TRAP RFSOLUTIONS | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 8
Technical content
- Open the enclosure by removing fixing screws from the enclosure 2. Remove the antenna and slide out the circuit board. 3. Connect the power supply screw terminals 12-32V ac or dc to the supply terminals. 4. Wire your desired connections to the relay switches 5. Once all required wiring is complete, use the handheld QUANTA transmitter to switch the outputs on and off. 6. As supplied, the handheld will operate the outputs - button 1 to output 1, button 2 to output 2 etc. 7. Change the output functions to latching, / Momentary Operation. COM NO NC Relay Connections when Transm itter NOT Operating COM NO NC Relay Connections when Transm itter OPERA TING Relay Relay Relay LOAD 12V 12V COM NO NC Supply Terminals TRAP-RX
Our Range Testing was conducted on Ditchling Beacon providing an open Line of Sight Test. 1. Receiver was mounted on the Bonnet of our vehicle in the Beacon Car park 2. The transmitter was carried along the beacon whilst being repeatedly operated. At full distance the Trans- mitter was also tested while placed on the ground. The transmitter was operated for long and short bursts. 3. 2KM range was achieved, the system was working 100% however testing ceased as we ran out of land. 4. Weather Conditions 5. Warm, Dry, Sunny, Broken Cloud, 20degC Range Test Notes Ditchling Beacon
50.00 59.00 46.00 82.00 10.00 All Dimensions in mm