TMCM-1140-CABLE overview
TMCM-1140-CABLE is a component documented by TRINAMIC Motion Control. The PDF description identifies it as "MODULE FOR STEPPER MOTORS." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: TRINAMIC Motion Control...
- Part number: TMCM-1140-CABLE
- Category: IC
- Datasheet length: 26 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- The module can be mounted on the back of NEMA 17 (42 mm flange size) stepper motors and has been designed for coil currents up to 2 A RMS and 24 V DC supply voltage.
- Electrical and mechanical data Supply voltage: +24 V DC nominal (9… 28 V DC) Motor current: up to 2 A RMS / 2.8 A peak (programmable) Refer to separate TMCL Firmware Manual, too.
- Maximum component height (height above PCB level) without mating connectors is around 8 mm above PCB level and 2 mm below PCB level.
- USB Motor Multi-purpose I/O Power and Communication Figure 3.2 Overview connectors Label Connector type Mating connector type Power and Communication Connector CI0106P1VK0-LF CVIlux CI01 series, 6 pins, 2mm pitch Connector housing CVIlux.
- Due to space restrictions the TMCM -1140 includes about 40µF/35V of supply filter capacitors.
- The module includes a 28V suppressor diode for over-voltage protection.
- at least 470µF/35V) to the power supply lines next to the TMCM-1140!
Engineering review checklist
- Check voltage, continuous and pulsed current, safe operating area and junction-temperature limits.
- Evaluate conduction and switching losses using the specified drive conditions rather than headline ratings.
- Confirm pinout, package thermal path, gate or base protection and transient derating in the final circuit.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the TMCM-1140-CABLE datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=tmcm-1140-cable-trinamic-motion-control