27C4096 overview
27C4096 is a component documented by Advanced Micro Devices. The PDF description identifies it as "4 Megabit (256 K x 16-Bit) CMOS EPROM." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Advanced Micro Devices
- Part number: 27C4096
- Category: Memory
- Datasheet length: 12 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- It is organized as 256 Kwords, operates from a single +5 V supply, has a static standby mode, and features fast single address location programming.
- Data can be typically accessed in less than 90 ns, al- lowing high-performance microprocessors to operate without any WAIT states.
- Typical power consumption is only 125 mW in active mode, and 125 µW in standby mode.
- The device supports AMD’s Flashrite programming algorithm (100 µs pulses), re- sulting in a typical programming time of 32 seconds.
- BLOCK DIAGRAM 11408F-1 A0–A17 Address Inputs CE#/PGM# OE# VCC VSS VPP Data Outputs DQ0–DQ15 Output Buffers Y Gating 4,194,304 Bit Cell Matrix X Decoder Y Decoder Output Enable Chip Enable and Prog Logic Notes: 1.
- PIN DESIGNATIONS A0–A17 = Address Inputs CE# (E#)/ = Chip Enable Input/ PGM#/ (P#) Program Enable Input DQ0–DQ15 = Data Input/Outputs OE# (G#) = Output Enable Input VCC =V CC Supply Voltage VPP = Program Voltage Input VSS = Ground LOGIC SY.
- AM27C4096 -95 D C OPTIONAL PROCESSING Blank = Standard Processing B = Burn-In TEMPERATURE RANGE C = Commercial (0°C to +70°C) I= Industrial (–40°C to +85°C) E = Extended (–55°C to +125°C) PACKAGE TYPE D = 40-Pin Ceramic DIP (CDV040) SPEED.
Topics covered by the datasheet
The document includes sections related to:
- ORDERING INFORMATION
Engineering review checklist
- Confirm supply rails, clock limits, memory size, peripheral mapping and I/O voltage compatibility.
- Check package pinout, boot configuration, programming interface and silicon-revision errata.
- Budget decoupling, thermal margin, startup timing and firmware recovery behavior before release.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the 27C4096 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=27c4096-advanced-micro-devices