3400656 CLARKE | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 4
Technical content
ORIGINAL INSTRUCTIONS GC05/25 TILE CUTTER MODEL NO: CTCM400 PART NO: 3400656
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com INTRODUCTION Thank you for purchasing this CLARKE Tile Cutter. The CTCM400 tile cutter is ideal for professional and DIY users alike. Ceramic tiles up to 400mm (16”) in length, and 14mm (1/2”) thick, may be cut perfectly straight. The CTCM400 has the additional capability of cutting to any angle, accurately, (max. diagonal cut - 400mm). Please read this leaflet thoroughly before use. This will ensure not only the safety of both yourself and those around you, but also accuracy of operation and long and trouble free service from your tile cutter. TILE CUTTING 1. Place the tile on the work table with the line to be scored exactly in line with the centre mark on the scale.
- An end stop is provided to ensure the tile is held in a square position. (Ensure the angle gauge is set to zero degrees).
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com 2. Adjust the position of the width guide to accommodate the tile and hold the tile firmly in place with the left hand, as shown. 3. Raise the handle and draw the slide back, past the edge of the tile, then lower the handle so that the tungsten carbide scoring wheel comes into contact with the leading edge of the tile. 4. Apply a firm pressure (not too heavily) down on to the handle whilst pushing forward, smoothly and evenly, in the direction of the arrow, so that the tile is scored along its entire length. 5. Raise the handle and reposition the slide so that the breaker bars are approximately half way along the tile. DO NOT MOVE THE TILE. 6. Pressing down on the handle again will cause the tile to break It is necessary to score the tile ONCE ONLY. The tile cutter is provided with an angle gauge so that the tile may be secured at any angle for cutting in a straight line. Simply adjust the angle gauge to the required angle and place the tile so that it is held firmly against the angle gauge guide plate. GUARANTEE This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase. This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the purpose for which it was intended. Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not effect your statutory rights.