OP550 TTELEC | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 6
Technical content
OP550, OP552, OP555, OP560, OP565, OP750 Series © TT electronics plc Issue A 08/2016 Page 1 OPTEK Technology, Inc.
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.optekinc.com | www.ttelectronics.com General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. Description: OP550, OP552, OP555, OP750, and OP770 series consists of a NPN silicon phototransistor molded in an epoxy package with a wide receiving angle that provides relatively even reception over a large area. The OP750 and OP770 have additional circuitry to enhance the operation of the device for stray light levels. OP560 and OP565 series consists of a NPN silicon photodarlington transistor molded in an epoxy package with a wide receiving angle that provides relatively even reception over a large area. The side-looking package design allows easy PCBoard mounting of slotted optical switches or optical interrupt detectors. The OP550, OP560, OP750 and OP770 devices have an external lens in a clear epoxy package. The OP552 device has an integral lens in an opaque plastic package that is optically transparent to infrared light but opaque to visible wavelengths. This feature allows the device to be used under high ambient light conditions – or anywhere external light sources could interfere with the intended sensing application (visible light immunity). The OP555 and OP565 devices have an internal lens in a blue-tinted package. The lensing effect of this package allows an acceptance half-angle of 28° when measured from the optical axis to the half-power point. These devices are 100% production tested using infrared light for close correlation with OPTEK’s GaAs and GaAIAs emitters. All of these sensors are mechanically and spectrally matched to the OP140, OP142, OP145, OP240 and OP245 series of infrared emitting diodes. Please refer to Application Bulletins 208 and 210 for additional design information and reliability (degradation) data. For custom versions please contact your OPTEK representative. Applications: Applications requiring wide receiving angle Applications requiring PCBoard mounting Space-limited applications Optical switches Optical interrupt detectors Optical encoders Non-contact position sensing Machine automation Features: Wide receiving angle Four sensitivity ranges Side-looking package Ideal for space-limited applications Ideal for PCBoard mounting Choice of clear, opaque or blue-tinted package OP550 OP560 OP750 OP770 OP555 OP565 OP552 55 = Phototransistor A = Highest sensitivity level 56 = Photodarlington B = Sensitivity Level with Min. Max. 75 = Phototransistor with RBE C = Middle Sensitivity Level 77 = Phototransistor with CCE D = Lowest Sensitivity Level 0 = Extended Lens - Clear Package 2 = Extended Lens - Blue Tinted Package 5 = Integral Lens - Blue Tinted Package OP550A OP552A OP555A OP560A OP565A OP750A OP755A OP770A OP775A OP550B OP552B OP555B OP560B OP565B OP750B OP755B OP770B OP775B OP550C OP552C OP555C OP560C OP565C OP750C OP755C OP770C OP775C OP550D OP552D OP555D OP750D OP755D OP770D OP775D Available Part Numbers RoHS
© TT electronics plc General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. OP550, OP552, OP555, OP560, OP565, OP750 Series Issue A 08/2016 Page 2 OPTEK Technology, Inc. www.optekinc.com | www.ttelectronics.com OP555, OP565 (A, B, C, D) OP550, OP552, OP560, OP750, OP770 (A, B, C, D) Pin # Sensor
1 Emitter
2 Collector
OP555 - CONTAINS POLYSULFONE To avoid stress cracking, we suggest using ND Industries’ Vibra-Tite for thread-locking. Vibra-Tite evaporates fast without causing structural failure in OPTEK'S molded plastics. INCHES [MILLIMETERS] DIMENSIONS ARE IN: INCHES [MILLIMETERS] DIMENSIONS ARE IN: Notes: 1. RMA flux is recommended. Duration can be extended to 10 seconds maximum when flow soldering. A maximum 20 grams force may be applied to the leads when soldering. 3. For all phototransistors in this series, the light source is an unfiltered GaAs LED with a peak emission wavelength of 935 nm. For OP550 and OP555 only, a radiometric intensity level that varies less than 10% over the entire lens surface of the phototransistor being tested applies. 4. To calculate typical collector dark current in µA, use the formula ICEO=10 (0.040 T A - 3.4), where TA is ambient temperature in °C.
