VN06-E overview
VN06-E is a component documented by STMicroelectronics. The PDF description identifies it as "ISO high side smart power solid state relay 06-Nov-2008." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: STMicroelectronics
- Part number: VN06-E
- Category: IC
- Datasheet length: 17 Pages
Key features noted in the PDF
- The nominal current is the current at Tc = 85°C for battery voltage of 13V which produces a voltage drop of 0.5V.
- The VIH is internally clamped at 6V about. It is possible to connect this pin to an higher voltage via an external resistor
- I OL(off) = (VCC -VOL)/ROL.
- t 1(on): minimum open load duration which acctivates the status output
- t 1(off): minimum load recovery time which desactivates the status output
- t 2(off): minimum on time after thermal shut down which desactivates status output
- t povl tpol: ISO definition (see figure)
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- Fast demagnetization of inductive loads is archieved by negative (-18V) load voltage at turn-off.
- The maximum continuous output current is the current at Tc = 85 °C for a battery voltage of 13V which does not activate self protection.
- Power The nominal current is the current at Tc = 85°C for battery voltage of 13V which produces a voltage drop of 0.5V. Table 5.
- Logic inputs** The VIH is internally clamped at 6V about.
- It is possible to connect this pin to an higher voltage via an external resistor calculated to not exceed 10 mA at the input pin. **Table 7.
- The open load diagnostic output has a 5 ms filtering.
- The filter gives a continuous signal for the fault condition after an initial delay of about 5 ms.
Topics covered by the datasheet
The document includes sections related to:
- Datasheet sections
- Features
- Description
Engineering review checklist
- Confirm the exact ordering code, package, pinout or terminal arrangement and document revision.
- Compare recommended operating conditions with absolute maximum ratings and retain adequate design margin.
- Validate electrical, thermal, mechanical and environmental behavior in the final application.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the VN06-E datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=vn06-e-stmicroelectronics