H100E MPD | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
Key Features: 1W Output Power Miniature MiniDIP Case UL Approved (File E245422) 1,000 VDC Isolation >3.5 MHour MTBF 17 Standard Models Industry Standard Pin-Out LOWEST COST! H100E Low Cost, 1W, Ultra-Miniature DC/DC Con vert ers Series MicroPower Direct
292 Page Street
Stoughton, MA 02072 USA T: (781) 344-8226 F: (781) 344-8481 E: sales@micropowerdirect.com W: www.micropowerdirect.com Input Parameter Conditions Min. Typ. Max. Units Input Voltage Range 3.3 VDC Input 3.0 3.3 3.6 VDC5 VDC Input 4.5 5.0 5.5 12 VDC Input 10.8 12.0 13.2 24 VDC Input 21.6 24.0 26.4 Input Filter Internal Capacitor Reverse Polarity Input Current 0.3 A Output Parameter Conditions Min. Typ. Max. Units Output Voltage Accuracy ±1.0 ±3.0 % Line Regulation, 3.3V Output Models For Vin Change of 1% ±1.5 %Line Regulation, All Other Models ±1.2 Load Regulation See Model Selection Guide Ripple & Noise (20 MHz) 75 100 mV P - P Output Power Protection 120 % Temperature Coeffi cient ±0.03 %/ ºC Output Short Circuit Momentary (1.0 Sec.) General Parameter Conditions Min. Typ. Max. Units Isolation Voltage 60 Seconds 1,000 VDC Isolation Resistance 500 VDC 1,000 MΩ Isolation Capacitance 100 kHz, 1V 60 100 pF Switching Frequency 100 kHz Environmental Parameter Conditions Min. Typ. Max. Units Operating Temperature Range Ambient -40 +25 +85 ºC Storage Temperature Range -55 +125 ºC Cooling Free Air Convection Humidity RH, Non-condensing 95 % Physical Case Material Non-Conductive Black Plastic (UL94-V0) Weight 0.06 Oz (1.8g) Reliability Specifi cations Parameter Conditions Min. Typ. Max. Units MTBF MIL HDBK 217F, 25ºC, Gnd Benign 3.5 MHours Safety Standards UL 1950, EN 60950, IEC 60950 Safety Approvals Not 3.3 Vout Models UL, cUL; File No. E245422 Absolute Maximum Ratings Parameter Conditions Min. Typ. Max. Units Input Voltage Surge (1 Sec) 3.3 VDC Input -0.7 7.0 VDC5 VDC Input -0.7 9.0 12 VDC Input -0.7 18.0 24 VDC Input -0.7 30.0 Lead Temperature 1.5 mm From Case For 10 Sec 300 ºC Internal Power Dissipation All Models 450 mW Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings. Electrical Specifi cations Specifi cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifi cations subject to change without notice.
Notes: 1. Output load regulation is specifi ed for a load change of 10% to 100%. 2. When measuring output ripple, it is recommended that an external 0.33 µF ceramic capacitor be placed from the +Vout pin to the -Vout pin. 3. During operation, care must be taken not to exceed the specifi ed input range of the unit or to allow the output load to drop below the specifi ed minimum (10% of full load). Operating the unit under either of these conditions could cause damage to the unit. 4. These converters are specifi ed for operation without external components. However, in some applications the addition of input/output capacitors will enhance stability and reduce output ripple. Recommended capacitor values are: Vin Input Capacitor Vout Output Capacitor 3.3 VDC 4.7 µF 3.3 VDC 10.0 µF 5 VDC 4.7 µF 5 VDC 10.0 µF 12 VDC 2.2 µF 9 VDC 4.7 µF 24 VDC 1.0 µF 12 VDC 2.2 µF 15 VDC 1.0 µF For applications requiring very low output noise levels, a simple LC fi lter should be effective. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the table above for the correct rating. Model Selection Guide Notes: All dimensions are typical in inches (mm) Tolerance x.xx = ±0.01 (±0.25) Pin 1 is marked by a “dot” or indentation on the top of the unit Mechanical Dimensions Pin Connections Model Number Input Output Load Regulation (%, Max) Effi ciency (%, Typ) Fuse Rating Slow-Blow (mA) Voltage (VDC) Current (mA) Voltage (VDC) Current (mA, Max) Current (mA, Min)Nominal Range Full-Load No-Load Pin Function 1- V i n 4+ V i n 5 +Vout 7 -Vout MicroPower Direct www.micropowerdirect.com 292 Page Street Ste D Stoughton, MA 02072 TEL: (781) 344-8226 FAX: (781) 344-8481 E-Mail: sales@micropowerdirect.com Derating Curve