CED1Z overview
CED1Z is a component documented by Analog Devices. The PDF description identifies it as "8-/6-/4-Channel DAS with 16-Bit,Bipolar Input,Simultaneous Sampling ADC REV. 0." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Analog Devices
- Part number: CED1Z
- Category: IC
- Datasheet length: 36 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- 8/6/4 simultaneously sampled inputs True bipolar analog input ranges: ±10 V, ±5 V Single 5 V analog supply and 2.3 V to 5 V V DRIVE Fully integrated data acquisition solution Analog input clamp protection Input buffer with 1 MΩ analog inpu.
- Each part contains analog input clamp protection, a second-order antialiasing filter, a track-and-hold amplifier, a 16-bit charge redistribution successive approximation analog-to-digital converter (ADC), a flexible digital filter, a 2.5 V.
- The AD7606/AD7606-6/AD7606-4 operate from a single 5 V supply and can accommodate ±10 V and ±5 V true bipolar input signals while sampling at throughput rates up to 200 kSPS for all channels.
- The input clamp protection circuitry can tolerate voltages up to ±16.5 V .
- The AD7606 has 1 MΩ analog input impedance regardless of sampling frequency.
- The AD7606/AD7606-6/AD7606-4 antialiasing filter has a 3 dB cutoff frequency of 22 kHz and provides 40 dB antialias rejection when sampling at 200 kSPS.
- Parameter Test Conditions/Comments Min Typ Max Unit DYNAMIC PERFORMANCE fIN = 1 kHz sine wave unless otherwise noted Signal-to-Noise Ratio (SNR)2, 3 Oversampling by 16; ±10 V range; fIN = 130 Hz 94 95.5 dB Oversampling by 16; ±5 V range; f.
Topics covered by the datasheet
The document includes sections related to:
- DATASHEET SEARCH SITE
- FEATURES
- APPLICATIONS
- REVISION HISTORY
Engineering review checklist
- Verify supply range, input common-mode range and output swing at the required load.
- Check offset, bias current, noise, bandwidth, slew rate and stability for the intended feedback network.
- Review supply decoupling, source impedance, capacitive-load behavior and thermal limits in the final layout.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the CED1Z datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=ced1z-analog-devices