K30ALBT2GHT overview
K30ALBT2GHT is a component documented by Banner Engineering Corp. The PDF description identifies it as "EZ-LIGHT® Touch Gen 2 K30 Series Illuminated Buttons Rev. F 30 April 2021." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Banner Engineering Corp...
- Part number: K30ALBT2GHT
- Category: IC
- Datasheet length: 4 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- W = White X = Not Used G RL H Color 1 Not Activated Color 2 Activated Output Function Function A = Normally Open A Blank = 2 m Integral Cable Q = Integral 5-pin M12 Quick Disconnect (QD) * QP = 150 mm (5.9 in) cable with 5-pin M12 Quick Di.
- Wiring Diagrams Load Load 12-30V dc Not Used Color Key 1 = Brown 2 = White 3 = Blue 4 = Black 5 = Gray Note: Cabled wiring diagrams are shown.
- F 55 mA max current (exclusive of load) Supply Protection Circuitry Protected against reverse polarity and transient voltages Touch Dwell Time (momentary models only) If a touch dwells for longer than 60 seconds, the output and indicator c.
- Output Response Time 150 milliseconds ON and OFF Output Rating Maximum Load: 150 mA ON-state saturation voltage: < 2 V DC at 10 mA; < 2.5 V DC at 150 mA OFF-state leakage current: < 10 µA at 30 V DC Power-Up Delay 300 milliseconds Latching.
- Operating Conditions 90% at +50 °C maximum relative humidity (non-condensing) Storage Vibration and Mechanical Shock Vibration: 10 Hz to 55 Hz, 1.0 mm peak-to-peak amplitude per IEC 60068-2-6 Shock: 30G 11 ms duration, half sine wave per I.
- stainless steel Mounting hole for 22 mm sensor A B C Hole center spacing: A to B = 26.0 Hole size: A = ø 4.6, B = 4.6 x 16.9, C = 22.2 SMB22FVK V-clamp, flat bracket and fasteners for mounting to pipe or extensions Clamp accommodates 28 mm.
- square extrusions 22 mm hole for mounting sensor 46 1 18 A ø22.5 Hole size: A = ø 22.5 EZ-LIGHT® Touch Gen 2 K30 Series Illuminated Buttons P/N 189826 Rev.
Topics covered by the datasheet
The document includes sections related to:
- K30_V12 BANNER
Engineering review checklist
- Check voltage, continuous and pulsed current, safe operating area and junction-temperature limits.
- Evaluate conduction and switching losses using the specified drive conditions rather than headline ratings.
- Confirm pinout, package thermal path, gate or base protection and transient derating in the final circuit.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the K30ALBT2GHT datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=k30albt2ght-banner-engineering-corp