PBM300PS03-C XPPOWER | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 2

Technical content

300 Watts

  • Worldwide Medical Approvals
  • Single and Quad Outputs
  • Small Size - Only 7.50” x 4.50” x 1.75”
  • Power Fail Detect & Remote On/Off
  • Universal AC Input with Active PFC
  • High Reliability >300 kHrs MTBF
  • 150 Watt Convection-cooled Rating PBM300 Series Input Input Voltage • 90-264 VAC Input Frequency • 47-63 Hz Input Current • 4.7 A rms at 115 VAC,

2.3 A rms for 230 VAC

Inrush Current • 30 A at 115 VAC,

60 A at 230 VAC cold start +25 °C

Power Factor • 0.98 typical Earth Leakage Current • 100 µA max at 115 VAC/60 Hz 220 µA max at 230 VAC/50 Hz Input Protection • Both line and neutral fused Output Output Voltage • See table Output Voltage Trim • ±5% for outputs 1 & 2 Initial Set Accuracy • ±2% Minimum Load • See table and note 5 Start Up Delay • 2 s max Start Up Rise Time • 18 ms typical Hold Up Time • 12 ms min at full load and 110 VAC Drift • ±0.2% Line Regulation • ±0.2% max Load Regulation • See note 6 Transient Response • 4% max deviation, recovery to within 1% in 500 µs for a 25% load change Ripple & Noise • 2% max pk-pk, 20 MHz BW, with a 22 µF electrolytic & a 0.47 µF tantalum capacitor Overvoltage Protection • 115-140% Vnom output 1 only, recycle input to reset Overtemperature • Shutdown at +95 °C (singles) or +105 °C Protection (multi-outputs) with auto recovery, measured internally Overload Protection • 140-200% typical, auto recovery Short Circuit Protection • Trip and restart (Hiccup mode) Temperature • 0.04%/°C Coefficient Remote Sense • Compensates for up to 0.5 V drop Remote On/Off • On = Logic low or open circuit Off = Logic high xppower.com General Efficiency • 70% typical Isolation • 4000 VAC Input to Output

1500 VAC Input to Ground

500 VAC Output to Ground

Switching Frequency • 70 kHz ±10 kHz Power Density • 5.08 W/In Power Fail Detect • AC OK = TTL logic high AC not OK = TTL logic low MTBF • 300 kHrs per MIL-HDBK-217F at +25 °C Environmental Operating Temperature • 0 °C to +70 °C, derate linearly from 100% power at +50 °C to 50% power at +70 °C Cooling • ‘C’ versions have internal fan, ‘B’ versions are derated with convection cooling or require 35 CFM (see note 4) Operating Humidity • up to 95% RH, non-condensing Storage Temperature • -40 °C to +85 °C Operating Altitude • 2500 m Shock • Half sine pulse. acceleration 50 g, duration 11 ms, 3 shocks in each direction, unpackaged, non-operating Vibration • Sinusoidal 10-50 Hz, amplitude 0.15 mm, 30 min/axis, unpackaged, non-operating EMC & Safety Emissions • EN55011 and FCC Class B conducted & radiated Harmonic Currents • EN61000-3-2 Voltage Flicker • EN61000-3-3 ESD Immunity • EN61000-4-2, level 3 Perf Criteria A Radiated Immunity • EN61000-4-3, level 3 Perf Criteria A EFT/Burst • EN61000-4-4, level 3 Perf Criteria A Surge • EN61000-4-5, level 3 Perf Criteria A Conducted Immunity • EN61000-4-6, 3 V Perf Criteria A Dips & Interruptions • EN61000-4-11, 30% 10 ms, 60% 100 ms, >95% 5000 ms, Perf Criteria A, A, B Safety Approvals • EN60601-1, UL60601-1, CSA22.2 No. 601-1 per cUL, CE Mark Specification

  1. For U-bracket format replace suffix ‘-C’ with suffix ‘-B’. 2. All auxiliary outputs are floating and can be connected externally for either positive or negative output. 3. Output 1 & 2 can be adjusted within ±5% of their nominal voltage. 4. 300 W for ‘C’ version with cover and fan assembly. 150 watts for ‘B’ version with convection cooling (maximum current of output 1 & 2 derated by 50%). 300 W for ‘B’ version with 35 CFM forced air provided by user. PBM300PS03 is rated 200 W with 35 CFM forced air cooling or 100 W convection-cooled. PBM300PQ01 is rated 250 W with 35 CFM forced air cooling or 125 W with convection cooling. 5. Zero minimum load for outputs 3 & 4. Single output models may be operated at no-load, but voltage total regulation increases to 10%. 6. Total regulation includes initial tolerance, line regulation and load regulation. 7. † Available from Farnell. See pages 204-206. PCB B A B A 5.70 (144.8) 0.95 (24.1) B A L N G 1 P1 B A 1.34 (34.2) 0.94 (24.0) 1.80 (45.7) 2.60 (66.0) 4.50 (114.3) 1.00 (25.4) 0.63 (16.0) 1.75 (44.45) B AA B 1.00 (25.4) 7.00 (177.8) 7.50 (190.5) 1.75 (44.45) B A B A FAN Multi Output Models Single Output Models Notes 2. Mounting Holes A: #6-32 Mounting Screw, B: M3 x 0.5 3. Input connector P1 is Dinkle P/N DT-35-B01W-03. Screws are M3 x 0.5 on 0.375” centres. 4. Connector P4 mates with Molex housing 50-37-5103 & pins 5263. 5. Connectors P2. P3, P5 & P6: M3x0.5 screw connections. 6. Connector P7 mates with Molex housing 09-50-3041 & 2878 series crimp terminals. 7. DC fan on P4 is rated at 12 V/0.1 A. Conn Pin Model Number(s) PSXX PQXX

1 Line Line

2 Neutral Neutral

3 Ground Ground

1 Signal Ground Signal Ground

4 PFD PFD

5 Remote On/Off Remote On/Off

6 N.C. N.C. 7 N.C. +sense OP2 8 N.C. -sense OP2 9 0V (fan) 0V (fan) 10 12V (fan) 12V (fan) P5 1 OP1 Return OP2 P6 1 OP1 Return OP2 Return 1 n/a OP3 2 n/a OP3 Return 3 n/a OP4 4 n/a OP4 Return Mechanical Details Output Power(4) Output 1 Output 2 (2) Output 3 (2) Output 4 (2) Model Number(1) Vnom(3) Imin(5) Imax Reg(6) Vnom(3) Imin Imax Reg(6) Vnom Imax Reg(6) Vnom Imax Reg(6) 200 W 3.3 V 3.0 A 60.0 A 3% PBM300PS03-C† 300 W 5.1 V 3.0 A 60.0 A 2% PBM300PS05-C† 300 W 12.0 V 1.2 A 25.0 A 2% PBM300PS12-C† 300 W 15.0 V 1.0 A 20.0 A 2% PBM300PS15-C† 300 W 24.0 V 0.6 A 12.5 A 2% PBM300PS24-C† 300 W 30.0 V 0.5 A 10.0 A 2% PBM300PS30-C 300 W 48.0 V 0.5 A 6.3 A 2% PBM300PS48-C†