D200RW MPD | Alldatasheet
Document overview
- Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
- PDF pages: 2
Technical content
Key Features: 2W Output Power 2:1 Input Voltage Range 1,000 VDC Isolation Short Circuit Protected Miniature SIP Case Single & Dual Outputs 2.7 MH MTBF Industry Standard Pin-Out D200RW Miniature SIP, 2W Wide Input Range DC/DC Con vert ers Series Input Parameter Conditions Min. Typ. Max. Units Input Voltage Range 5 VDC Input 4.5 5.0 9.0 VDC12 VDC Input 9.0 12.0 18.0 24 VDC Input 18.0 24.0 36.0 48 VDC Input 36.0 48.0 72.0 Input Filter Capacitor Filter Input Refl ected Ripple Current 35 mA P - P Reverse Polarity Input Current 1.0 A Short Circuit Input Power 1,500 mW Output Parameter Conditions Min. Typ. Max. Units Output Voltage Accuracy ±2.0 % Output Voltage Balance ±2.0 % Line Regulation Vin = Min to Max ±0.5 % Load Regulation Iout = 25% to 100% ±1.0 % Ripple & Noise (20 MHz) 80 mV P - P Output Power Protection 120 % Temperature Coeffi cient ±0.02 %/°C Output Short Circuit Continuous (Autorecovery) General Parameter Conditions Min. Typ. Max. Units Isolation Voltage 60 Seconds 1,000 VDC Isolation Resistance 1,000 VDC 1,000 MΩ Isolation Capacitance 100 kHz, 1V 60 pF Switching Frequency 100 650 kHz Environmental Parameter Conditions Min. Typ. Max. Units Operating Temperature Range Ambient -40 +25 +85 °C Operating Temperature Range Case +100 °C Storage Temperature Range -40 +125 °C Cooling Free Air Convection Humidity RH, Non-condensing 95 % Physical Case Material Non-Conductive Black Plastic (UL94-V0) Weight 0.17 Oz (4.8g) Remote On/Off Parameter Conditions Min. Typ. Max. Units Unit On (Note 2) 0 0.8 VDC Unit Off (Note 2) 5.0 VDC Off Idle Current 5.0 mA Reliability Specifi cations Parameter Conditions Min. Typ. Max. Units MTBF MIL HDBK 217F, 25°C, Gnd Benign 2.73 MHours Absolute Maximum Ratings Parameter Conditions Min. Typ. Max. Units Input Voltage Surge (1 Sec) 5 VDC Input -0.7 12.0 VDC12 VDC Input -0.7 24.0 24 VDC Input -0.7 40.0 48 VDC Input -0.7 80.0 Lead Temperature 1.5 mm From Case For 10 Sec 260 °C Internal Power Dissipation All Models 1,800 mW Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings. MicroPower Direct
292 Page Street
Stoughton, MA 02072 USA T: (781) 344-8226 F: (781) 344-8481 E: sales@micropowerdirect.com W: www.micropowerdirect.com RoHS Compliant Electrical Specifi cations Specifi cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifi cations subject to change without notice.
Mechanical Notes:
- All dimensions are typical in inch es (mm)
- Tolerance x.xx = ±0.01 (±0.25) Notes: 1. An external capacitor should be placed from the +Vout pin to the -Vout pin for single output units and from each output to common for dual output units. For single output units a 100 µF is recommended, for dual output models ±48 µF should be used. 2. The Remote On/Off Control input (Pin 3) is referenced to -Vin (Pin 1). Connection to the pin should be made through a 1kΩ resistor and diode (1N4148). If it is not used, the control pin should be left open or tied directly to -Vin (Pin 1). 3. Operation at no-load will not damage these units. However, they may not meet all specifi cations. 4. Dual output units may be connected to provide a 10 VDC, 24 VDC, 30 VDC or 48 VDC output. To do this, connect the load across the positive (+Vout) and negative (-Vout) outputs and fl oat the output common. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the table above for the correct rating. Model Number Input Output Effi ciency (%, Typ) Capacitive Load (µF, Max) Fuse Rating Slow-Blow (mA) Voltage (VDC) Current (mA) Voltage (VDC) Current (mA, Max) Current (mA, Min)Nominal Range Full-Load No-Load Pin Single Dual 1 -Vin -Vin 2 +Vin +Vin
3 Remote ON/OFF
8 NC -Vout
NC = No Connection Pin Connections NCMicroPower Direct www.micropowerdirect.com 292 Page Street Ste D Stoughton, MA 02072 • TEL: (781) 344-8226 • FAX: (781) 344-8481 • E-Mail: sales@micropowerdirect.com Derating Curve Other input/output combinations are available (i.e. 9.0 VDC). Contact the factory for details at: sales@micropowerdirect.com A metal case is available Contact the factory for details at: sales@micropowerdirect.com