LM358

LM358 ESTEK | Alldatasheet

Document overview

• Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
• PDF pages: 4

Technical content

Features

• Internally frequency compensated for unity gain
• Large DC voltage gain:100dB Wide power supply range:
• Input common-mode voltage range includes ground
• Large output voltage swing:0V DC to Vcc-1,5V DC
• Power drain suitable for battery operation
• Differential inpit voltage range equal to the power supply voltage SOP - 8
• Low input offset voltage and offset current DIP - 8 Package Internal Block Digram Logic Diagram Pin Assinment PIN 4 = GND PIN 8=V CC BEIJING ESTEK ELECTRONICS CO.,LTD

Electrical Characteristics

at specified free-air temperature, Vcc = 5 V (unless otherwise noted) Symbol Parameter Test conditions* VIO Input offset voltage Vcc = 5 V to MAX, LM358 Min Typ Max 25 °С 3 7 Units mV αVIO Average temperature coefficient of input offset voltage VIC = VICR min, Vo=1.4 V Full range 9 Full range 7 µ V/° C lIO Input offset current Vo=1.4 V 25 °С 2 50 Full range 150 nA αlIO Average temperature coefficient of input offset current Full range 10 pA/° C IIB Input bias current Vo=1.4 V VICR Common-mode input voltage range Vcc = 5 V to MAX 25 °С -20 -250 Full range -500 25°С 0 to Vcc-1.5 Full range 0 to Vcc - 2 nA V VOH High-level output voltage RL ≥2 KΩ 25 °С Vcc-1.5 Vcc = MAX, RL=2 kΩ Full range 26 V Vcc = MAX, RL ≥10 kΩ Full range 27 28 VOL Low-level output voltage RL ≥10 kΩ Full range 5 20 mV AVD Large-signal differential voltage amplification Vcc = 15 V, Vo=1V to 11 V, RL ≥2 kΩ 25 °С 25 100 Full range 15 V/mV CMRR Common-mode rejection ratio Vcc = 5 V to MAX, VIC = VICR min 25 °С 65 80 dB kSVR Supply voltage rejection ratio (∆Vcc/∆VIO) Vcc = 5 V to MAX 25 °С 65 100 dB Vo1 /Vo2 Crosstalk attenuation f=1 kHz to 20 kHz 25 °С 120 dB lo Output current Vcc = 15 V, 25 °С -20 -30 mA VID=1 V,VO= 0 Full range -10 Vcc = 15 V, 25 °С 10 20 VID = - 1 V, Vo = 15 V Full range 5 VID = - 1 V, Vo =200 mV lOS Short-circuit output current Vcc at 5 V, GND at -5 V,Vo=0 25 °С 12 30 µ A 25 °С ± 40 ± 60 mA ICC Supply current (two amplifiers) Vo - 2.5 V, No load Full range 0.7 1.2 mA Vcc = MAX, Vo = 0.5Vcc, No load Full range 1 2

• All characteristics are measured under open-loop conditions with zero common-mode input voltage unless otherwise specified. “ MAX” VCC for testing purposes is 30 V. Full range is 0 °С to 70 °С . BEIJING ESTEK ELECTRONICS CO.,LTD

Symbol Parameter Value Unit VCC Power Supply Voltages Single Supply Split Supplies ±16 V VIDR Input Differential Voltage Range (1) ±32 V VICR tS IIN Input Common Mode Voltage Range -0.3 to 32 V Short-Circuit duration of Output 100 ms Input Current, per pin (2) 50 mA Junction TemperatureTJ Plastic Packages 150 °C Tstg Storage Temperature Plastic Packages (TA = +25º C) -55 to +125 °C TL Lead Temperature, 1mm from Case for 10 Seconds 260 °C Maximum Ratings are those values beyond which damage to the device may occur. Functional operation should be restricted to the Recommended Operating Conditions. Notes: 1. Split Power Supplies. 2. VIN <-0.3V. This input current will only exist when voltage at any of the input leads is driven negative. Typcal Peformance Characteristics Figure 1.Input Voltage Rang e Figure 2. Open-Loop Frequency BEIJING ESTEK ELECTRONICS CO.,LTD