1801612 CLARKE | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 8
Technical content
ASSEMBLY & INSTRUCTION MANUAL LS1216 1.5L OIL EXTRACTOR MODEL: CHT612 Part No: 1801612
Thank you for purchasing this CLARKE product Before attempting to use the product, it is essential that you read this manual thoroughly and carefully follow all instructions given. In doing so you will ensure the safety of yourself and that of others around you, and you can also look forward to the product giving you long and satisfactory service. GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase. This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for the purpose for which it was intended. Faulty goods should be returned to their place of purchase, no product can be returned to us without prior permission. This guarantee does not effect your statutory rights. ENVIRONMENTAL PROTECTION Do not dispose of this product with general household waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of appropriately. PARTS & SERVICE For parts & Servicing, please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 PARTS & SERVICE FAX: 020 8558 3622 or e-mail as follows: PARTS: Parts@clarkeinternational.com SERVICE: Service@clarkeinternational.com
- Make sure that the oil extractor is in perfect condition before use i.e. No cracks which would result in oil leaks. When disposing of oil, it must be disposed of according to local regulations. Never pour it down drains. When draining oil, make sure that the engine is switched off. Warm oil is easier to drain, but make sure the oil is not hot Make sure that the oil extractor is on a stable surface. If oil is spilt, the area must be cleaned completely and sand or sawdust scattered on the area to absorb the oil and then cleaned up. You should also alert people in the vicinity to the possible danger of slipping. DO NOT use this equipment with petrol or other flammable liquids or chemicals. ALWA YS drain and clean the unit thoroughly after use, and store in a clean , dry place. PARTS IDENTIFICATION Hose Collection Container Bung Plunger
- Slide the bung into the top of the collection container. Make sure it is secure. 2. Take the thinner hose and slide the thick section through the hole as shown. Do not slide it all the way through, about 5-7cm should be enough. 3. Screw the plunger into position taking care not to over tighten it. 4. The Oil Drainer is ready for use. 1 2 3 4
- Place the hose into the oil sump you wish to drain. 2. Make sure the collection container is positioned lower then the oil sump. 3. Raise the plunger up and down to start syphoning the oil into the collection container. JOINING THE HOSES If you require a longer hose, simply join the two hoses together as shown.
Drain and clean the container after use. Do not clean the unit with aggressive detergents or chemicals. SPECIFICATION HOSE A HOSE B
Below are further Clarke products ideal for fluid/oil extraction, available from your local Clarke dealer. Clarke COD70 (70 litre oil drainer) Gravity fed with 2m discharge hose, ideal for professional garage use. Part number: 7630203 Clarke CHT588 (Pneumatic Fluid Extractor) Safely extracts oils, coolents and other fluids from cars, motorcycles, vans/lorries etc. Part number: 1801588 ClarkeOCD8 (8 gallon Oil Drain Cart) Low entry cart for garage use, ideal for commercial vehicle oil changes etc. Part number: 3051470