ME30A1503B01 overview
ME30A1503B01 is a component documented by SL Power Electronics. The PDF description identifies it as "20 to 30W Single Output External Power." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: SL Power Electronics
- Part number: ME30A1503B01
- Category: IC
- Datasheet length: 4 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- The ME30A Series models will operate at universal input range of 90 to 264Vac over the wide temperature range of -20°C to +50°C, delivering full rated output power up to +40°C and applicable output power derating at 50 °C.
- Model Selection Model Output Output Ripple & Line Load Overvoltage Output Input Number Volts Current Power Noise¹ Regulation Regulation Trip Range Connector Configuration ME30A0503F01 5.0V 4.00A 20W 75mV pk-pk ±1% ±5% 5.75V-7.75V 2.5 x 5.5.
- Measured at the output connector, with noise probe directly across output and load terminated with 0.1μF ceramic and 10μF low ESR capacitors.
- For 5V and 6V models, values listed are typical, 100mV pk-pk maximum with 0.1μF ceramic and 47μF low ESR capacitors used at measurement point.
- All specifications are typical at nominal input, full load, at 25 °C ambient unless noted.
- General Specifications AC Input 100-240Vac, ±10%, 47-63Hz, 1∅ Turn On Time Less than 700mS @115Vac, full load Input Current 115Vac: 1.2A, 230Vac:0.6A Hold-up Time 20mS min., at full Load, 100Vac input Inrush Current 264Vac, cold start: wil.
- Input Fuses F1, F2: 2.0A, 250Vac fuses (line & neutral lines) provided on all models Overload Protection 130 to 180% of rating, Hiccup Mode Earth Leakage Current Input-GND: <500μA@264Vac, 60Hz, NC Output-GND: <4mA@264Vac, 60Hz, NC Short Ci.
Topics covered by the datasheet
The document includes sections related to:
- DATASHEET SEARCH SITE
- Features
- Description
Engineering review checklist
- Verify contact current, voltage, contact resistance, insulation and mating-cycle ratings.
- Check the exact keying, pitch, orientation, mating part and mechanical drawing before footprint approval.
- Review assembly force, retention, cable strain relief and environmental exposure for the application.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the ME30A1503B01 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=me30a1503b01-sl-power-electronics