TVHB546 CONNOR-WINFIELD | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. HTTP://WWW.CONWIN.COM P R O D U C T D A T A S H E E T CRYSTAL CONTROLLED OSCILLATORS The Connor-Winfield TVHB546 is a 5.0V HCMOS, surface mount, Voltage Controlled Temperature Compensated Crystal Oscillator (VCTCXO). The TVHB546 is designed for applications requiring very tight frequency stability vs. Temperature. The TVHB546 is offered in a surface mount package for automated assembly. TVHB546 - 16.384MHz ECL SERIES CENTER FREQUENCY
FEATURES
DESCRIPTION
ORDERING INFORMATION
5.0V OPERATION LOW JITTER <1pS RMS OVERALL FREQUENCY STABILITY: ±4.6ppm TEMPERATURE RANGE: 0 to 70°C SURFACE MOUNT PACKAGE TAPE AND REEL PACKAGING SURFACE MOUNT 5.0V HCMOS VCTCXO Tx067 1/14/03 CW 0107 TVHB546 16.384M Specifications subject to change without notice. DATA SHEET #: REV: DATE: PAGE OF Copyright 2001 Connor-Winfield all rights reserved. a TVHB546 ABSOLUTE MAXIMUM RATINGS TABLE 1.0 PARAMETER UNITS MINIMUM NOMINAL MAXIMUM UNITS NOTE Storage Temperature -40 Supply Voltage (Vcc) -0.5 Vdc Control Voltage (Vc) -0.5 Vdc OPERATING SPECIFICATIONS TABLE 2.0 PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE Frequency Range (Fo) 12.8 100.0 MHz Total Frequency Tolerance -4.6 4.6 ppm Operating Temperature Range Supply Voltage (Vcc) 4.75 5.0 5.25 Vdc Supply Current (Icc) mA Jitter (BW=10Hz to 20MHz) ps rms Jitter (BW=12kHz to 20MHz) ps rms SSB Phase Noise at 10Hz offset -70 dBc/Hz SSB Phase Noise at 100Hz offset -100 dBc/Hz SSB Phase Noise at 1KHz offset -125 dBc/Hz SSB Phase Noise at 10KHz offset -135 dBc/Hz SSB Phase Noise at 100KHz offset -140 dBc/Hz INPUT CHARACTERISTICS TABLE 3.0 PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE Control Voltage (Vc) 0.5 2.5 4.5 Vdc Frequency Adjust Range ±10 ppm Frequency Adjust Linearity -15 Input Impedance 10k Ohm HCMOS OUTPUT CHARACTERISTICS TABLE 4.0 PARAMETER MINIMUM NOMINAL MAXIMUM UNITS NOTE LOAD pF Voltage (High) (Voh) Vcc – 0.5 Vdc (Low) (Vol) 0.5 Vdc Current (High) (Ioh) mA (Low) (Ioh) mA Duty Cycle at 50% of Vcc Rise / Fall Time 10% to 90% nS PROCESS RECOMMENDATIONS TABLE 6.0 Solder Reflow The component solder used internal to this device has a m elting point of 221°C. The peak temperature inside the device should be less than or equal to 220°C for a maximum of 10 seconds Wash Ultrasonic cleaning is not recommended. Note: 1) Inclusive of calibration, frequency vs. temperature stability, supply voltage change, load change, shock and vibration and aging for 10 years. 2) Positive Slope. PACKAGE CHARACTERISTICS TABLE 5.0 Package Non-hermetic package consisting of an FR4 substrat e with grounded metal cover.
THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 851-5040. PHONE (630) 851-4722. HTTP://WWW.CONWIN.COM P R O D U C T D A T A S H E E T Specifications subject to change without notice. DATA SHEET #: REV: DATE: PAGE OF Copyright 2001 Connor-Winfield all rights reserved. a CRYSTAL CONTROLLED OSCILLATORS Dimensional Tolerance: ±.005 (.127mm)