TFS140AM

DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM

Document overview

• Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
• PDF pages: 5

Technical content

Filename: tfs 140am.doc Version 1.5 25.02.2008 VI TELEFILTER Filter specification TFS 140AM 1/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@vectron.com Measurement condition Ambient temperature: 25 °C Input power level: 0 dBm Terminating impedance: * Input: 143 Ω || -26 pF Output: 144 Ω || -29 pF Characteristics Remark: The reference level for the relativ e attenuation arel of the TFS 140AM is the minimum of the pass band att enuation. This value is defined as the insertion loss ae. The nominal frequency fN is fixed at 140 MHz without any tolerance. The values of relative attenuation arel are guaranteed for the whole operating temperature range. The frequency shift of the filter in the operating temperature range is included in the production tolerance scheme. D a t a typ. value tolerance / limit Insertion loss ae 8,5 dB max. 11 dB (reference level) Nominal frequency fN 140,0 MHz Passband PB 23,9 MHz fN ± 10,25 MHz Passband ripple 0,3 dB max. 1,4 MHz Passband ripple over any 10 kHz segment 0,02 dB max. 0,2 MHz Relative attenuation arel fN - 10,25 MHz … fN + 10,25 MHz 0,3 dB max. 1,4 dB fN - 100,0 MHz … fN - 17,3 MHz 42 dB min. 40 dB fN - 17,3 MHz … fN - 15,3 MHz 33 dB min. 30 dB fN ± 14,0 MHz 28 dB fN + 16,3 MHz … fN + 18,3 MHz 39 dB min. 30 dB fN + 18,3 MHz … fN + 80,0 MHz 42 dB min. 40 dB fN + 80,0 MHz … fN + 110,0 MHz 58 dB min. 50 dB fN + 110,0 MHz … fN + 130,0 MHz 58 dB min. 35 dB fN + 130,0 MHz … fN + 210,0 MHz 40 dB min. 40 dB Absolute group delay 0,8 µs max. 1,5 µs Group delay ripple within PB 55 ns max. 100 ns Phase linearity within PB 3) p-p 5 deg max. 15 deg Triple transit response suppression 40 dB min. 35 dB VSWR 1,5:1 max. 2 : 1 Input power level max. + 17 dBm Operating temperature range OTR - 40 °C ... + 85 °C Storage temperature range - 40 °C ... + 85 °C Temperature coefficient of frequency TCf -90 ppm/K - The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team. @ 25 °C over 90% of actual 1dB bandwidth ∆f(Hz) = TCf(ppm/K) x (T-T0) x fTo(MHz) Generated: Checked / Approved: VI TELEFILTER reserves the right to make changes to the produc t(s) and/or information contained herein w ithout notice. No liab ility is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs 140am.doc Version 1.5 25.02.2008 VI TELEFILTER Filter specification TFS 140AM 2/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@vectron.com Filter characteristic 100 108 116 124 132 140 148 156 164 172 180-60 -54 -48 -42 -36 -30 -24 -18 -12 frequency in MHz magnitude in dB 130 132 134 136 138 140 142 144 146 148 150-10 frequency in MHz magnitude in dB 130 132 134 136 138 140 142 144 146 148 150 0.685 0.76 0.835 0.91 0.985 1.06 1.135 1.21 1.285 1.36 1.435 frequency in MHz delay in µs Construction and pin connection (All dimensions in mm) 13,6Max. 6,8Max. 2,0Max. 8910 1,5 2,54 ±0,15 2,54 ±0,15 0,8 0,1 1 2 3 4 Date code Date code: Year + week V 2007 W 2008 X 2009 ...

