SA24 overview
SA24 is a component documented by Taiwan Semiconductor Co. The PDF description identifies it as "500 Watts Transient Voltage Suppressor." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Taiwan Semiconductor Co...
- Part number: SA24
- Category: IC
- Datasheet length: 5 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- Features om ~ Plastic package has Underwriters Laboratory Lay may Flammability Classification 94V-0 wee ~ 500W surge capability at 10 X 1000us waveform i ~ Excellent clamping capability eel “a ~ Low Dynamic impedance oA ~ Fast response tim.
- A above 10V ~ High temperature soldering guaranteed: Dimensions in inches and (millimeters) 260°C / 10 seconds / .375",(9.5mm) lead length Marking Diagram 1 5ibs.,(2.3kg) tension ~ Green compound with suffix “G” on packing code & prefix “G.
- Type Number Symbol | Value [Units Peak Power Dissipation atTx=25°C, Tp=ims (Note 1) | Pre | __Minimums00_ [| Watts [Steady State Power Dissipation at T.=75°C.
- Lead Lengths .375", 9.5mm (Note 2) | om | $0 watts Peak Forward Surge Current, 8.3 ms Single Half |Sine-wave Superimposed on Rated Load Irs 70 Amps (JEDEC method) (Note 3) [Unidirectional Only [Operating and Storage Temperature Range -55 t.
- Mounted on Copper Pad Area of 0.4 x 0.4” (10 x 10 mm) Per Fig.
- 2 3, 8.3ms Single Half Sine-wave or Equivalent Square Wave, Duty Cycle=4 Pulses Per Minutes Maximum.
- Lease TI NUS 3 — or LOTT LE LIMIT TTT Version: F10 ELECTRICAL CHARACTERISTICS (Ta=25°C unless otherwise noted) Maximum Maximum Breakdown Test Stand-off | Reverse Clamping | , Maximum oneal Vottage caren | ‘otege’ | Coatope Yanege, | Temper.
Engineering review checklist
- Check voltage, continuous and pulsed current, safe operating area and junction-temperature limits.
- Evaluate conduction and switching losses using the specified drive conditions rather than headline ratings.
- Confirm pinout, package thermal path, gate or base protection and transient derating in the final circuit.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the SA24 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=sa24-taiwan-semiconductor-co