TFS220F

TFS220F VECTRON | Alldatasheet

Document overview

• Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
• PDF pages: 5

Technical content

Filename: tfs220f.doc Version 1.1 03.11.2003 VI TELEFILTER Filter Specification TFS220F 1/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com Measurement condition Ambient temperature: 23 °C Input power level: 0 dBm Terminating impedance: * Input: 680 -1,75 pF Output: 680 -1,75 pF Characteristics Remark: Reference level for the relative attenuation a rel of the TFS220F is the minimum of the pass band attenuation a min. The minimum of the pass band attenuation a min is defined as the insertion loss a e. The centre frequency f c is the arithmetic mean value of the upper and lower frequencies at the 2 dB filter attenuation level relative to the insertion loss a e. The nominal frequencyf N is fixed at 220 MHz without tolerance. The given values for the relative attenuation a rel and for the group delay ripple have to be reached at the frequencies given belowevenif the centre frequency f c is shifted due to the temperature coefficient of frequency TC f in the operating temperature range and due to a production tolerance for the centre frequency f c. D a t a Typ. Value Tolerance / Limit Insertion Loss ae - max. 5,2dB (reference level) Nominal Frequency fN - 220 MHz Centre Frequency fC 220,015MHz - Bandwidth B W 2dB 187 kHz min. 100 kHz Relative Attenuation Arel fN ...f N ± 50kHz 1 dB max. 2 dB fN ± 0,5MHz...f N ± 1MHz 41 dB min. 10 dB fN ± 1MHz...f N ± 5MHz 46 dB min. 20 dB fN ± 5MHz...f N ± 200MHz 56 dB min. 40 dB Operating Temperature Range OTR - - 45 °C ... + 75 °C Storage Temperature Range - - 40 °C ... + 85 °C Frequency Inversion Temperature 15 °C - Temperature Coefficient of Frequency TCf ** -0,036ppm/K ² - Input Power Level - max. 10 dBm *) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. **) f(Hz) = TCf(ppm/K) x (T-T0)² x fTo(MHz). Generated : Checked / approved : VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs220f.doc Version 1.1 03.11.2003 VI TELEFILTER Filter Specification TFS220F 2/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com Construction, pin configuration and 50 - matching network (Alldimensionsinmm) 2,54+-0,2 S 220 F R24 2 Max. 2,54 +-0,2 5,2 Max. 7,2 Max. 0,8

1 Input

2 Input RF Return

3 Ground

4 Ground

5 Package Ground

6 Ground

7 Output

8 Output RF Return

9 Ground

10 Ground

12 Ground

Datecode: Year+week N 2001 P 2002 R 2003 ...

50 Ohm Test circuit 1

50 Ohm 50 Ohm

50 Ohm Test circuit 2

VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs220f.doc Version 1.1 03.11.2003 VI TELEFILTER Filter Specification TFS220F 3/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com Stability characteristics After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 18 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N 4. Resistance to solder heat (reflow): reflow possible: twice max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; Packing Tape & Reel: IEC 286 – 3, with exeption of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters peer reel: 3000 reel of empty components at start: min. 300 mm reel of empty components at start including leader: min. 500 mm trailer: min. 300 mm Do Po E F W EMBOSSED CARRIERTAPE COVER TAPE G P 2 Bo Ao ± 0,1 D 1 13,4 Tape (all dimensions in mm) W : 16,00 ± 0,3 Po : 4,00 ± 0,1 Do : 1,50+0,1/-0 E : 1,75 ± 0,1 F : 7,50 ± 0,1 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 8,00 ± 0,1 D1(min) : 1,50 Ao : 5,50 ± 0,1 Bo : 7,50 ± 0,1 Ct : 13,5 ± 0,1 Reel (all dimensions in mm) A : 330 W1 : 16,4+2/-0 W2(max) : 22,4 N(min) : 50 C : 13,0+0,5/-0,2 A C N W 1 W 2 The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape. Marking of the filters can be read if the upper side of the carrier tape is regarded with the sprocket holes on its right. VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs220f.doc Version 1.1 03.11.2003 VI TELEFILTER Filter Specification TFS220F 4/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com Air reflow temperature conditions 1st and 2nd air reflow profile Name: pre-heatingperiodsmain-heating periods peak temperature Temperature: 150 °C - 170 °C over 200 °C 255 °C ± 5 °C Time: 60 sec. - 90 sec. 20 sec. - 25 sec. Chip-mount air reflow profile time / sec. temperature / °C 100 120 140 160 180 200 220 240 260 0 20 40 60 80100120140160180200220240 Table for temperature vs. time during the air reflow process Tolerance of temperatures: ± 5 °C time / sec. temperature / °C time / sec. temperature / °C 0 23 140 160 10 34 150 161 20 46 160 164 30 60 170 170 40 80 180 180 50 103 190 205 60 121 195 230 70 134 200 255 80 143 205 230 90 150 210 205 100 154 215 180 110 156 220 165 120 158 230 140 130 159 240 120 VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs220f.doc Version 1.1 03.11.2003 VI TELEFILTER Filter Specification TFS220F 5/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@telefilter.com History Version Reason of Changes Name Date 1.1 -Change from development specification to filter specification Dr. Wall 03.11.2003 - Add termination impedances and typical values. VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.