MG82F6D17 overview
MG82F6D17 is a component documented by Megawin Technology Co.,. The PDF description identifies it as "MG82F6D17 2021/04 version 1.00." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Megawin Technology Co.,...
- Part number: MG82F6D17
- Category: IC
- Datasheet length: 306 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- UART baud rate up to 3.6864MHz/ 6MHz ━ Support SPI Master in Mode 4, up to 12MHz on SPICLK ━ Built-in baud rate generator (S0BRG) to support TX or RX on different baud rate ━ Support LIN bus protocol with auto baud rate detection in mode 5.
- UART baud rate up to 1.8432/3.0MHz ━ Support SPI Master in Mode 4, up to 12MHz on SPICLK ━ S1BRG in timer mode cascaded with Timer 0/1 to be a 16/24-bit timer/counter One Master/Slave SPI serial interface ━ Max.
- 24MHz SPICLK on SPI master ━ Max 12MHz on SPI slave ━ 8 bits data transfer ━ Up to 3 SPI masters including S0/S1 in mode 4 ━ Support daisy-chain function in SPI slave mode Two Master/Slave two wire serial interfaces: TWI0/ I2C0 and STWI.
- 1MHz on TWI0/ I2C0 master mode and Max.
- 400KHz on TWI0 slave mode ━ One software TWI/ I2C, STWI/ SI2C, Start/Stop serial interface detection (SID) Programmable Watchdog Timer (WDT), clock sourced from ILRCO or SYSCLK/12 ━ One time enabled by CPU or power-on ━ Interrupt CPU or.
- In addition, the MG82F6D17 has17 I/O port pins, one XRAM of 768 bytes, one extra external interrupts with High/low trigger option, 800KHz 12-bit ADC, one 16-bit timer, one 8-channel PCA with dead-time controlled PWM, one 8-bit SPI, two TWI.
- If P6.0 is configured to clock output, enable this bit when P6.0 output frequency is more than 12MHz at 5V application or more than 6MHz at 3V application.
Topics covered by the datasheet
The document includes sections related to:
- Features
- description
Engineering review checklist
- Confirm supply rails, clock limits, memory size, peripheral mapping and I/O voltage compatibility.
- Check package pinout, boot configuration, programming interface and silicon-revision errata.
- Budget decoupling, thermal margin, startup timing and firmware recovery behavior before release.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the MG82F6D17 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=mg82f6d17-megawin-technology-co