© TT electronics plc General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. OP550, OP552, OP555, OP560, OP565, OP750 Series Issue A 08/2016 Page 3 OPTEK Technology, Inc. www.optekinc.com | www.ttelectronics.com Absolute Maximum Ratings (TA = 25° C unless otherwise noted) Storage Temperature Range -40o C to +100o C Operating Temperature Range OP550, OP555, OP560, OP565, OP750 OP552 -40o C to +100o C -40o C to +85o C Collector-Emitter Voltage OP550, OP552, OP555, OP560, OP750 OP565 30 V 15 V Emitter-Collector Voltage 5 V Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron] 260° C(1) Power Dissipation OP550, OP552, OP555, OP560, OP565 OP750 100 mW(2) 200 mW(2) Electrical Specifications
© TT electronics plc General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. OP550, OP552, OP555, OP560, OP565, OP750 Series Issue A 08/2016 Page 4 OPTEK Technology, Inc. www.optekinc.com | www.ttelectronics.com Electrical Specifications Electrical Characteristics (TA = 25° C unless otherwise noted) SYMBOL PARAMETER MIN TYP MAX UNITS TEST CONDITIONS IC(ON) On-State Collector Current OP550A, OP555A OP550B, OP555B OP550C, OP555C OP550D, OP552D 2.55 1.30 0.25 0.25 4.70 2.40 mA VCE = 5.0 V, EE = 1.0 mW/cm2(3) OP560A OP565B OP560C 6.6 3.3 1.1 9.8 VCE = 2.0 V, EE = 0.1 mW/cm2(3) OP750A OP750B OP750D 2.25 1.50 0.85 7.00 4.20 7.00 VCE = 5.0 V, EE = 1.0 mW/cm2(3) OP770A 2.25 - 7.00 IC/∆ T Relative IC Charge with Temperature - 1.00 - %/°C VCE = 5.0 V, EE = 1.0 mW/cm2 , λ = 935 nm ICEO Collector-Dark Current - - 100 nA VCE = 10.0 V, EE = 0(4) V(BR)CEO Collector-Emitter Breakdown Voltage OP550, OP552, OP555, OP750, OP770 OP560, OP565 V IC = 100 µA, EE = 0(4) IC = 1 mA, EE = 0(4) V(BR)ECO Emitter-Collector Breakdown Voltage 5.0 - - V IE = 100 µA VCE(SAT) Collector-Emitter Saturation Voltage OP550, OP552, OP555, OP750, OP770 OP560, OP565 0.40 1.10 V IC = 100 µA, EE = 1.0 mW/cm2(3) IC = 0.4 mA, EE = 0.1 mW/cm2(3) See page 2 for Notes
© TT electronics plc General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. OP550, OP552, OP555, OP560, OP565, OP750 Series Issue A 08/2016 Page 5 OPTEK Technology, Inc. www.optekinc.com | www.ttelectronics.com Performance OP552 - Angular Response 100 Angular Displacement (Degrees) Relative Collector Current (%) -45 -30 -15 0 15 30 45 Irradiance (EE) (mW/cm2) λ = 935 nm λ = 880 nm OP552 - On-State Collector Current vs Irradiance On-State Collector Current (IC(ON)) (mA) 100 RL VCC = 5 V IF Adjust IF to obtain VRL Switching Test Circuit
© TT electronics plc General Note TT Electronics reserves the right to make changes in product specification without notice or liability. All information is subject to TT Electronics’ own data and is considered accurate at time of going to print. OP550, OP552, OP555, OP560, OP565, OP750 Series Issue A 08/2016 Page 6 OPTEK Technology, Inc. www.optekinc.com | www.ttelectronics.com Performance OP552 - Typical Spectral Response 600 700 800 900 1000 1100 100 Wavelength (nm) Relative Response (%) OP552 - Output Vs Frequency 100 Frequency (KHz) Relative Output (%) 1 10 100 1000 RL = 10 K RL = 1 K OP552 - Rise and Fall Time vs Load Resistance 0 2 K 4 K 8 K 6 K 10 K 100 150 200 250 Load Resistance (Ohms) Relative Collector Current (V) tr tf VCC = 5 V VRL = 1 V f = 100 Hz PW = 1 ms OP552 - Coupling Characteristic Distance (inches) 100 Emitter: OP142 IF: 20mA VCE: 5V Relative Response (%)