DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 15

Technical content

Notes: 1. Measurements taken on PE4151 evaluation board with M/A-Com ETK4-2T baluns on the RF and IF ports. See Figure 45 for details.

  1. IIP2 and IIP3 are measured with two tones at 0 dBm, 100 kHz spacing.

Table 1. AC and DC Electrical Specifications1 (VDD = 3.0V, temperature = +25 °C unless specified otherwise) **Table 2. Supplemental Table for Operation in HF Band* (VDD = 3.0V, temperature = +25 °C unless specified otherwise)** Note: * Measurements taken on PE4151 evaluation board wi th M/A-Com ETK4-2T baluns on the RF and IF ports. See Figure 45 for details.

©2011–2016 Peregrine Semiconductor Corp. All rights reserved. Table 6. Power On/Off Control Table 4. Operating Ranges Note: Operation should be restricted to the limits in the Operating Ranges table. Table 5. Absolute Maximum Ratings Table 3. Pin Descriptions

1 EN Enable pin (active low)

2 V DD Supply voltage

3 IF_P Positive IF port

4 IF_N Negative IF port

5 RF_P Positive RF input

6 RF_N Negative RF input

7 GND Ground

8 VDD Supply voltage

9 INB Positive LO input

10 INA Negative LO input

in the 10-lead MSOP package is MSL1. to the limits in the Operating Ranges table. exceeding the specified rating. devices are immune to latch-up. Figure 3. Pin Configuration (Top View)

Figure 44. Evaluation Board Layout MOSFET mixer with integrated LO amplifier. either a single-ended or differential signal drive. thickness of 0.059" and metal thickness of 0.0015". chip enable EN is active low.

©2011–2016 Peregrine Semiconductor Corp. All rights reserved. Figure 45. Evaluation Board Schematic

  1. Caution: contains parts and assemblies susceptible to

damage by electrostatic discharge (ESD).

  1. LO input can be differential or single ended (INA_INB/
  2. With single ended LO input, no termination is needed on

Figure 46. Package Drawing Figure 47. Marking Specification

  • Pin 1 identification AAAA Product number LLLL Last four digits of the assembly lot number YWW Date code, last digit of the year and two digit work week AAAA LLLL
  • YWW DOC-53337 TOP VIEW FRONT VIEW SIDE VIEW RECOMMENDED LAND PATTERN A 0.10 C (2X) C 0.10 C 0.05 C SEATING PLANE B 0.10 C (2X)

0.10 C A B

©2011–2016 Peregrine Semiconductor Corp. All rights reserved. Table 7. Ordering Information Figure 48. Tape and Reel Drawing any manner without notice. Preliminary Specification: The datasheet contains preliminary data. specifications at any time without notice in order to supply the best possible product. CNF (Customer Notification Form). liability for the use of this information. Use shall be entirely at the user’s own risk. damages, arising out of the use of its products in such applications. MultiSwitch and DuNE are trademarks of Peregrine Semiconductor Corp. For sales and contact information please visit www.psemi.com.