FCM-8519-1-T4 FINISAR | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 9
Technical content
HSSDC (FCM-8519-2-T4) connectors. Table 1. GBIC to h ost connector pin assignment
described in Table 2. The GBIC specification calls for a range of 4.75V to 5.25 volts. TX_DISABLE circuitry in Finisar copper GBICs will function at 6V. Input Voltage Vcc 4.5 5 5.5 V Referenced to GND. Table 2. +5 volt electrical power interface Table 3. GBIC pin usage, HSSDC and DB9 copper modules
protocol. MOD_DEF(1), MOD_DEF(2), and RX_LOS must be pulled up to host_Vcc. Table 4. Low speed signals – electronic characteristics Table 5. Low speed signal parameters (preliminary)
All high-speed PECL signals to and from the host board are AC coupled internally. internally and terminated into 75Ω (150Ω differential). Table 6. High-speed electrical interface - host to GBIC connector Table 7. High-speed electrical interface – GBIC to line connector
Table 10. General specifications Table 8. HSSDC pin assignment Table 9. DB9 pin assignment
Note that the GBIC Specification requires an ambient temperature range of 0 to 50C. Table 11. Environmental Specifications Atmel I2C Clock Rate Catmel 0 100,000 Hz Bus can be driven blind. Table 12. I2C timing requirements
Specification Revision 5.4, Section 61. Figure 1. GBIC Outline Draw ing (DB9) Table 10. Insertion, extraction, and retention forces
Figure 2. GBIC Outline Drawing (HSSDC)
FCM-8519-1-T4/FCM-8519-2-T4 Product Specifi cation F i n i s a r Finisar Corporation 03/10/2000 Page 9 IX. References 1. “Gigabit Interface Converter (GBIC) Revision 5.4”. Sun Microsystems Computer 2. “IEEE Draft P802.3z/D5.0 ‘Media Access Control (MAC) Parameters, Physical Layer, Repeater and Management Parameters for 1000Mb/s Operation’”. IEEE Standards Department, 1998. 3. “Fibre Channel Physical and Signaling Interface (FC-PH, FC-PH2, FC-PH3)”. American National Standard for Information Systems. 4. “AT24C01A/02/04/08/16 2-Wire Serial CMOS E2PROM”. Atmel Corporation. www.Atmel.com