AMZ-2.55 RHOMBUS-IND | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 1

Technical content

15801 Chemical Lane, Huntington Beach, CA 92649-1595

Phone: (714) 898-0960 • FAX: (714) 896-0971 www.rhombus-ind.com • email: sales@rhombus-ind.com Rhombus Industries Inc. For other values & Custom Designs, contact factory. Specifications subject to change without notice. AMZ 9901 AMZ & AMY Series Passive 5-Tap DIP/SMD Delay Modules 1. Rise Times are measured from 10% to 90% points. 2. Delay Times measured at 50% point of leading edge. 3. Output (100% Tap) terminated to ground through R L=ZO Low Profile 8-Pin Package for Surface Mount Applications Low Distortion LC Network

5 Equal Delay Taps

Fast Rise Time -- BW 0.35 / tr Standard Impedances: 50 - 75 - 100 - 200 Ω Stable Delay vs. Temperature: 100 ppm/O C Operating Temperature Range -55O C to +125O C AM Y Style Schematic Per table, substitute AMY for AMZ in P/N 100% IN 80% 20% 60% 40% COM COM 100% IN 20% 40% 60% 80% COM COM AM Z Style Schematic Recommended for New Designs Dimensions in Inches (mm) .300 (7.62) .285 (7.24) MAX. .010 (0.25) TYP. .365 (9.27) MAX. .505 (12.83) MAX. .120 MIN. (3.05) MAX. .205 (5.21) .100 (2.54) TYP. .050 (1.27) TYP. .020 (0.51) TYP. .020 (0.51) TYP. J-SMD .330 (8.38) MAX. .020 R (0.51) .285 (7.24) MAX. .285 (7.24) .260 (6.60) MAX. .215 (5.46) .030 (0.76) TYP. .505 (12.83) MAX. .100 (2.54) TYP. .020 (0.51) TYP. .050 (1.27) TYP. To Specify SMD: Add Suffix "J" to P/N G-SMD G-SMD .400 (10.16) .430 (10.92) .285 (7.24) MAX. .030 (0.76) TYP. .010 (0.25) TYP. .008 R (0.20) .505 (12.83) MAX. .205 (5.21) MAX. .015 (0.38) TYP. .020 (0.51) TYP. .050 (1.27) TYP. .100 (2.54) TYP. To Specify SMD: Add Suffix "G" to P/N J-SMD Delay Tolerances 50 Ohm Part Number Rise Time (ns) DCR max. (Ohms)

75 Ohm

(ns) DCR max. (Ohms)

100 Ohm

(ns) DCR max. (Ohms)

200 Ohm

(ns) DCR max. (Ohms) Total (ns) Tap-to-Tap (ns) Electrical Specifications at 25O C 1, 2, 3 Note: For SMD Package add "G" of "J" as below to P/N in Table Operating Specifications - Passive Delay Lines O C, typical