1855539 PHOENIX | Alldatasheet

Document overview

  • Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
  • PDF pages: 7

Technical content

Please be informed that the data shown in this PDF document is generated from our online catalog. Please find the complete data in the user documentation. Our general terms of use for downloads are valid. Sleeve housing, Range of articles: VARIOCON, design: VC1, housing material: Zinc die-cast, color: gray, When using fiber optics, the bending radii of the cable manufacturers must be observed. Commercial data Item number 1855539 Packing unit 5 pc Minimum order quantity 1 pc Note Made to order (non-returnable) Sales key AB01 Product key ABLAAB Catalog page Page 369 (PC-2009) GTIN 4017918161514 Weight per piece (including packing) 245 g Weight per piece (excluding packing) 244.64 g Customs tariff number 85389099 Country of origin PL VC-MP-T1-R - Sleeve housing 1855539 https://www.phoenixcontact.com/us/products/1855539 Oct 30, 2024, 4:57 AM Page 1 (7)

General When using fiber optics, the bending radii of the cable manufacturers must be observed. Safety note WARNING: The connectors may not be plugged in or disconnected under load. Ignoring the warning or improper use may damage persons and/or property.

  • WARNING: Commission properly functioning products only. The products must be regularly inspected for damage. Decommission defective products immediately. Replace damaged products. Repairs are not possible.
  • WARNING: Only electrically qualified personnel may install and operate the product. They must observe the following safety notes. The qualified personnel must be familiar with the basics of electrical engineering. They must be able to recognize and prevent danger. The relevant symbol on the packaging indicates that only personnel familiar with electrical engineering are allowed to install and operate the product.
  • The products are suitable for applications in plant, controller, and electrical device engineering.
  • When operating the connectors in outdoor applications, they must be separately protected against environmental influences.
  • Assembled products may not be manipulated or improperly opened.
  • Only use mating connectors that are specified in the technical data of the standards listed (e.g. the ones listed in the product accessories online at phoenixcontact.com/products).
  • When using the product in direct connection with third-party manufacturers, the user is responsible.
  • For operating voltages > 50 V AC, conductive connector housings must be grounded
  • Ensure that the protective or functional ground has been properly connected. are applicable when combining several circuits in a cable and/or connector
  • Observe the corresponding technical data. You will find information: o On the product o On the packing label o In the supplied documentation o Online at phoenixcontact.com/products under the product
  • Only use tools recommended by Phoenix Contact
  • The installation notes/Design In documents online on the download page at phoenixcontact.com/products must be observed for this product.
  • Use a protective cap to protect connectors that are not in use. The suitable accessories are available online in the accessory section of the product at phoenixcontact.com/products
  • Operate the connector only when it is fully plugged in. Safety note VC-MP-T1-R - Sleeve housing 1855539 https://www.phoenixcontact.com/us/products/1855539 Oct 30, 2024, 4:57 AM Page 2 (7)
  • Ensure that when laying the cable, the tensile load on the connectors does not exceed the upper limit specified in the standards.
  • Observe the minimum bending radius of the cable. Lay the cable without twisting it.
  • The connector warms up in normal operation. Depending on the ambient conditions, the surface of the connector can continue to warm up. In this case, the user is responsible for posting warnings (e.g. DIN EN ISO 13732-1:2008-12). Product properties Product type Sleeve housings Product family VARIOCON Type VC1 No. of cable outlets 1 Number of module slots 2 Type of the screw connection 1x Pg16 Shielded no Cable outlet angled Data management status Article revision 06 Connection data Dimensions Dimensional drawing Width 33 mm Height 71 mm Length 66 mm Thread type on seal side Pg16 Material specifications Color gray Color of the housing part gray Die-cast zinc (Housing)Material NBR (O-ring) Flammability rating according to UL 94 V0 Seal material EPDM Housing material Zinc die-cast O-ring material NBR VC-MP-T1-R - Sleeve housing 1855539 https://www.phoenixcontact.com/us/products/1855539 Oct 30, 2024, 4:57 AM Page 3 (7)

Material of locking screw Brass, nickel-plated Mechanical properties Mechanical data Type of the screw connection 1x Pg16 Locking type Screw Environmental and real-life conditions Ambient conditions IP67 (IEC 60529)Degree of protection IP65/IP66/IP67 Ambient temperature (operation) -40 °C ... 125 °C VC-MP-T1-R - Sleeve housing 1855539 https://www.phoenixcontact.com/us/products/1855539 Oct 30, 2024, 4:57 AM Page 4 (7)

3340 9,5 VC-MP-T1-R - Sleeve housing 1855539 https://www.phoenixcontact.com/us/products/1855539 Oct 30, 2024, 4:57 AM Page 5 (7)

ECLASS-11.0 27440202 ECLASS-12.0 27440202 ECLASS-13.0 27440202 ETIM ETIM 9.0 EC000437 UNSPSC UNSPSC 21.0 31261500 VC-MP-T1-R - Sleeve housing 1855539 https://www.phoenixcontact.com/us/products/1855539 Oct 30, 2024, 4:57 AM Page 6 (7)

Environmental product compliance EU RoHS Fulfills EU RoHS substance requirements Yes, No exemptions China RoHS EFUP-EEnvironment friendly use period (EFUP) No hazardous substances above the limits EU REACH SVHC REACH candidate substance (CAS No.) No substance above 0.1 wt% Phoenix Contact 2024 © - all rights reserved https://www.phoenixcontact.com Phoenix Contact USA

586 Fulling Mill Road

Middletown, PA 17057, United States (+717) 944-1300 info@phoenixcon.com VC-MP-T1-R - Sleeve housing 1855539 https://www.phoenixcontact.com/us/products/1855539 Oct 30, 2024, 4:57 AM Page 7 (7)