C3D03060F_13 CREE | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 6

Technical content

Features

  • 600-Volt Schottky Rectifier
  • Optimized for PFC Boost Diode Application
  • Zero Reverse Recovery Current
  • Zero Forward Recovery Voltage
  • High-Frequency Operation
  • Temperature-Independent Switching Behavior
  • Extremely Fast Switching
  • Positive Temperature Coefficient on VF Benefits
  • Replace Bipolar with Unipolar Rectifiers
  • Essentially No Switching Losses
  • Higher Efficiency
  • Reduction of Heat Sink Requirements
  • Parallel Devices Without Thermal Runaway

Applications

  • Switch Mode Power Supplies
  • Power Factor Correction - Typical PFC P out : 150W-300W Package TO-220-F2 Maximum Ratings (TC = 25 ˚C unless otherwise specified) Symbol Parameter Value Unit Test Conditions Note VRRM Repetitive Peak Reverse Voltage 600 V VRSM Surge Peak Reverse Voltage 600 V VDC DC Blocking Voltage 600 V IF Continuous Forward Current A TC=25˚C TC=110˚C TC=135˚C IFRM Repetitive Peak Forward Surge Current 20 15 A TC=25˚C, tP=10 mS, Half Sine Wave D=0.3 TC=110˚C, tP=10 mS, Half Sine Wave D=0.3 IFSM Non-Repetitive Peak Forward Surge Current 28 22 A TC=25˚C, tP=10 mS, Half Sine Wave D=0.3 TC=110˚C, tP=10 mS, Half Sine Wave D=0.3 IFSM Non-Repetitive Peak Forward Surge Current 100 A TC=25˚C, tP=10 µS, Pulse Ptot Power Dissipation 12.5

5.4 W TC=25˚C

TC=110˚C TJ , Tstg Operating Junction and Storage Temperature -55 to +175 ˚C TO-220 Mounting Torque 1 8.8 Nm lbf-in M3 Screw 6-32 Screw Part Number Package Marking C3D03060F TO-220-F2 C3D03060 PIN 1 PIN 2 CASE VRRM = 600 V IF (TC=110˚C) = 3 A Qc = 6.7 nC

C3D03060F Rev. C 4.0 5.0 6.0 0.0 1.0 2.0 3.0

Electrical Characteristics

Symbol Parameter Typ. Max. Unit Test Conditions Note VF Forward Voltage 1.7

2.4 V IF = 3 A TJ=25°C

IF = 3 A TJ=175°C IR Reverse Current 10 100 μA VR = 600 V TJ=25°C VR = 600 V TJ=175°C QC Total Capacitive Charge 6.7 nC VR = 600 V, IF = 3A di/dt = 500 A/μS TJ = 25°C C Total Capacitance 155 pF VR = 0 V, TJ = 25°C, f = 1 MHz VR = 200 V, TJ = 25˚C, f = 1 MHz VR = 400 V, TJ = 25˚C, f = 1 MHz Note: 1. This is a majority carrier diode, so there is no reverse recovery charge. Thermal Characteristics Symbol Parameter Typ. Unit RθJC TO-220-F2 Package Thermal Resistance from Junction to Case 12.0 °C/W Typical Performance Figure 1. Forward Characteristics Figure 2. Reverse Characteristics

Figure 6. Power Derating

  1. Dimension L, M, T apply for Solder Dip

C3D03060F Rev. C Recommended Solder Pad Layout Part Number Package Marking C3D03060F TO-220-F2 C3D03060 TO-220-2 Diode Model Note: Tj = Diode Junction Temperature In Degrees Celsius VT RT Diode Model CSD04060 Vf T = VT + If*RT VfT = VT+If*RT Note: Recommended soldering profiles can be found in the applications note here: http://www.cree.com/power_app_notes/soldering

C3D03060F Rev. C Copyright © 2013 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree, the Cree logo, and Zero Recovery are registered trademarks of Cree, Inc. Cree, Inc.

4600 Silicon Drive

Durham, NC 27703 USA Tel: +1.919.313.5300 Fax: +1.919.313.5451 www.cree.com/power

  • RoHS Compliance The levels of RoHS restricted materials in this product are below the maximum concentration values (also referred to as the threshold limits) permitted for such substances, or are used in an exempted application, in accordance with EU Directive 2011/65/EC (RoHS2), as implemented January 2, 2013. RoHS Declarations for this product can be obtained from your Cree representative or from the Product Documentation sections of www.cree.com.
  • REACh Compliance REACh substances of high concern (SVHCs) information is available for this product. Since the European Chemi- cal Agency (ECHA) has published notice of their intent to frequently revise the SVHC listing for the foreseeable future,please contact a Cree representative to insure you get the most up-to-date REACh SVHC Declaration. REACh banned substance information (REACh Article 67) is also available upon request.
  • This product has not been designed or tested for use in, and is not intended for use in, applications implanted into the human body nor in applications in which failure of the product could lead to death, personal injury or property damage, including but not limited to equipment used in the operation of nuclear facilities, life-support machines, cardiac defibrillators or similar emergency medical equipment, aircraft navigation or communication or control systems, air traffic control systems, or weapons systems. Notes