AAV003-10E RHOPOINT | Alldatasheet

Document overview

  • Manufacturer or author: Provided By ALLDATASHEET.COM(FREE DATASHEET DOWNLOAD SITE)
  • PDF pages: 4

Technical content

NVE Corporation • 11409 Valley View Road, Eden Prai rie, MN 55344-3617 • (952) 829-9217 • www.nve.com AAV003-10E Current Sensor Key Features

  • For Low Current Detection
  • On-Chip Current Strap for Precise Operation
  • −80 mA to +80 mA Linear Range
  • Sensitivity up to 2 mV/mA
  • AC or DC Measurement
  • Ultraminiature TDFN Package

Description

The AAV003-10E is a high linearity, extremely low hysteresis GMR current sensor with an on-chip current strap. A GMR bridge sensor element close to the current strap senses the magnetic field created by the current. The GMR sensor element uses a unique, bipolar output, low hysteresis GMR material for excellent accuracy. The four terminals of the bridge sensor are available externally. The output terminals of the bridge provide a bipolar voltage signal proportional to the current through the strap. (Pin 1) Out+ Out- AAV003-10E GMR Bridge AAV003-10E Functional Diagram

NVE Corporation • 11409 Valley View Road, Eden Prai rie, MN 55344-3617 • (952) 829-9217 • www.nve.com Operation A representative transfer curve is shown below: AAV003-10E Bridge Output vs Input C urrent 5V S upply Voltage, 25C ‐0.175 -0.15 -0.125 -0.1 -0.075 -0.05 -0.025 0.025 0.05 0.075 0.1 0.125 0.15 0.175 Input C urrent (A) Br i dge Out put ( V) Operating Specifications: Parameter Test Conditions Min. Typ. Max. Units Nominal Bridge Resistance 25°C 5500 7000 8500 Ohms Sensitivity Operating; 5 V Supply, 25°C 0.06 0.08 0.10 mV/V-mA Frequency Response 100 KHz Linear Range of Current Measurement Operating; Full Voltage and Temperature Range −80 80 mA Output Linearity Over Linear Current Range; Full Oper. Temperature Range 99% Bridge Electrical Offset 25°C −4 +4 mV/V Offset Drift over Full Temperature Range Zero Current −1.0 1.0 mV/V Bridge Supply Voltage 24 |Volts| Isolation Voltage See Note 1 240 VRMS On-Chip Current Strap Resistance 25°C 0.25 0.35 Ohms On-Chip Current Strap Resistance Temperature Coefficient +0.6 %/°C Temperature Range of Operation Operating −40 85 °C Bridge Resistance Temperature Coeff. Operating +0.1 %/°C Bridge TCOV2 Operating −0.21 %/°C Notes: 1. For isolation measurement, the sensor is considered a two terminal device: I+ and I- pins (pins 3 and 4) are shorted, and bridge pins (pins 1, 2, 5, and 6) are shorted. 2. TCOV is the percent change in output signal over temper ature, with a constant voltage source powering the part. Absolute Maximum Ratings: Parameter Min. Typ. Max. Units Absolute Maximum Current −600 600 mA Bridge Supply Voltage 30 Volts Storage Temperature −40 170 °C Ambient Magnetic Field Unlimited Note: Exceeding Absolute Maximum Ratings may cause permanent damage.

NVE Corporation • 11409 Valley View Road, Eden Prai rie, MN 55344-3617 • (952) 829-9217 • www.nve.com External Magnetic Fields and Hysteresis Effects The AAV003-10E sensor elements are shielded to make them insensitive to external magnetic fields, however, shielding is not 100% effective, so external fields applied to the sensor should be avoided for the most repeatable, accurate operation. When exposed to magnetic fields over 50 Oe (5 mT), the characteristic of the sensor can be disturbed, causing a hysteresis effect that will produce a non-linear response. A magnetic field of 50 Oe is a large field that should not be encountered during normal operation. However, in case the sensor is exposed to such a field, a degauss pulse train can be applied to the sensor to restore the original response. The sensor cannot be permanently damaged by any magnetic field, no matter how large and it can always be restored after exposure to a large field with a degauss signal. This same effect can be observed when a large constant current (>200 mA) is applied to the on-chip current strap, or a smaller constant current (>100 mA) at high temperatures (>85°C). Again in these cases, correct operation of the sensor is restored with a degauss signal. The degauss signal should consist of at least four current pulses of alternating polarity, with a pulse width of at least 50 µs and an initial current pulse of 600 mA: Typical Degauss Pulse -600 -450 -300 -150 150 300 450 600 750 900 Time (μs) Current (mA) Minimum Duration at Peak 50 μs 100 200 300 400 500 Temperature Characteristics Typical output over temperature is shown in the graph below: AAV003-10E Output over Temperature - Typical -0.200 -0.150 -0.100 -0.050 0.000 0.050 0.100 0.150 0.200 On-C hip S trap C urrent (A) Out put Signal (V) -50 -20 25 C 85 C 125 C

NVE Corporation • 11409 Valley View Road, Eden Prai rie, MN 55344-3617 • (952) 829-9217 • www.nve.com Pinout The AAV003-10E pinout is as follows: Pin Terminal Description

1 V + Supply Voltage

2 Out + Positive Differential Bridge Output

3 I + Current Terminal 1

4 I − Current Terminal 2

5 Out − Negative Differential Bridge Output

6 V − Ground

Notes: 1. Pins are numbered counterclockwise around the package. 2. Current entering the chip via terminal I + and leaving the chip via terminal I− produces a positive bridge output. Notes:

  • Dimensions in mm.
  • TDFN6 package has thermal power dissipation of 320°C/Watt in free air.
  • Attaching the package to a circuit board improves thermal performance, especially if the center pad is also soldered to the board.
  • The center pad may be left floating or connected to ground. SB-00-022; Jan. 26, 2009