A-5461BS TOPLITE | Alldatasheet
Document overview
- Manufacturer or author: Provided By alldatasheet.com(free datasheet download site)
- PDF pages: 5
Technical content
Features
Ordering Information
TOP -35 ~ 85 ºC TSTG -35 ~ 85 ºC IF 30 mA per seg IPF 120 mA per seg VR 5 V per seg P 80 mW per seg *1 at 1/10 Duty Cycle Symbol Value Unit (Typ.) λP 635 nm (Typ.) λD -n m (Typ.) Δλ 20 nm (Typ.) 2θ1/2 - degree (Min.) VF 1.8 V (Typ.) VF 2.1 V (Max.) VF 2.4 V (Max.) IR 20 µA (Typ.) ηOPT - lm/W Min. Typ. Max. 13500 15524 17549 17550 21937 26325 26326 32907 39489 URL: www.topliteusa.com Email: sales@toplightusa.com R S T Operating temperature Parameter Bin Code (TA = 25 ºC & IF = 10 mA) Luminous Intensity Iv (µcd) Maximum Ratings Electrical / Optical Characteristics (1) (TA = 25 ºC) Luminous Intensity Bin Groups Storage temperature Forward current (TA=25 ºC) Peak forward current (TA=25 ºC) *1 Reverse voltage (TA=25 ºC) Power consumption (TA=25 ºC) TOPLITE Parameter Wavelength at peak emission Dominant wavelength IF = 20mA Spectral bandwidth at 50% IF = 20mA Viewing angle at 50% IF = 20mA Reverse current VR = 5V Optical efficiency IF = 20mA Forward voltage IF = 20mA TOP L I T E
Electrical/Optical Charateristic (2) URL: www.topliteusa.com Email: sales@toplightusa.com TOPLITE TOP L I T E
Package Outline Dimensions TOP LIGHT A-5461BS -S- 09C3 Notes: 1. All dimensions are in millimeters. Tolerance is +/-0.25 unless otherwise noted. 2. The specifications, characteristics and technical data described in the datasheet are subject to change without prior notice. URL: www.topliteusa.com Email: sales@toplightusa.com TOPLITE TOP L I T E
Display Soldering Conditions The recommended conditions for soldering are as follows Because the component is made with epoxy resin the 1 . Manual Soldering Conditions(with 1.5mm Iron tip ) Iron Tip Temperature: 350°C Max, Time: 3s Max The recommended conditions for soldering are as follows. Because the component is made with epoxy resin, the units are susceptible to heat. Therefore, the preheating and soldering temperatures should be kept as low as possible to avoid damage. Position: The iron should be situated at least 2mm away from the root of the leads. 2 . Through the Wave Soldering Conditions Wave Soldering Profile For Lead-free Through-hole LED 3 . Soldering General Notes: b. Maintain the pre-heat and peak temperatures with dip units as low as possible and the times as short as is feasible, since the products are susceptible to heat during flow soldering. a. Toplight recommend manual soldering to be used only for repair and rework purposes. The soldering iron should not exceed 30W in power. The tip of the soldering iron should not touch the reflector case to avoid heat-damage. operations. subjected to intense heat, please check with Toplight for compatibility. pp g g c. After soldering, allow at least three minutes for the component to cool to room temperature before further d. If components will undergo multiple soldering processes, or other processes where the components may be URL: www.topliteusa.com Email: sales@toplightusa.com TOPLITE TOP L I T E