PRL0801D ULC | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 4
Technical content
FEATURES: ◆ Compact 240W with 1U height Power Density: 10.41 watts/cu in ◆ Built-in Remote On-Off, Power Good, Fan Fail Alarm ◆ 5/ 12/ 24/ 48V Dual Output Optional Combinations ◆ Power Factor Corrected to EN61000-3-2 Class D ◆ Variable Fan Speed & Low Acoustical Noise ◆ High Quality & Reliable Component Usage ◆ Approved to UL TUV CE CB ◆ 4 - Mechanical Options ◆ Full Range AC Input 120W ~ 240W AC-DC PFC SWITCHING POWER SUPPLY PRL0801D DUAL OUTPUT SERIES Input Voltage: 90 ~ 264Vac full range, 47 ~ 63Hz. Input Current: 5A at 90Vac. Inrush Current: Max. 70A@230Vac & 35A@115Vac; cold start. Power Factor Correction: PF>0.95 typical. Transient Response: Returns to within 1% in less than 2.5mS for a 50% load change and the peak transient does not excess 5%. Overshoot: Turn-on & off overshoot 5% over nominal voltage. Efficiency: 75% ~ 89% depends on model. Turn On Delay: 1 second maximum at 230 Vac. Hold Up Time: 16mS min. at 80% of full load. Adjustability: Output user adjustable +/-5% minimum. Fan Drive: 12VDC/300mA offering to drive an external fan. Fan Fail (FF) Alarm: Designated as FF on pin 3 of CN3, two types of logical signal provided, contact manufacturer. Remote On-Off: Designated as INH on pin4 of CN3, requires a low signal to inhibit output. Power Supply On: Green LED designated as LED1 on the PCB. Power Good: PG on CN3 goes high 100-500mS after DC regulation and low at least 1mS before loss of regulation (Open collector). Input Fusing Protection: One F5A/350V fuse inserted in primary. Over-Power Protection: 110~140% of I-Max; Auto-recovery. Short Circuit Protection: Trip without damage and auto-recovery. Over Voltage Protection: Unit latching down when output exceed 130% and recycle AC input to reset. Over-Temperature Protection: Unit protected of excessive operating ambient 110 ℃ and automatic recovery. Switching Frequency: PFC 40K~66K Hz; PWM 55K~75K Hz. Warranty: 2 years. Storage Temperature: -20℃ to 85℃. Operating Temperature: 0℃ to 70℃ ambient, de-rating at 2.5% per degree from 50℃ to 70℃. Operating Humidity: 5% to 90% RH, Non-condensing. Storage Humidity: 5% to 95% RH, Non-condensing. EMC: EN55022 class B conducted / radiated, EN61000-3-2, EN61000-3-3; EN55024 (IEC61000-4-2, IEC61000-4-3, IEC61000-4- 4, IEC61000-4-5, IEC61000-4-6, IEC61000-4-11). Safety Regulation: UL60950-1, EN60950-1, IEC60950-1. Vibration: 5 ~ 50 Hz, acceleration 7.35 m/s*s on X,Y and Z Axis. Leakage Current: < 1mA @ 264Vac. HI-POT Test: 1500 VAC input line to chassis (10mA DC cut off current); Isolating 3000VAC primary to secondary windings; Primary to core 1500VAC. All for 3 sec. Grounding Test: Apply 25 A from ground pin of the three prong plug to the far most earth. Max allowable resistance 0.1 ohm. MTBF: 100000 Hrs (according to MIL-HBK-217F) at 30 ℃ . Cooling: U Type: U-Chassis @240W max. with 25CFM airflow or 120W max. under air convection (same output ratings w/ top cover option). F Type: U-Chassis with top built-in fan @240W max. E Type: Enclosed with a built-in fan in the input end @240W max. Burn in: 45 +/- 5 degree C for 1 hour @230Vac with full load. Enclosure: U Type: 5(L) x 3.2(W) x 1.5(H) inches. U Type with top cover option: 5(L) x 3.2(W) x 1.66(H) inches. F Type: 5(L) x 3.2(W) x 2(H)inches. E Type: 3.2(L) x 6.5(W) x 1.6(H)inches Weight: Maximum U-type weight is 500g. Copy Right Ultra Level Tech Co., Ltd 2015, All Right Reserved. Specifications subject to change without notice. PRODUCT SPECIFICATIONS: CB U Type (With Top cover): 3.2(W) x 5(L) x 1.66(H) inches. E Type (Enclosed with end built-in fan): 3.2(W) x 6.5(L) x 1.6(H) inches U Type (U-Chassis only): 3.2(W) x 5(L)x 1.5(H) inches. F Type (U-Chassis with top built-in fan ): 3.2(W) x 5(L) x 2(H) inches. ULTRA LEVEL TECH CO., LTD. We Supply the Power Customers Need ISO9001 www.ultralevel.com.tw Tel:+886-2-29180118 Fax:+886-2-29181465
