DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 7

Technical content

FEATURES

❑ Single power supply operation (3.3V to 5.0V) or dual power supply operation (±1.65 to ±2.5V) ❑ Radiation performance - Total dose: >1Mrad(Si); Dose rate = 50 - 300 rads(Si)/s - ELDRS Immune - SEL Immune >100 MeV-cm 2/mg - Neutron Displacement Damage >1014 neutrons/cm2 ❑ High Speed ❑ Rail-to-Rail input and output range ❑ Enable pin to Enable/Disable amplifiers in pairs. ❑ Short Circuit Tolerant ❑ Full military temperature range ❑ Designed for aerospace and high reliability space applications ❑ Packaging – Hermetic ceramic SOIC - 16-pin, .417"L x .300"W x 0.105"Ht SOIC - Typical Weight 0.8 grams RadHard-by-Design GENERAL DESCRIPTION Aeroflex’s RHD5904 is a radiation hardened, single supply, high speed, quad operational amplifier with enable in a 16-pin SOIC package. The RHD5904 design uses specific circuit topology and layout methods to mitigate total ionizing dose effects and single event latchup. These characteristics make the RHD5904 especially suited for the harsh envi ronment encountered in Deep Sp ace missions. It is guaranteed operational from -55°C to +125°C. Available screened in accordance with MIL-PRF-38534 Class K, the RHD5904 is ideal for demanding military and space applications. ORGANIZATION AND APPLICATION The RHD5904 amplifiers are capable of rail-to-rail input and outputs. Performance characteristics listed are for general purpose operational 5V CMOS amplifier applications. The amplifiers will drive substantial resistive or capacitive loads and are unity gain stab le under normal conditions. Resistive loads in the low kohm range can be handled without gain derating an d capacitive loads of several nF can be tolerated. CMOS device drive has a negative temperature coefficient and the devices are therefore inherently tolerant to momentary shorts, although on chip thermal shutdown is not provided. All inputs and outputs are diode protected. The devices will not latch with SEU events to above 100 MeV-cm2/mg. Total dose degradation is minimal to above 1Mrad(Si). Displacement damage environments to neutron fluence equivalents in the mid 10 14 neutrons per cm2 range are readily tolerated. There is no sensitivity to low-dose rate (ELDRS) effects. SEU effects are application dependant. The RHD5904 is configured with en able/disable control. Pairs of am plifiers are put in a power-down condition with their outputs in a high impedance state. Several useful operational amplifier configurations are supported where more than one amplifier can feed an output with others disabled. Standard Products September 26, 2012 www.aeroflex.com/RHDseries RHD5904 Quad Operational Amplifier Instrumentation Amplifier with Enables Advanced

3SCD5904 Rev A Advanced 9/26/12 Aeroflex Plainview ABSOLUTE MAXIMUM RATINGS Parameter Range Units Case Operating Temperature Range -55 to +125 °C Storage Temperature Range -65 to +150 °C Junction Temperature +150 °C Supply Voltage V CC - VEE +6.0 V Input Voltage VCC +0.4 VEE -0.4 V Lead Temperature (soldering, 10 seconds) 300 °C Thermal Resistance, Junction to Case,jc 7 °C/W ESD Rating 2.0 KV Power @ 25°C 200 mW NOTICE: Stresses above those listed under “Absolute Maximums Rating” may cause permanent damage to the device. These are stress rating only; functional operation beyond the “Operation Conditions” is not recommended and extended exposure beyond the “Operation Conditions” may affect device reliability. RECOMMENDED OPERATING CONDITIONS Symbol Parameter Typical Units +VCC Power Supply Voltage 3.3 to 5.0 V VCM Input Common Mode Range V CC to VEE V ELECTRICAL PERFORMANCE CHARACTERISTICS (TC = -55°C TO +125°C, +VCC = +5.0V -- UNLESS OTHERWISE SPECIFIED) Parameter Symbol Conditions Min Typ Max Units Input Offset Voltage V OS -2 2m V Input Offset Current I OS -10 10 pA Input Bias Current I B -20 20 pA Input Offset TempCo 2/V IOST 10 uV/C Common Mode Rejection Ratio CMRR 70 dB Power Supply Rejection Ratio PSRR 70 dB Output Voltage High V OH ROUT = 3.6 Kohms to GND 4.9 V Output Voltage Low V OL ROUT = 3.6 Kohms to VCC 0.1 V Short Circuit Output Current 2/ IO(SINK)V OUT to VCC -63 mA IO(SOURCE)V OUT to VEE 45 mA Slew Rate SR R L = 8K 2.5 V/uS Open Loop Gain 2/A OL No Load 100 dB Unity Gain Bandwidth UGBW R L = 10K 5 MHz

