplied as shown in Fig.3. 4. Attach the wheels, securing with the large flat washers and nuts as shown in Fig 4, taking care not to over- tighten. (nut & washer shown fitted) 5. Turn the complete trolley assembly the right way up. 6. Slide the lower handle into the trunnion and attach both to the yoke on the steering assembly as shown in Fig 5 using the bolt, washer and nut. 7. Add the upper handle section and secure using the bolt and split-pin.
- Note that the complete handle assembly can be twisted through 90 degrees if required using the additional holes at the end of the lower handle. 8. Attach the side and end fences to the bed using the ‘R’ clips as shown in Fig Clip the removable liner to the side panels if carrying loose materials and sit the mesh basket astride the side frames. Replacement parts are available from your CLARKE dealer.