TFS326A

TFS326A_06 VECTRON | Alldatasheet

Document overview

• Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
• PDF pages: 5

Technical content

Filename: tfs 326a.doc Version 1.9 13.10.2006 VI TELEFILTER Filter specification TFS 326A 1/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com Measurement condition Ambient temperature: 23 °C Input power level: 0 dBm Terminating impedance: * Input: 237 Ω || -0,30 pF Output: 237 Ω || -0,30 pF Characteristics Remark: The reference lev el for the relative attenuation arel of the TFS 326A is the mini mum of the pass band attenuation a min. The minimum of the pass band attenuation amin is defined as the insertion loss a e. The centre frequency fc is the arithmetic mean value of the upper and low er frequencies at the 3 dB filter attenuation level relative to the insertion loss a e. The nominal frequency fN is fixed at 326,4 MHz without any tolerance. The given values for both the relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc. D a t a typ. value tolerance / limit Insertion loss ae 2,6 dB max. 4,5 dB (reference level) Nominal frequency fN - 326,4 MHz Centre frequency fC 326,4 MHz - Passband PB - fN ± 2,50 MHz Pass band ripple 0,6 dB max. 0,8 dB Bandwidth BW 3 dB 17,5 MHz min. 14,0 MHz Relative attenuation arel fN … . fN ± 2,5 MHz 0,6 dB max. 0,8 dB fN ± 2,5 MHz ... fN ± 7,0 MHz 2,0 dB max. 3,0 dB fN + 12,5 MHz … fN + 13,28 MHz 24 dB min. 11 dB fN + 13,28 MHz … fN + 14,85 MHz 19 dB min. 15 dB fN + 14,85 MHz … fN + 18,9 MHz 15 dB min. 13 dB fN + 18,9 MHz … fN + 40,0 MHz 18 dB min. 15 dB fN - 12,5 MHz … fN – 13,75 MHz 14 dB min. 11 dB fN - 13,75 MHz … fN – 30,0 MHz 18 dB min. 15 dB fN - 30,0 MHz … fN – 316,4 MHz 27 dB min. 25 dB fN + 40,0 MHz … fN + 123,6 MHz 52 dB min. 25 dB Group delay ripple within PB 21 ns max 40,0 ns Group delay ripple within ± 7,0 MHz 58 ns max. 100,0 ns Return loss within PB 13,5 dB min. 12,0 dB Return loss within ± 7,0 MHz 12 dB min. 8,0 dB Input power level - max. 15,0 dBm Operating temperature range OTR - - 10 °C ... + 80°C Storage temperature range - - 40 °C ... + 85°C Temperature coefficient of frequency TCf * - 73 ppm/K *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. ) peaks with 20 dBm allowed for 1:100 duty cycle *) ∆fc(Hz) = Tcf(ppm/K) x (T - To) x fCAT (MHz). Generated: Checked / Approved: assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information. VI TELEFILTER reserves the right to make changes to the produc t(s) and/or information contained herein w ithout notice. No liab ility is

Filename: tfs 326a.doc Version 1.9 13.10.2006 VI TELEFILTER Filter specification TFS 326A 2/5 VI TELEFILTER Vectron International, Inc. Potsdamer Straße 18 267 Lowell Road D 14 513 TELTOW / Germany Hudson, NH 03051 / USA Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: tft@telefilter.com E-Mail: vti@vtinh.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is Filter characteristic 100 200 300 400 500 600 -100 -90 -80 -70 -60 -50 -40 -30 -20 -10 frequency in MHz magnitude in dB 315 320 325 330 335 -4.5 -3.5 -2.5 -1.5 -0.5 frequency in MHz magnitude in dB 315 320 325 330 335 0.02 0.04 0.06 0.08 0.1 0.12 0.14 0.16 0.18 Construction and pin connection (All dimensions in mm) 7 5 1,8 Max. 2,54 0,1 1,1 1,1 120° 0,64 5 -0,10 +0,15 Date code Date code: Year + week U 2006 V 2007 W 2008 ...

