OP16GN8 overview
OP16GN8 is a component documented by List of Unclassifed Man. The PDF description identifies it as "Add device type 04 for device class V and radiation hardened requirements." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: List of Unclassifed Man...
- Part number: OP16GN8
- Category: IC
- Datasheet length: 14 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- FRYE MICROCIRCUIT, LINEAR, JFET-INPUT, OPERATIONAL AMPLIFIER, MONOLITHIC SILICON DRAWING APPROVAL DATE 89-10-25 AMSC N/A REVISION LEVEL C SIZE A CAGE CODE 67268 5962-89543 SHEET 1 OF 12 DSCC FORM 2233 APR 97 5962-E483-12 A 5962-89543 DLA L.
- 1/ Supply voltage range (VS): Devices 01, 02, and 04: Device 03: Differential input voltage: Input voltage: Thermal resistance, junction-to-ambient (θJA): 1.4 Recommended operating conditions.
- 1/ Stresses above the absolute maximum rating may cause permanent damage to the device.
- 2/ Derate linearly 6.7 mW/°C above TA = +75°C for P package; Derate linearly 7.1 mW/°C above TA = +80°C for G package.
- Unless otherwise specified herein, the electrical performance characteristics and postirradiation parameter limits are as specified in table I and shall apply over the full ambient operating temperature range.
- When performing post irradiation electrical measurements for any RHA level, TA = +25°C.
- The test circuit shall specify the inputs, outputs, biases, and power dissipation, as applicable, in accordance with the intent specified in method 1015. (2) TA = +125°C, minimum.
Topics covered by the datasheet
The document includes sections related to:
- DATASHEET SEARCH SITE
Engineering review checklist
- Verify supply range, input common-mode range and output swing at the required load.
- Check offset, bias current, noise, bandwidth, slew rate and stability for the intended feedback network.
- Review supply decoupling, source impedance, capacitive-load behavior and thermal limits in the final layout.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the OP16GN8 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=op16gn8-list-of-unclassifed-man