OUTPUT VOLTAGE / CURRENT RATING CHART: Measured at output power connector. Note: * PRL0801D series are designated as PRL0801Dx-y where x can be U (U-Chassis only or with optional vented top cover), F (U-chassis with top cover and fan installed) or E (Enclosed Type with rear side built-in fan) , y can be 0512, 0524, 0548, 1224. * U Type: U-Chassis @240W max. with min. 25CFM forced airflow or 120W max. under air convection (Option: vented top cover). * E Type: Enclosed with rear side built-in fan @240W max. * F Type: U-Chassis with top built-in fan @240W max. * Ripple and noise is measured from 10KHZ to 20MHz bandwidth at output with parallel 0.1µF ceramic and 22µF electrolytic capa citors. * 10% minimum load is required to maintain the ripple and regulation. * Output is fully isolated. Input Connector (CN1): U and F Type: Mating Molex Part No. VHR-5N or equivalent (5pin, 3 used), or Terminal Block: Howder M3 screws 3 pin 6.35mm center Part No. HD-601-3P; PCB Labeling: L=Line; N=Neutral; G=Chassis Ground . E Type: IEC320 snap-in mounting type or Terminal Block: Howder HD-602-3P. Output Connector (CN2): Molex Part No. VHR-8N Terminal block – Howder M3 Part No. HD-816-3P Output Pin Assignment: (See table in right). Mounting Inserts: 6 Places M3X0.7. Maximum Penetration 4mm sees outline drawing for location. Logic signal connector (CN3): Mating JST XHP-4 or equivalent (CHYAO SHIUNN JS-2001-04); Mating Pins: JST SXH-002T-P0.6 FOR AWG 30 to 26. : Fan driver connector (FAN1): Mating connector is JST P/N XHP-3 (3 pins 0.98 pitch) or equivalent (CHYAO SHIUNN JS-2001-03). Howder Molex V1 : Pin 3 V1 : Pin 6~8 RTN : Pin 2 RTN : Pin 2~5 V2 : Pin 1 V2 : Pin 1 Copy Right Ultra Level Tech Co., Ltd 2015, All Right Reserved. Specifications subject to change without notice. OUTLINE DRAWING: Model Number Output Voltage Max. Output Current Regulation Ripple & Noise Type U (force air) & E & F Type U (Convection) PRL0801Dx-0512 PRL0801Dx-0524 PRL0801Dx-0548 PRL0801Dx-1224 ULTRA LEVEL TECH CO., LTD. We Supply the Power Customers Need ISO9001 www.ultralevel.com.tw Tel:+886-2-29180118 Fax:+886-2-29181465
Copy Right Ultra Level Tech Co., Ltd 2015, All Right Reserved. Specifications subject to change without notice. U Type (U-Chassis only): 5(L) x 3.2(W) x 1.5(H) inches; Weight: 500g. U Type (U-Chassis with Top Cover): 5(L) x 3.2(W) x 1.66(H) inches; Weight: 550g. 抽孔攻牙 ULTRA LEVEL TECH CO., LTD. We Supply the Power Customers Need ISO9001 www.ultralevel.com.tw Tel:+886-2-29180118 Fax:+886-2-29181465
Copy Right Ultra Level Tech Co., Ltd 2015, All Right Reserved. Specifications subject to change without notice. F Type (U-Chassis with Top built-in Fan):5(L) x 3.2(W) x 2(H) inches; Weight: 600g. E Type (Enclosed with Rear Side built-in Fan): 6.5(L) x 3.2(W) x 1.6(H)inches; Weight: 650g. 81.28 [3.20] 165.10 [6.50] 68.58 [2.70] 44.52 64.77 [2.55] 8.26 [0.32] 40.64 [1.60] 19.05 [0.75] ULTRA LEVEL TECH CO., LTD. We Supply the Power Customers Need ISO9001 www.ultralevel.com.tw Tel:+886-2-29180118 Fax:+886-2-29181465