PQ200 overview
PQ200 is a component documented by Pico Technology Ltd. The PDF description identifies it as "Smarter scopes for faster debug." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Pico Technology Ltd.
- Part number: PQ200
- Category: IC
- Datasheet length: 39 Pages
Key features noted in the PDF
- Up to 1.3 GHz probe bandwidth
- Click-to-fit convenience
- Super light flexible cable
- Control capture start and stop using a button on the probe
- Connects directly to PicoScope 6000E Series oscilloscopes with the Intelligent Probe Interface
- Powered by the oscilloscope, eliminating separate power supplies and interface boxes
- Automatic probe detection and unit scaling
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- Best-in-class bandwidth, sampling rate and memory depth Capture time in PicoScope 6 at maximum sampling rate: 200 ms at 5 GS/s With up to 1 GHz analog bandwidth complemented by a real-time sampling rate of can display single-shot pulses wi.
- This ultra-deep memory allows the oscilloscope to capture 200 ms waveforms at its maximum sampling rate of 5 GS/s.
- Custom applications using PicoSDK can allocate the scope’s whole memory to a single waveform and sustain the maximum 5 GS/s sampling rate for even longer captures, up to an incredible 800 ms.
- Coupled with high signal-to-noise ratio amplifiers and a low- noise system architecture, FlexRes technology can capture and display signals up to 1 GHz with a high sampling rate, or lower- speed signals with 16 times more resolution than t.
- Digital channel bandwidth is 500 MHz, equivalent to 1 Gb/s, and the input capacitance of only 3.5 pF minimizes loading on the device under test.
- Aux Trig – trigger from an external logic-level source and integrate the scope into a larger system Ground – accepts bare wire or 4 mm (banana) plug.
- Includes frequency sweep mode.
Topics covered by the datasheet
The document includes sections related to:
- Features
Engineering review checklist
- Confirm supply rails, clock limits, memory size, peripheral mapping and I/O voltage compatibility.
- Check package pinout, boot configuration, programming interface and silicon-revision errata.
- Budget decoupling, thermal margin, startup timing and firmware recovery behavior before release.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the PQ200 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=pq200-pico-technology-ltd