1 Ground

2 Ground

3 Output

4 Ground

5 Ground

6 Ground

7 Input

8 Ground

• U41 50 Ω Test circuit SAW 1, 2, 4, 5, 6, 8 3 7 assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs 326a.doc Version 1.9 13.10.2006 VI TELEFILTER Filter specification TFS 326A 3/5 VI TELEFILTER Vectron International, Inc. Potsdamer Straße 18 267 Lowell Road D 14 513 TELTOW / Germany Hudson, NH 03051 / USA Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: tft@telefilter.com E-Mail: vti@vtinh.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N 4. Resistance to solder heat (reflow): reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: 3000 reel of empty components at start: min. 300 mm reel of empty components at start including leader: min. 500 mm trailer: min. 300 mm G Do W Ct F E G Po Bo Ao Pull Off Direction PIN MarkerTyp Date Code Ko t Tape (all dimensions in mm) W : 12,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,1 F : 5,50 ± 0,05 G(min) : 0,75 P2 : 2,00 ± 0,05 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,30 ± 0,1 Bo : 5,30 ± 0,1 Ct : 9,5 ± 0,1 A C N W 1 W 2 Reel (all dimensions in mm) A : 330 W1 : 12,4 +2/-0 W2(max) : 18,4 N(min) : 50 C : 13,0 +0,5/-0,2 The minimum bending radius is 45 mm. assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs 326a.doc Version 1.9 13.10.2006 VI TELEFILTER Filter specification TFS 326A 4/5 VI TELEFILTER Vectron International, Inc. Potsdamer Straße 18 267 Lowell Road D 14 513 TELTOW / Germany Hudson, NH 03051 / USA Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: tft@telefilter.com E-Mail: vti@vtinh.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is Air reflow temperature conditions Conditions Exposure Average ramp-up rate (30°C to 217°C) less than 3°C/second > 100°C between 300 and 600 seconds > 150°C between 240 and 500 seconds > 217°C between 30 and 150 seconds Peak temperature max. 260°C Time within 5°C of actual peak temperature between 10 and 30 seconds Cool-down rate (Peak to 50°C) less than 6°C/second Time from 30°C to Peak temperature no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C Time / s max. 300 s 10 ... 30 s 30 ... 150 s assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs 326a.doc Version 1.9 13.10.2006 VI TELEFILTER Filter specification TFS 326A 5/5 VI TELEFILTER Vectron International, Inc. Potsdamer Straße 18 267 Lowell Road D 14 513 TELTOW / Germany Hudson, NH 03051 / USA Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 Tel: (603) 598-0070 Fax: (603) 598-0075 E-Mail: tft@telefilter.com E-Mail: vti@vtinh.com VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is History Version Reason of Changes Name Date 1.0 - generate according customer requirement specification Dr. Sabah 10.08.2000 1.2 - Return loss within: ± 2,50 MHz Max. 10 dB - Return loss within: ± 7,50 MHz Max. 6,5 dB Dr. Sabah 31.08.2000 1.3 - Pin connection changed : pin 9 input; pin 3 output Dr. Sabah 31.08.2000 1.4 - Add preliminary values for terminating impedance Dr. Sabah 11.10.2000 1.5 - changing of 3dB bandwidth to ± 7,0 MHz Dr. Sabah 06.11.2000 - changing of package to 5X5 1.6 - changing of Return loss to –12dB (within: ± 2,50 MHz) - changing of stopband between: 342,5 MHz .. 344,5 MHz to – 13 dB - changing of –15 dB stopband to fn –13,75 MHz - changing of group delay ripple within : ± 2,50 MHz to 40 ns - changing of group delay ripple within : ± 7,0 MHz to 100 ns Dr. S. Sabah 28.02.2001 1.7 - changing of relative attenation between: fn –15,6 MHz to fn +18,60 MHz - changing of filter name to TFS326A - changing of input power specification - changing of matching circuit Dr. S. Sabah 15.03.2001 1.8 - with customer agreed modification of stopband attenuation - fN + 14,85 MHz...fN + 18,9 MHz to min. 13,0 dB 1.9 - add typ. value and filter characteristic Strehl 13.10.2006 assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.