1 Ground

2 Ground

3 Ground

4 Ground

5 Output

6 Output RF Return

7 Ground

8 Ground

9 Ground

10 Ground

11 Input

12 Input RF Return

• W09

50 Ohm Test circuit

VI TELEFILTER reserves the right to make changes to the produc t(s) and/or information contained herein w ithout notice. No liab ility is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs 140am.doc Version 1.5 25.02.2008 VI TELEFILTER Filter specification TFS 140AM 3/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@vectron.com Stability characteristics, reliability After the following tests the filter shall meet the whole specification: 1. Shock: 500g, 1 ms, half sine wave, 3 shocks each plane; DIN IEC 68 T2 - 27 2. Vibration: 10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans; DIN IEC 68 T2 - 6 3. Change of temperature: -55 °C to 125°C / 30 min. each / 10 cycles DIN IEC 68 part 2 – 14 Test N 4. Resistance to solder heat (reflow): reflow possible: three times max.; for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4; This filter is RoHS compliant (2002/95/EG, 2005/618/EG) Packing Tape & Reel: IEC 286 – 3, with exception of value for N and minimum bending radius; tape type II, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: <MAXPIECESPERREEL> reel of empty components at start: min. 300 mm reel of empty components at start including leader: min. 500 mm trailer: min. 300 mm G Do W Ct F E G Po Bo Ao Pull Off Direction PIN MarkerTyp Date Code Ko t Tape (all dimensions in mm) Po : 4,00 ± 0,1 Do : 1,50 +0,1/-0 E : 1,75 ± 0,10 F : 11,50 ± 0,10 G(min) : 0,60 P2 : 2,00 ± 0,1 P1 : 12,00 ± 0,1 D1(min) : 1,50 Ao : 7,10 ± 0,10 Bo : 13,90 ± 0,10 Ct : 21,5 ± 0,1 A C N W 1 W 2 Reel (all dimensions in mm) A : 330 W1 : 24,4 +2/-0 W2(max) : 30,4 N(min) : 60 C : 13,0 +0,5/-0,2 The minimum bending radius is 45 mm. Air reflow temperature conditions Conditions Exposure Average ramp-up rate (30°C to 217°C) less than 3°C/second > 100°C between 300 and 600 seconds VI TELEFILTER reserves the right to make changes to the produc t(s) and/or information contained herein w ithout notice. No liab ility is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs 140am.doc Version 1.5 25.02.2008 VI TELEFILTER Filter specification TFS 140AM 4/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@vectron.com > 150°C between 240 and 500 seconds > 217°C between 30 and 150 seconds Peak temperature max. 260°C Time within 5°C of actual peak temperature between 10 and 30 seconds Cool-down rate (Peak to 50°C) less than 6°C/second Time from 30°C to Peak temperature no greater than 300 seconds Chip-mount air reflow profile Temperature / °C max. 260°C 217°C Time / s max. 300 s 10 ... 30 s 30 ... 150 s VI TELEFILTER reserves the right to make changes to the produc t(s) and/or information contained herein w ithout notice. No liab ility is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.

Filename: tfs 140am.doc Version 1.5 25.02.2008 VI TELEFILTER Filter specification TFS 140AM 5/5 Tele Filter GmbH Potsdamer Straße 18 D 14 513 TELTOW / Germany Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30 E-Mail: tft@vectron.com History Version Reason of Changes Name Date 1.0 - Generation of development specification Alawneh 05.05.2006 1.1 - Change data Strehl 15.06.2006 1.2 - Introduced relative attenuation at fn +/- 14 MHz Chilla 03.08.2006 1.3 - Changed insertion loss Chilla 10.05.2006 - Changed relative attenuation - Changed absolute group delay - Changed input power - Added comment for rejection at fn+/-14MHz - Added comment for phase ripple - Changed packing 1.4 - Created filter specification Chilla 17.08.2007 - Added terminating impedances - Added typical values - Added filter characteristic - Added test circuit - attenuation limit at fN +/-14 MHz removed 1.5 - changed relative attenuation at fN+110 MHz … f N+130 MHz Chilla 25.02.2008 VI TELEFILTER reserves the right to make changes to the produc t(s) and/or information contained herein w ithout notice. No liab ility is assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.