X533 CONNOR-WINFIELD | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. P R O D U C T D A T A S H E E T Specifications subject to change without notice. DATA SHEET #: REV: DATE: PAGE OF Copyright 2001 Connor-Winfield all rights reserved. a CRYSTAL CONTROLLED OSCILLATORS The Connor-Winfield X533 is a 3.3V Crystal Controlled Oscillator (XO) with LVDS Differential outputs. The X533 is designed for use with PLL systems requiring tight frequency stability vs. temperature. The use of multiplication is utilized in this oscillator design. X533 - 333.00MHz LVDS CLOCK SERIES CENTER FREQUENCY
FEATURES
DESCRIPTION
ORDERING INFORMATION
3.3V OPERATION LOW JITTER <3pS RMS TOTAL FREQUENCY TOLERANCE: ±100ppm TEMPERATURE RANGE: 0 to 85°C DIFFERENTIAL LVDS OUTPUTS SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING RoHS COMPLIANT / LEAD FREE 3.3V SURFACE MOUNT 5.0 x 7.5mm LVDS CLOCK OSCILLATOR X533 DS019 11/07/05 www.conwin.com ABSOLUTE MAXIMUM RATINGS TABLE 1.0 PARAMETER UNITS MINIMUM NOMINAL MAXIMUM UNITS NOTE Storage Temperature -40 100 Supply Voltage (Vcc) -0.5 7.0 Vdc OPERATING SPECIFICATIONS TABLE 2.0 PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE Center Frequency (Fo) 100 400 MHz Total Frequency Tolerance -100 100 ppm Operating Temperature Range Supply Voltage (Vcc) 3.135 3.3 3.465 Vdc Supply Current (Icc) mA Jitter (BW=10Hz to 20MHz) ps rms Jitter (BW=12kHz to 80MHz) ps rms SSB Phase Noise at 10Hz offset -75 dBc/Hz SSB Phase Noise at 100Hz offset -95 dBc/Hz SSB Phase Noise at 1KHz offset -110 dBc/Hz SSB Phase Noise at 10KHz offset -125 dBc/Hz SSB Phase Noise at 100KHz offset -120 dBc/Hz INPUT CHARACTERISTICS TABLE 3.0 PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE Enable Input Voltage (Low) (Vil) 0.3Vcc Vdc Disable Input Voltage (High) (Vih) 0.7Vcc Vdc LVDS OUTPUT CHARACTERISTICS TABLE 4.0 PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE LOAD 100 Ohms Output Differential Voltage (Vod) 250 450 mV Duty Cycle at 50% Level Rise / Fall Time 0.6 1.0 nS PACKAGE CHARACTERISTICS TABLE 5.0 Package Hermetically sealed ceramic package with grounded m etal cover. PROCESS RECOMMENDATIONS TABLE 6.0 Solder Reflow SMD product suitable for Convection Reflow soldering. Peak temperature 260°C. Maximum time above 220°C, 60 seconds. Notes 1.0 Inclusive of calibration @ 25°C, frequency stabili ty vs. temperature, control voltage (Vc) = 1.65 Vdc and aging for ten years. 2.0 When oscillator is disabled both output are in a high impedance state (Tri-State) 3.0 Vod measured with 100 ohm resistor between the true output and the com plementary output. X533M2 333M
THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. P R O D U C T D A T A S H E E T Specifications subject to change without notice. DATA SHEET #: REV: DATE: PAGE OF Copyright 2001 Connor-Winfield all rights reserved. a CRYSTAL CONTROLLED OSCILLATORS DS019 11/07/05 www.conwin.com E/D N/C Dimensional Tolerance: ±.005 (.127mm) 100 ohm 100 ohm Vod Vod Q Q Timing Chart Pin Function N/C Enable / Disable Ground (Case) Output Q Comp Output Q Vcc X533 M2 333M 120°C 150°C 180°C 260°C 220°C 360 Sec. Max. 120 S Max. 10 S 60 S Max. Time Temperature 260°C Solder Profile Suggested Pad Layout Test Curcuit Package Outline and Dimensions Pin Connections