SH110-4 overview
SH110-4 is a component documented by Danley Sound Labs. All. The PDF description identifies it as "2 Way Full Range Loudspeaker Rev. 202305022." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Danley Sound Labs. All ...
- Part number: SH110-4
- Category: IC
- Datasheet length: 2 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- Gainesville, GA 30501 danleysoundlabs.com | 877.419.5805 Performance Specifications Operating Mode Two-way single channel amplified Operating Range 360Hz - 15 KHz, -3dB Low 2x8”, High 1x1.4” Power Handling 500 W Cont. | 2000 W Peak Sensiti.
- Black polyurea coated enclosure w/ matte black grille, or White polyurea coated enclosure w/ matte white grille Gray UV resistant painted enclosure w/ matte grey grille Enclosure Material 18mm Baltic Birch, polyurea coated Options SH110-4.
- Utilizing our patented Synergy Horn™ technology, we uniquely place drivers within the horn in unison with a Synergy crossover network to allow for proper phase alignment between frequency bands.
- This permits the physically separated bands to combine and emerge from the horn as a single source, greatly reducing off axis distortions in frequency response and allowing for greater clarity at long distances.
- Furthermore, out of band harmonic distortion is reduced by the use of acoustic low pass filters on the low and mid frequency drivers.
- As an added layer of protection we include our Sentinel™ high frequency driver protection circuitry which is a multistage limiter that protects the high freq driver in the event of overloads (peaks or long term).
- The loudspeaker shall have an operating rage of 90 Hz - 20kHz - 10 dB.
Engineering review checklist
- Verify supply range, input common-mode range and output swing at the required load.
- Check offset, bias current, noise, bandwidth, slew rate and stability for the intended feedback network.
- Review supply decoupling, source impedance, capacitive-load behavior and thermal limits in the final layout.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the SH110-4 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=sh110-4-danley-sound-labs-all