4SCD5904 Rev A Advanced 9/26/12 Aeroflex Plainview Input Voltage - Enable (EN_AB, EN_CD) VHI High (Enabled) 70% VCC - VEE V VLO Low (Disabled) 30% VCC - VEE V Input Current - Enable (EN_AB, EN_CD) IEN 100 nA Quiescent Supply Current I CCQ All Amplifiers Enabled, No Load 5.5 mA All Amplifier Disabled 1 uA Channel Separation 2/R L = 2K, f = 1.0KHz 90 dB Input-Referred Voltage Noise 2/ en F = 1 kHz TBD V/ Phase Margin 2/ m TBD Deg Notes: 1/ Specification derated to reflect Total Dose exposure to 1 Mrad(Si) @ +25°C. 2/ Not tested. Shall be guaranteed by design, characterization, or correlation to other test parameters. SWITCHING CHARACTERISTICS (TC = -55°C TO +125°C, +VCC = +5.0V -- UNLESS OTHERWISE SPECIFIED) Parameter Symbol Conditions Min Max Units Output Delay (Enabled) tONEN 100 ns Output Delay (Disabled) tOFFEN 100 ns ELECTRICAL PERFORMANCE CHARACTERISTICS (continued) (TC = -55°C TO +125°C, +VCC = +5.0V -- UNLESS OTHERWISE SPECIFIED) Parameter Symbol Conditions Min Typ Max Units VCC 50% VCC GND tOFFEN tONEN GND HI Z HI Z (EN_AB or EN_CD) VOUT FIGURE 3: RHD5904 SWITCHING DIAGRAM ENABLES (VOUT_A&B or VOUT_C&D) Hz

5SCD5904 Rev A Advanced 9/26/12 Aeroflex Plainview Inverting Amplifier R3 VOUT VIN +5V +5V Vbias VOUT VIN R2 –= EN Non Inverting Amplifier VOUT VIN R4 R2 +5V +5V Vbias VOUT VIN 1 R2 + EN Note: For VOUT DC @ mid range of common mode voltage range, VBIAS = 2.5/(1+R2/R1), VBIAS = +5*R4/(R3+R4) R1 R2 VOUT VIN Inverting Amplifier VOUT VIN R2 –= -2.5V +2.5V EN VIN VOUT Non Inverting Amplifier VOUT VIN 1 R2 + -2.5V +2.5V EN RHD5904 QUAD OPERATIONAL AMPLIFIER APPLICATION NOTES APPLICATION NOTE 1: DUAL POWER SUPPLY AMPLIFIER APPLICATION NOTE 2: SINGLE POWER SUPPLY AMPLIFIER

6SCD5904 Rev A Advanced 9/26/12 Aeroflex Plainview Differential Input Amplifier R3 VOUT VOUT V2 R4  1 R2  V1 R2 –= EN VEE VCC VOUT Multiple Amplifiers - Selectable Output ENV1 A/B C/D +5V APPLICATION NOTE 3: MULTIPLE AMPLIFIERS Note: Package and lid are electrically isolated from signal pads. FIGURE 4: PACKAGE OUTLINE DIFFERENTIAL INPUT AMPLIFIER APPLICATION NOTE 4:

SCD5904 Rev A Advanced 9/26/12 7 PLAINVIEW, NEW YORK Toll Free: 800-THE-1553 Fax: 516-694-6715 SE AND MID-ATLANTIC Tel: 321-951-4164 Fax: 321-951-4254 INTERNATIONAL Tel: 805-778-9229 Fax: 805-778-1980 WEST COAST Tel: 949-362-2260 Fax: 949-362-2266 NORTHEAST Tel: 603-888-3975 Fax: 603-888-4585 CENTRAL Tel: 719-594-8017 Fax: 719-594-8468 www.aeroflex.com info-ams@aeroflex.com Aeroflex Microelectronic Solutions reserves the right to change at any time without notice the specifications, design, function, or form of its products described herein. All parameters must be validated for each customer's application by engineering. No liability is assumed as a result of use of this product. No patent licenses are implied. Our passion for performance is defined by three attributes represented by these three icons: solution-minded, performance-driven and customer-focused EXPORT CONTROL: EXPORT WARNING: This product is controlled for expor t under the International Traffic in Arms Regulations (ITAR). A license from the U.S. Department of State is required prior to the export of this product from the United States. Aeroflex’s military and space products are controlled for export under the International Traffic in Arms Regulations (ITAR) and may not be sold or proposed or offered for sale to certain countries. (See ITAR 126.1 for complete information.)

ORDERING INFORMATION

Model DSCC SMD # Screening Package RHD5904-7 - Commercial Flow, +25°C testing only 16-pin RHD5904-S - Military Temperature, -55°C to +125°C Screened in accordance with the individual Test Methods of MIL-STD-883 for Space Applications RHD5904-201-1S 5962-1024104KXC DSCC SMD Pending RHD5904-201-2S 5962-1024104KXA RHD5904-901-1S 5962H1024104KXC DSCC SMD and Radiation Certification Pending RHD5904-901-2S 5962H1024104KXA