IAM1.52PM600 overview
IAM1.52PM600 is a component documented by Banner Engineering Corp. The PDF description identifies it as "Fiber Optic Systems." This guide condenses the most useful engineering information from the available PDF so that designers and sourcing teams can identify the checks that still need confirmation in the original document.
Datasheet snapshot
- Manufacturer: Banner Engineering Corp...
- Part number: IAM1.52PM600
- Category: IC
- Datasheet length: 42 Pages
Specifications and operating details
The following points were extracted from the PDF text. Check the associated conditions, notes and limits in the complete document before using a value in a design.
- 466- 467)D10BFPGQ 6-pin Pico QD D10—Discrete, 10-30V dc Models Sensing Mode/LED* Range Cable** Output Type Data Sheet D10AFP PLASTIC FIBER Range varies by Power Level/Speed Selection used and with fiber optics used.
- ripple) at less than 65 mA, exclusive of load Supply Protection Circuitry Protected against reverse polarity and transient voltage.
- load OFF-state leakage current: less than 10 µA at 24V dc ON-state saturation voltage: NPN less than 1.5V at 150 mA load PNP less than 2.5V at 150 mA load Output Protection Circuitry Protected against false pulse on power-up and continuous.
- Operating Conditions Temperature: -20° to +55° C Storage Temperature: -20° to +80° C Relative humidity: 90% @ 50° C Number of Devices Stacked Ambient Temperature Rating Load Specification 3 55° C 150 mA 7 50° C 50 mA 10 45° C 50 mA Install.
- 481) D10 Expert™ with Numeric Display—Analog/Discrete Specifications Required Fiber Optic Cable Banner P-Series plastic fibers (See Plastic Fiber Optic section, page 182) Supply Voltage and Current 4-20 mA Analog Models: 12-24V dc (10% max.
- ripple) at less than 65 mA exclusive of load 0-10V dc Analog Models: 15-24V dc (10% max.
- ripple) at less than 70 mA exclusive of load Supply Protection Circuitry Protected against reverse polarity and transient voltage.
Topics covered by the datasheet
The document includes sections related to:
- D10_V05 BANNER
Engineering review checklist
- Verify supply range, input common-mode range and output swing at the required load.
- Check offset, bias current, noise, bandwidth, slew rate and stability for the intended feedback network.
- Review supply decoupling, source impedance, capacitive-load behavior and thermal limits in the final layout.
Always confirm values against the latest manufacturer-controlled datasheet, especially when qualifying a substitute or releasing a production BOM.
View the complete PDF and model record
Open the IAM1.52PM600 datasheet and model details to review the complete PDF, document pages and available product information.
Source attribution
Adapted from the PDF associated with this DigiCamel model page.
Source model URL: https://www.digicamel.com/product.php?slug=iam1-52pm600-banner-engineering-corp