RL1024P overview
RL1024P is a component documented by PerkinElmer Optoelectro. The PDF description identifies it as "P-SERIES LINEAR PHOTODIODE ARRAY IMAGERS." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: PerkinElmer Optoelectro...
- Part number: RL1024P
- Category: Interface
- Datasheet length: 8 Pages
Key features noted in the PDF
- Extended spectral range—250 to 1000 nm
- 40 MHz pixel readout rate
- 2500:1 dynamic range
- 5-volt clocking
- Line rates to 70 kHz
- Ultra low image lag
- Electronic exposure control
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- DATASHEET Lighting Imaging Telecom Imaging Product Line DSP-101 01H - 7/2002W Page 1 Description (cont.) P-series imagers combine high-perfor- mance photodiodes with high-speed CCD readout registers and a high- sensitivity readout amplifie.
- DSP-101 01H - 7/2002W Page 2 Figure 1: Imager Functional Diagram Output Amp 2-Phase Buried Channel CCD Shift Register Transfer Gate Antiblooming/Exposure Control Gate N = 512 for the RL0512P N = 1024 for the RL1024P N = 2048 for the RL2048.
- While the two-phase CCD shift register architecture allows relaxed timing tolerances over those required in three- or four-phase designs, optimum charge transfer effici ency and lowest power dissipation is obtained when the overlap of the.
- Readout timing details are shown in Figure 4 with ranges and tolerances in Table 2.
- An apparent clipping of the video signal will result if this Item Sym Min Typ Max ø1, ø2 clock period t 1 25 ns - - ø1, ø2 rise/fall time t 2 -5 n s - øRG rise/fall time t 4 -5 n s - øRG clock - high duration t 5 5 ns - - Delay of ø1 high.
- Horizontal Shift Registers (cont.) DSP-101 01H - 7/2002W Page 4 ments and overlap tolerances.
- Absolute Maximum Rating Above Which Useful Life May Be Impaired ments facilitate optimum designs. Table 6.
Topics covered by the datasheet
The document includes sections related to:
- Features
- Ordering Information
Engineering review checklist
- Confirm repetitive reverse voltage, average forward current, surge current and leakage at the intended temperature.
- Check forward-voltage loss and reverse-recovery behavior at the actual current and switching frequency.
- Review package thermal resistance, copper area, polarity marking and transient derating before layout release.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the RL1024P datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=rl1024p-perkinelmer-optoelectro