SMC890 ROITHNER | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 2

Technical content

07.04.2011 SMC890 1 of 2

Invisible LED, SMD AlGaAs SMC890 are AlGaAs LEDs mounted on a ceramic SMD package and sealed with silicone or epoxy resin for damp proof. On forward bias, it emits a radiation of typical 8 mW at a peak wavelength of 890 nm. Specifications

  • Structure: AlGaAs
  • Peak Wavelength: typ. 890 nm
  • Optical Output Power: typ. 8 mW
  • Package: Ceramic SMD, silicon or epoxy resin Absolute Maximum Ratings (Ta=25°C) Item Symbol Value Unit Power Dissipation PD 160 mW Forward Current IF 100 mA Pulse Forward Current *1 I FP 500 mA Reverse Voltage VR 5 V Operating Temperature Topr -30 … +80 °C Storage Temperature Tstg -30 … +80 °C Soldering Temperature *2 T sol 255 °C *1 duty = 1%, pulse width = 10 µs *2 must be completed within 5 seconds (Unit: mm) Electro-Optical Characteristics Item Symbol Condition Min. Typ. Max. Unit Forward Voltage VF I F = 50 mA - 1.45 1.7 V Reverse Current IR V R = 5 V - - 10 µA Total Radiated Power PO I F = 50 mA 4 8 - mW Radiation Intensity IE I F = 50 mA 2 4 - mW/sr Peak Wavelength λP I F = 50 mA - 890 - nm Half Width Δλ I F = 50 mA - 75 - nm Viewing Half Angle Θ1/2 I F = 50 mA - ±55 - deg. Rise Time tr I F = 50 mA - 800 - ns Fall Time tf I F = 50 mA - 400 - ns Radiation Intensity is measured by Tektronix J-6512 Total Radiated Power is measured by Photodyne #500 Notes
  • Do not view directly into the emitting area of the LED during operation!
  • The above specifications are for reference purpose only and subjected to change without prior notice.

07.04.2011 SMC890 2 of 2

Recommended Land Layout (Unit: mm) 1. Soldering Conditions

  • DO NOT apply any stress to the lead particularly when heat.
  • After soldering the LEDs should be protected from mechanical shock or vibration until the LEDs return to room temperature.
  • When it is necessary to clamp the LEDs to prevent soldering failure, it is important to minimize the mechanical stress on the LEDs. Soldering Conditions 2. Static Electricity
  • The LEDs are very sensitive to Static Electricity and surge voltage. So it is recommended that a wrist band or an anti-electrostatic glove be used when handling the LEDs.
  • All devices, equipment and machinery must be grounded properly. It is recommended that precautions should be taken against surge voltage to the equipment that mounts the LEDs.