AVT-55689 AVAGO | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 11

Technical content

Features

  • Small signal gain amplifier
  • Operating frequency 50 MHz to 6 GHz
  • Unconditionally stable
  • 50 Ohm input & output
  • Industry standard SOT-89
  • Lead-free, RoHS compliant, Green Specifications 2 GHz, 5 V Vcc, 75 mA (typ.)
  • 17.2 dB Gain
  • 19.5 dBm P1dB
  • 32.5 dBm OIP3
  • 4.3 dB NF
  • 19 dB IRL and 10.7 dB ORL

Applications

  • Wireless Data / WLAN
  • WiMAX / WiBRO
  • CATV & Cable modem
  • ISM Typical Biasing Configuration Vcc RFin RFout Cbyp Cbyp L Cblock Cblock Pin 1 Input Pin 2 (Gnd) Pin 3 Output 55X Top View RFin GND RFout #1 #2 #3 Bottom View RFout GND RFin #3 #2 #1

Absolute Maximum Rating (1) TA = 25° C Symbol Parameter Units Absolute Max. Vd, MAX Device Voltage V 5.5 PIN, MAX CW RF Input Power dBm 18 PDISS Total Power Dissipation (2) mW 550 TOPT Operating Temperature °C -40 to 85 TJ, MAX Junction Temperature °C 150 TSTG Storage Temperature °C -65 to 150 Thermal Resistance Thermal Resistance (3) θjc = 111° C/W (Id = 75 mA, Tc = 85° C) Notes: 1. Operation of this device in excess of any of these limits may cause permanent damage. 2. Ground lead temperature is 25° C. Derate 8.9 mW/° C for Tc>108° C. 3. Thermal resistance measured using Infrared measurement technique. Electrical Specification (1) TA = 25° C, Zo = 50 Ω, VCC = 5 V, Pin = -15 dBm (unless specified otherwise) Symbol Parameter and Test Condition Frequency Units Min. Typ. Max. Id Device Current mA 66 75 86 Gp Power Gain 900 MHz

2000 MHz

15.5 18.8 17.2 18.5 f3dB 3 dB Bandwidth GHz 2.5 OIP3 (2) Output 3rd Intercept Point 900 MHz 32.5 S11 Input Return Loss, 50 Ω source 900 MHz -19 S22 Output Return Loss, 50 Ω load 900 MHz -10.7 S12 Reverse Isolation 900 MHz dB -22.6 -22.7 P1dB Output Power at 1 dB Gain Compression 900 MHz dBm 20.6 19.5 NF Noise Figure 900 MHz dB 4.1 4.3 Note : 1. Measurements obtained on CPWG line with reference plane at the ends of DUT leads (as shown in Figure 1). 2. OIP3 test condition: FRF1 - FRF2 = 10 MHz with input power of -15 dBm per tone measured at worse side band.

AVT-55689 Typical Scattering Parameters TA = 25° C, Zo = 50 Ω, Vcc = 4.5 V, (unless specified otherwise) Freq (GHz) S11 S21 S12 S22 Kmag angle dB mag angle mag angle mag angle Notes: 1. S-parameters are measured on a CPWG line fabricated on 0.025 inch thick Rogers RO4350 material. The input reference plane is at the end of the input lead. The output reference plane is at the end of the output lead.

AVT-55689 Typical Scattering Parameters TA = 25° C, Zo = 50 Ω, Vcc = 5.0 V, (unless specified otherwise) Freq (GHz) S11 S21 S12 S22 Kmag angle dB mag angle mag angle mag angle Notes: 1. S-parameters are measured on a CPWG line fabricated on 0.025 inch thick Rogers RO4350 material. The input reference plane is at the end of the input lead. The output reference plane is at the end of the output lead.

AVT-55689 Typical Scattering Parameters TA = 25° C, Zo = 50 Ω, Vcc = 5.5 V, (unless specified otherwise) Freq (GHz) S11 S21 S12 S22 Kmag angle dB mag angle mag angle mag angle Notes: 1. S-parameters are measured on a CPWG line fabricated on 0.025 inch thick Rogers RO4350 material. The input reference plane is at the end of the input lead. The output reference plane is at the end of the output lead.

Part Number Ordering Information Part Number No. of Devices Container AVT-55689-BLKG 100 Antistatic Bag AVT-55689-TR1G 3000 13" Tape/Reel Dimensions in mm Dimensions in inches Symbols Minimum Nominal Maximum Minimum Nominal Maximum E 3.94 - 4.25 0.155 - 0.167 MATTE FINISH POLISH POLISH D E L b e e1S C b1 b A OR 1.24 1.23 0.77

0.2 HALF ETCHING

1.625 2.35 DEPTH 0.100 E D E L e e1S OR

NOTES: 1. 10 SPROCKET HOLE PITCH CUMULATIVE TOLERANCE ±0.2 2. CAMBER IN COMPLIANCE WITH EIA 481 3. POCKET POSITION RELATIVE TO SPROCKET HOLE MEASURED AS TRUE POSITION OF POCKET, NOT POCKET HOLE 12.0 ± .3 Ao = 4.60 Bo = 4.90 Ko = 1.90 5.50 ± .05 SEE NOTE 3 1.75 ± .10 8.00 Ø 1.5 +0.1/-0.0 2.00 ± .05 SEE NOTE 3

4.00 SEE NOTE 1

Ø 1.50 MIN. Ao Ko R 0.3 TYP . R 0.3 MAX. 0.30 ± .05 A A Bo USER FEED DIRECTION COVER TAPE CARRIER TAPE REEL 55X 55X 55X 55X

For product information and a complete list of distributors, please go to our web site: www.avagotech.com Avago, Avago Technologies, and the A logo are trademarks of Avago Technologies in the United States and other countries. Data subject to change. Copyright © 2005-2013 Avago Technologies. All rights reserved. AV02-2705EN - May 23, 2013 Reel Dimensions – 13” Reel Ø 20.2 M IN 2.0 ± 0.5 Ø 13.0 +0.5 -0.2 102.0 REF 330.0 REF 8.4(MEASURED AT HUB) (MEASURED AT HUB) "A" ATTENTION Electrostatic Sensitive Devices Safe Handling Required MINNEAPOLIS USA U.S PAT 4726534 R LOKREEL R 11.1 MAX. Detail "A" Detail "B" PS PS 1.5

88 REF

96.5 +0.3 - 0.2 Dimensions in mm