TEP0006 | DigiCamel IC Datasheet

Online Datasheet

Read TEP0006 online.

TEP0006 TRENZ | Alldatasheet

Document overview

Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
PDF pages: 17

Technical content

Online version of this document: https://wiki.trenz-electronic.de/display/PD/TEP0006+TRM TEP0006 TRM Revision v.24 Exported on 2019-11-07

1 Table of Contents

2 Table of Figures

3 Table of Tables

4 Overview

The Trenz Electronic TEP0006 is an Ultra96 LS Expansion to Pmod adapter. Refer to http://trenz.org/tep0006-info for the current online version of this manual and other available documentation.

4.1 Key Features

On Board: 4x Voltage Level Translators 2x Voltage Regulators Interface: 1x Ultra96 LS Expansion Header (40 Pins) 3x Pmod Connectors 3x Jumpers Power: VCC_PSAUX Dimension: 85 mm x 17 mm

4.2 Block Diagram

4.3 Main Components

Figure 2: TEP0006 Main Components

Copyright © 2019 Trenz Electronic GmbH 8 of 17 http://www.trenz-electronic.de 10. 11. 12. PMod 2x6 Host Socke (PMOD 2) ,J2 PMod 2x6 Host Socke (PMOD 2) ,J1 Level Translator (HP_GPIO[0..7]) ,U1 Level Translator (HP_GPIO[8..15]),U3 Level Translator PMOD(SPI),U6 Linear Voltage Regulator,U2 Jumper,J6-J7 PMod 2x6 Host Socke (SPI),J4 GROVE,J5 Level Translator (GROVE) ,U5 Jumper (Voltage select ),J10 Ultra96 LS Expansion Header (40 Pos),J3

4.4 Initial Delivery State

Storage device name Content Notes --- --- --- Table 1: Initial delivery state of programmable devices on the module

4.5 Configuration Signals

5 Signals, Interfaces and Pins

5.1 Low Speed Expansion Connector

The SMD Header J3 has 40 pin (20x2) and it is compatible with Ultra96 LS Expansion Connector. You can find General information about the LS Expansion connector in the following table. Schematic Connected to Notes MIO38, MIO41...43 Level Translator PMOD(SPI) SPI VCC_PSAUX Level Translator, U1-U3-U5-U6 Voltage Regulator, U2 1.8 V nPOK 5V Voltage Regulator, U2 Jumper, J10 Vin Pull up Voltage Table 2: Ultra96 LS Expansion information

5.2 Pmod Connectors

The TEP0006 is equipped with three Pmod connectors. Pmod Connectors are the expanded outputs from Ultra96 Board. Pin Connected to Notes Pmod 1, J1 Pmod 2, J2 Pmod SPI,

1 PMOD_HD-

PMOD_HD-GPIO8 SS

2 PMOD_HD-

PMOD_HD-GPIO9 MOSI

3 PMOD_HD-

PMOD_HD-GPIO10 MISO

4 PMOD_HD-

PMOD_HD-GPIO11 SCK

5 GND GND GND

6 3.3 V 3.3 V 3.3 V

7 PMOD_HD-

PMOD_HD-GPIO12 INIT

8 PMOD_HD-

PMOD_HD-GPIO13 RESET

9 PMOD_HD-

PMOD_HD-GPIO14 Not Connected

10 PMOD_HD-

PMOD_HD-GPIO15 Not Connected

11 GND GND GND

12 3.3 V 3.3 V 3.3 V Table 3: Pmod Connectors information

5.3 Jumpers

J6 HD_GPI O_15 Level Translator U3 and U5 If you install the jumper HD_GPIO_15 will be driven through Level Translator (U5) and Grove (J5) otherwise it goes to Level Translator (U3). J7 HD_GPI O_11 Level Translator U3 and U5 If you put the jumper HD_GPIO_11 will be driven through Level Translator (U5) and Grove (J5) otherwise it goes to Level Translator (U3). J10 Voltage select 5 V, 3.3 V Pull up Voltage Table 4: Pmod Connectors information

7 Power and Power-On Sequence

7.1 Power Supply

Power is supplied by Ultra96 Board through SMD Header J3.

7.2 Power Consumption

Power Input Pin Typical Current 5V TBD VCC_PSAUX TBD Table 6: Power Consumption * TBD - To Be Determined

7.3 Power Distribution Dependencies

Figure 3: Power Distribution

7.4 Power-On Sequence

There is no specific power on sequence, after power on the Ultra96 Board all electrical components on TEP0006 will be enabled.

7.5 Power Rails

Power Rail Name LS Expansion Connector Pin Direction Notes +5V 37 Input Supplied by Ultra96

Copyright © 2019 Trenz Electronic GmbH 13 of 17 http://www.trenz-electronic.de Power Rail Name LS Expansion Connector Pin Direction Notes VCC_PSAUX 35 Input Supplied by Ultra96 Table 7: Module power rails.

7.6 Technical Specifications

7.7 Absolute Maximum Ratings

Symbols Description Min Max Unit T_STG Storage Temperature -55 150 °C Table 8: PS absolute maximum ratings

7.8 Recommended Operating Conditions

Operating temperature range depends also on customer design and cooling solution. Please contact us for options. Parameter Min Max Units Reference Document T_OPT -40 +85 °C Table 9: Recommended operating conditions.

