DATASHEET SEARCH SITE | WWW.ALLDATASHEET.COM

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 2

Technical content

Key Features:  1W Output Power  Ultra-Miniature SIP Case  3,000 VDC Isolation  14 Standard Models  >3.5 MHour MTBF  3.3V, 5V, 12V & 24V Inputs  LOWEST COST!! E100EI 1W, High Isolation Ultra-Miniature SIP DC/DC Con vert ers Input Parameter Conditions Min. Typ. Max. Units Input Voltage Range 3.3 VDC Input 2.97 3.3 3.63 VDC5 VDC Input 4.50 5.0 5.50 12 VDC Input 10.80 12.0 13.20 24 VDC Input 21.60 24.0 26.40 Reverse Polarity Input Current 0.3 A Input Filter Internal Capacitor Output Parameter Conditions Min. Typ. Max. Units Output Voltage Accuracy ±1.0 ±3.0 % Line Regulation, 3.3V Input Models For Vin Change of 1% ±1.5 % All Other Models ±1.2 Load Regulation, See Note 1 See Model Selection Guide Ripple & Noise (20 MHz) See Note 3 100 150 mV P - P Temperature Coeffi cient ±0.01 ±0.03 %/°C Output Short Circuit, See Note 4 Momentary (1.0 Sec.) General Parameter Conditions Min. Typ. Max. Units Isolation Voltage 60 Seconds 3,000 VDC Isolation Resistance 500 VDC 1,000 M Isolation Capacitance 100 kHz, 1V 60 pF Switching Frequency 100 kHz Environmental Parameter Conditions Min. Typ. Max. Units Operating Temperature Range Ambient -40 +25 +85 °C Storage Temperature Range -55 +125 °C Cooling Free Air Convection Humidity RH, Non-condensing 95 % Physical Case Material Non-Conductive Black Plastic (UL-94V0) Weight 0.04 Oz (1.1g) Reliability Specifi cations Parameter Conditions Min. Typ. Max. Units MTBF MIL HDBK 217F , 25°C, Gnd Benign 3.5 MHours Shock & Vibration, See Note 5 Meets MIL-STD-202F , IEC68-2-6 Absolute Maximum Ratings Parameter Conditions Min. Typ. Max. Units Input Voltage Surge (1 Sec) 3.3 VDC Input -0.7 7.0 VDC5 VDC Input -0.7 9.0 12 VDC Input -0.7 18.0 24 VDC Input -0.7 30.0 Lead Temperature 1.5 mm From Case For 10 Sec 300 °C Internal Power Dissipation All Models 650 mW Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings. Series www.micropowerdirect.com MicroPower Direct

292 Page Street

Stoughton, MA 02072 USA T: (781) 344-8226 F: (781) 344-8481 E: sales@micropowerdirect.com W: www.micropowerdirect.com Electrical Specifi cations Specifi cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifi cations subject to change without notice.

Notes: 1. Output load regulation is specifi ed for a load change of 10% to 100%. 2. These units should not be operated with a load under 10% of full load. Operation at no- load may cause damage to the unit. 3. These converters will operate without external components. However, when measuring out- put ripple, it is recommended that an external ceramic capacitor be placed from the +Vout pin to the -Vout pin. An input capacitor will enhance stability over tem- perature and input line variations. Recommended capacitor values are given in the table above. For applications requiring very low output noise levels, a simple LC fi lter should be effective. 4. After an output short circuit, the input power must be recycled to operate the unit. 5. Given for frequency range of 5 to 500 Hz and PSD of 0.0248 g 2/Hz. Tested on X, Y & Z axis for 60 minutes. 6. It is recommended that a fuse be used on the input of a power supply for protection. See the Model Selection table above for the correct rating. Vin Input Capacitor Vout Output Capacitor 3.3 VDC 4.7 µ F 3.3 VDC 10.0 µ F 5 VDC 4.7 µ F 5 VDC 10.0 µ F 12 VDC 2.2 µ F 9 VDC 4.7 µ F 24 VDC 1.0 µ F 12 VDC 2.2 µ F 15 VDC 1.0 µ F Other input/output combinations are available (i.e. 3.3 VDC). Contact the factory for details at: sales@micropowerdirect.com Model Selection Guide Notes:

  • All dimensions are typical in inches (mm)
  • Tolerance x.xx = ±0.01 (±0.25)
  • Pin 1 is marked by a “dot” or indentation on the side of the unit Model Number Input Output Load Regulation Effi ciency (%, Typ) Fuse Rating Slow-Blow (mA) Voltage (VDC) Current (mA) Voltage (VDC) Current (mA, Max) Current (mA, Min)Nominal Range Full-Load No-Load (% Typ) (% Max) Mechanical Dimensions Pin Description 1- V i n 2+ V i n 3 -Vout 4 +Vout Pin Connections www.micropowerdirect.com Derating Curve MicroPower Direct We Power Your Success - For Less! 292 Page Street Ste D Stoughton, MA 02072  TEL: (781) 344-8226  FAX: (781) 344-8481  E-Mail: sales@micropowerdirect.com