F10 WILCOXON | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 1
Technical content
Note: Due to continuous process improvement, specifications are subject to change without notice. This document is cleared for public release. Wilcoxon Sensing Technologies 8435 Progress Drive Frederick, MD 21701 USA Tel: +1 (301) 330-8811 Fax: +1 (301) 330-8873 info@wilcoxon.com An Amphenol Company buy.wilcoxon.com www.wilcoxon.com 98388 Rev.E 10/21 SPECIFICATIONS F10 Electromagnetic shaker system Notes: 1 Blocked force output refers to the force output against a mass of infinite mechanical impedance. 2 Refers to connector at end of cable. Accessories supplied: All input cables; air feed/coupler; gasket Accessories available: Power amplifiers; Z820WA impedance head; dummy plug, F7 vibration generator/impedance head Key features The F10 vibration generator is a reaction-type shaker generating very large dynamic forces for structural excitation in vibration research and testing. The reaction principle of operation and compact configuration allow this generator to be stud mounted in any position, directly to structures, without external support or critical shaft alignment problems. The F10 is designed for operation over a wide range of audio frequencies. The relatively light coil and bobbin are rigidly attached to the structure under test, while the heavy cylindrical magnets are suspended by two rubber diaphragms. The dynamic weight added to the test structure is relatively low, since the rubber suspended weight does not affect axial or rotational inertia of the vibration generator’s coil and bobbin above the 25 Hz resonance frequency of the system. The F10 can be supplied with a sensing transducer containing an accelerometer and a force gauge (model Z820WA impedance head), a piezoelectric vibration generator/impedance head combination (model F7), or a solid core with a 3/8-16” tapped mounting hole (model F4/F10 dummy plug). Usable frequency range 5 - 2,000 Hz Blocked force output1 see graph Maximum continuous current 4.0 amp rms Nominal electrical impedance 8.5 Ω at 100 Hz DC electrical resistance 5 Ω Resonance frequency, blocked 25 Hz Connector2 Bendix SP00A-8-3 Cable R4M-8B-8B-J9B-10 Temperature range 0° to +80°C Weight: Parts rigidly attached to structure Suspended weight Total weight 8 lb 20 lb 28 lb 100 31.6
3.16 Pounds, peak
Fre quency, Hz 316 Limited by shak er e x cursio n T ypic al bl ock ed f or c e output (F10 shak er power ed by P A8HF) Model F10 with dummy plug 8.25" dia. Electrical connector Air cooling plugs 3/8-16 mounting hole 0.65" 4.70" 1.62" dia. 2.18" dia. F10 Air feed Dummy plug Signal source Powe r amplifier PA8HF Structure F10 Dummy plug Recommended system diagram Power amplifier WST7B3 Typical blocked force output (F10 shaker powered by WST7B3)