7.9 Physical Dimensions

Module size: 85 mm × 17 mm. Please download the assembly diagram for exact numbers. PCB thickness: 1.6 mm. Figure 4: Physical Dimension

8 Currently Offered Variants

Trenz shop TEP0006 overview page English page1 German page2 Table 10: Trenz Electronic Shop Overview

Copyright © 2019 Trenz Electronic GmbH 15 of 17 http://www.trenz-electronic.de 3 https://shop.trenz-electronic.de/Download/?path=Trenz_Electronic/Pmods/TEP0006/REV01 4 https://wiki.trenz-electronic.de/display/~j.hartfiel 5 https://wiki.trenz-electronic.de/display/~P.Babakhani 6 https://wiki.trenz-electronic.de/display/~j.hartfiel

9 Revision History

9.1 Hardware Revision History

Date Revision Changes Documentation Link 2019-07-19 01 Initial Release REV013 Table 11: Hardware Revision History Hardware revision number can be found on the PCB board together with the module model number separated by the dash. Figure 5: Board hardware revision number.

9.2 Document Change History

Date Revision Contributor Description| 2019-11-07 v.24(see page 6) John Hartfiel4 Initial release -- all Pedram Babakhani5 , John Hartfiel6 -- Table 12: Document change history.

10 Disclaimer

10.1 Data Privacy

Please also note our data protection declaration at https://www.trenz-electronic.de/en/Data-protection-Privacy

10.2 Document Warranty

The material contained in this document is provided “as is” and is subject to being changed at any time without notice. Trenz Electronic does not warrant the accuracy and completeness of the materials in this document. Further, to the maximum extent permitted by applicable law, Trenz Electronic disclaims all warranties, either express or implied, with regard to this document and any information contained herein, including but not limited to the implied warranties of merchantability, fitness for a particular purpose or non infringement of intellectual property. Trenz Electronic shall not be liable for errors or for incidental or consequential damages in connection with the furnishing, use, or performance of this document or of any information contained herein.

10.3 Limitation of Liability

In no event will Trenz Electronic, its suppliers, or other third parties mentioned in this document be liable for any damages whatsoever (including, without limitation, those resulting from lost profits, lost data or business interruption) arising out of the use, inability to use, or the results of use of this document, any documents linked to this document, or the materials or information contained at any or all such documents. If your use of the materials or information from this document results in the need for servicing, repair or correction of equipment or data, you assume all costs thereof.

10.4 Copyright Notice

No part of this manual may be reproduced in any form or by any means (including electronic storage and retrieval or translation into a foreign language) without prior agreement and written consent from Trenz Electronic.

10.5 Technology Licenses

The hardware / firmware / software described in this document are furnished under a license and may be used / modified / copied only in accordance with the terms of such license.

10.6 Environmental Protection

To confront directly with the responsibility toward the environment, the global community and eventually also oneself. Such a resolution should be integral part not only of everybody's life. Also enterprises shall be conscious of their social responsibility and contribute to the preservation of our common living space. That is why Trenz Electronic invests in the protection of our Environment.

10.7 REACH, RoHS and WEEE

7 http://guidance.echa.europa.eu/ 8 https://echa.europa.eu/candidate-list-table 9 http://www.echa.europa.eu/ Copyright © 2019 Trenz Electronic GmbH 17 of 17 http://www.trenz-electronic.de Trenz Electronic is a manufacturer and a distributor of electronic products. It is therefore a so called downstream user in the sense of REACH7. The products we supply to you are solely non-chemical products (goods). Moreover and under normal and reasonably foreseeable circumstances of application, the goods supplied to you shall not release any substance. For that, Trenz Electronic is obliged to neither register nor to provide safety data sheet. According to present knowledge and to best of our knowledge, no SVHC (Substances of Very High Concern) on the Candidate List8 are contained in our products. Furthermore, we will immediately and unsolicited inform our customers in compliance with REACH - Article 33 if any substance present in our goods (above a concentration of 0,1 % weight by weight) will be classified as SVHC by the European Chemicals Agency (ECHA)9. RoHS Trenz Electronic GmbH herewith declares that all its products are developed, manufactured and distributed RoHS compliant. WEEE Information for users within the European Union in accordance with Directive 2002/96/EC of the European Parliament and of the Council of 27 January 2003 on waste electrical and electronic equipment (WEEE). Users of electrical and electronic equipment in private households are required not to dispose of waste electrical and electronic equipment as unsorted municipal waste and to collect such waste electrical and electronic equipment separately. By the 13 August 2005, Member States shall have ensured that systems are set up allowing final holders and distributors to return waste electrical and electronic equipment at least free of charge. Member States shall ensure the availability and accessibility of the necessary collection facilities. Separate collection is the precondition to ensure specific treatment and recycling of waste electrical and electronic equipment and is necessary to achieve the chosen level of protection of human health and the environment in the European Union. Consumers have to actively contribute to the success of such collection and the return of waste electrical and electronic equipment. Presence of hazardous substances in electrical and electronic equipment results in potential effects on the environment and human health. The symbol consisting of the crossed-out wheeled bin indicates separate collection for waste electrical and electronic equipment. Trenz Electronic is registered under WEEE-Reg.-Nr. DE97922676. 2019-06-07

Product Information

TEP0006 specifications and overview.

Summary

TEP0006 is an Ultra96 LS Expansion to Pmod adapter. Revision v.24

Description

TEP0006 is an Ultra96 LS Expansion to Pmod adapter. Revision v.24

Source title TEP0006 Datasheet(PDF) - Trenz Electronic

Related Parts

More parts from the same family.

Browse manufacturer